www.invisiblefence.com
4
Step 4: Determine the length of wire needed to pass from the Surge Protector to the
Fence Transmitter. Measure and cut 2 lengths of wire, then strip approximately 3/8-inch
of insulation at both ends. Twist the 2 lengths together, with at least 10-12 twists per foot,
so these wires will not send out a signal.
Step 5: Insert the ends of the transmitter wires into the right 2 black connectors at the
bottom of the Surge Protector labeled “Transmitter”.
Note: There should be 1 wire in each connector hole.
Step 6: Insert the opposite stripped ends of the two transmitter wires (from Step 5) into
the connectors on the Fence Transmitter.
CAUTION: Verify the boundary and transmitter wires are connected to the
proper Surge Protector terminals. Damage to both the Surge Protector and your
Fence Transmitter can occur if connections are reversed.
Step 7: Plug in the Fence Transmitter power adapter to the AC outlet on the front of the
Surge Protector. If you have added the Surge Protector to an existing pet containment
system, check the Boundary Width for width and continuity. Adjust as necessary. If the
Surge Protector is being installed with a new pet containment system, follow the
Boundary Width adjustment procedures given in the system’s operating guide. For added
protection for the Surge Protector and Fence Transmitter when unused for long periods of
time, disconnect Loop Boundary Wires and unplug power adapter from the Surge
Protector.
LP Supplemental:
In 2004 Invisible Fence Brand designed a new transient voltage surge suppressor
(TVSS). If your system was installed prior to July of 2004, you may have an older style
lightning protection device. Please follow the instructions below when upgrading to the
LP4100 or LP4200 lightning protection device.
ICT50, ICT75, ICT100, ICT150 and ICT700
1. Remove and discard the green ground wire connecting the LP3000 to the
electrical outlet. (See figure 1)
2. Remove and discard the LP3000 lightning protection device.
3. Refer to steps 2 – 6 of the LP-4100 / LP-4200 manual to complete installation.
Figure 1
Wire
