Italian Technology of Broadcast
User's Manual
ARCHIMEDE 3000 AR
432
Page 5of 40
General Safety Rules
The device must be used in accordance with the instructions for use.
Electrical installations in the room must correspond to the requirements of safety regulations.
Take care that there are no cables, especially mains cables, in areas where people could move or work.
Do not use a mains connection in sockets shared by other power consumers. Do not use an extension
cable.
Only use the mains cable supplied. In the case it is not long enough, only use a cable with the same
characteristics as the one provided to assemble a longer one.
The unit is completely disconnected from the power source only when the power cord is removed from
power source. Therefore the power cord and its connectors must always remain easily accessible.
Do not set up the device in the proximity of heat sources or in a damp location.
Make sure that the device has adequate ventilation.
The Amplifier should not be used near water and objects filled with liquids should not be placed on the
appliance.
The Amplifier should be situated so that its location or position does not interfere with its proper
ventilation. For example, the device should not be placed in a built-in installation, such as a bookcase or
cabinet that may stop the flow of air through the ventilation openings.
All plugs on the connection cables must be screwed or locked to the chassis housing.
The device is designed to be used in horizontal position only.
The device is no longer safe to operate when has visible damage or it hasn’t been working for long time.
In case of technical problems or a few elements of doubt, Italab will help you with the support of
qualified technical personnel.
In case of system failure or visible damage, the device must be shut down.
Repairs may only be carried out by a person authorized by ITALAB.
The ARCHIMEDE 3000 must be switched off and the power cord disconnected from the AC source when
removing the top cover.
Climatic Conditions
In order to have the best performance in term of power, life span, etc, the following parameters must be
respected:
the room temperature should be in a range of 25° C and 30°C .
The humidity shall be less than 70% and non-condensing.
The Equipment will work beyond the parameters specified, but Italab will not guarantee the continuous service
and, in any case, with temperatures higher than 50°inside the Equipment, the standby procedure will
automatically start. The room must have a good ventilation to ensure that the inside temperature never
exceeds the limit of 40 °C. If the Equipment is included in a rack, the rear of this should not be closed. If it is
necessary to close the rear of the device, a forced ventilation and air extraction must be provided.
