Receiver
1. Connect the DC POWER ADAPTER to the receiver’s DC INPUT
then plug the other end of DC POWER ADAPTER into the WALL
OUTLET
2. Connect one end of ¼ “ to ¼ “ cable to receiver’s UN ALANCE
AUDIO OUTPUT (MIX) and the other end to a mixer. If you are
using the ALANCE AUDIO OUTPUT, use a XLR to XLR cable or
XLR to ¼ “ cable
3. Install the antenna into each antenna socket on rear panel, then
fasten the antenna towards the right side till the antenna is
vertical with ground
4. Push/Open the microphones handle/bodypack cover to check
to see if there are batteries. If not, install the batteries into the
microphones with the negative and positive end of the battery
correspond the negative and positive end of the microphone.
Push/Close the microphone handle/bodypack back on
Parameter
Receiver
