iWave FMS-8480 Manuale utente
www.iwavecomms.com
1
FMS-8480 User Manual
December 2019
Version 2.0
Content
1.Package List ........................................................................................................................................ 2
2.Interface ............................................................................................................................................. 3
3.Installation Setps ................................................................................................................................5
4.Play Video on Windows PC by TPlayer ...............................................................................................6
5. Steps of Network Configurations ...................................................................................................... 7
6.Notice .................................................................................................................................................7
www.iwavecomms.com
2
1.Package List
Transmitter*1
Receiver*1
Transmitter Antennas*2(5db/35cm length)
Receiver Antenna*2(14db/90°directional ant)
Antenna Cable*4
HDMI Cable*2
BNC-SMA*2
Power Cable*4
www.iwavecomms.com
3
Ethernet Cable*4
TTL Serial Data Cable*2
TTL-USB Cable*2
2.Interface
Interface on Tx and Rx are same
(Tx)
(Rx)
www.iwavecomms.com
4
Note: Camera logo for TX unit. Monitor logo for RX unit
TX Unit automatic identifies video type. If SDI video input, Tx unit will encode and transmit SDI
video. If HDMI video input, it will encode and transmit HDMI video.
Note: If Both are connected and active, it will encode and transmit SDI video
RX Unit outputs both SDI and HDMI video simultaneously. Two monitors can be connected.
The SDI and HDMI monitor will display the video at same time.
The voltage input voltage is 7~18V
Power LED will be bright when power on
WAN LED will be flashing when the video is transmitting/receiving
Wireless status LEDs. LED1 will be bright when the wireless communication link between Tx
and Rx has been established successfully.
LED2 and LED3 are reserved for production testing
SMA is to connect antenna
Note: Both the antennas should be in good connection before power on
MicroUSB: Reserved for production testing
www.iwavecomms.com
5
Serial connector: Connect the TTL-serial cable to transmit serial signal, voltage is 3.3V.
SMA connector: Connect antenna.
Note: Both the antennas should be in good connection before power on
LAN Connectors
LAN LED
--Bright: The LAN connector is connected successfully to external device via a LAN cable
--Flashing: Data is transmitting via the LAN connector
¼”-20 screw hole for installing/mounting the unit on UAV.
3.Installation Setps
1. Connect both Antennas on Tx and Rx
2. Connect Tx with SDI or HDMI Camera
3. Conenct Rx with a monitor
4. Power on all the devices
5. After 10-20s, LED1 will be bright, which means the wireless link between Tx and Rx has been
established successfully
6. After a few senconds the monitor will display the camera’s video
7. When use the serial port, please refer the following information of the the voltage and data
format
(note: Wire color is irrelevant)
www.iwavecomms.com
6
Pin number
Signal
1
TXD
2
RXD
3
3.3V output, max 500mA (to power external device if necessary)
4
GND
5
Reserved
Another header consists of 3 Dupont plugs with different color wire:
Serial Data Format
4.Play Video on Windows PC by TPlayer
Install TPlayer on a Windows PC (Windows 7 or Windows 10)
Connect the Windows PC to LAN1 or LAN2 port of receiver unit by one Ethernet Cable
When HDMI video/SDI Video is playing successfully on the monitor, run the TPlayer then select
the adapter connecting and click “Play” button
Color
Signal
Red
TXD
Yellow
RXD
Black
GND
Default Baud Rate
115200
Data Bits
8
Parity
No
Stop bit
1
Voltage
3.3V
www.iwavecomms.com
7
A video playback window will pop out and begin to play the video
5. Steps of Network Configurations
FMS-8480 units are working as wireless bridge. Tx and Rx are in the same IP subnet 192.168.1
netmask is 255.255.255.0
IP Address of FMS-8480 as follows:
Tx
Rx
192.168.1.1
192.168.1.2
All external devices/PC connecting to LAN ports of FMS-8480 should be in the same IP subnet
192.168.1 with netmask 255.255.255.0
Steps of Network Configuration
1. Connect both Antennas on Tx and Rx
2. Configure the IP/gateway/mask of devices connected with Tx and Rx units
3. Connect network devices to LAN ports of Tx/Rx unit
4. Power on all the devices
5. After 10~20 seconds, LED1 will be bright, which means the wireless link between Tx and Rx has
been established successfully
Note: FMS-8480 supports HDMI/SDI video transmitting and network communication
simultaneously. While when HDMI/SDI video is transmitting over wireless channel, there is only
100kbps throughput left in the channel for LAN1+LAN2.
6.Notice
Before powering on, make sure both SMA has connected to antennas. Powering on a unit
without antenna as load, the PAs inside will be damaged
Two antennas of one unit should keep certain distance. We commend 1 meter for Tx side, 2
meters for Rx side. If two antennas don’t keep proper distance, the wireless signal may
become weaker and the communication distance will be short.
Indice
Altri manuali iWave Hardware per computer
iWave
iWave FIM-1440 Manuale utente
iWave
iWave iW-RainboW-G30D Manuale utente
iWave
iWave iW-RainboW-G40M Manuale di installazione
iWave
iWave FIM-2450 Manuale utente
iWave
iWave iW-RainboW-G25S Manuale utente
iWave
iWave FPM-8416 Manuale utente
iWave
iWave FIM-2410 Manuale utente
iWave
iWave iW-RainboW-G47D Manuale utente
iWave
iWave iW-RainboW-G17D Manuale utente
iWave
iWave iW-RainboW-G57M Manuale di installazione
iWave
iWave FIP-2410 Manuale utente
iWave
iWave FNS-8408 Manuale utente
iWave
iWave FDM-6600 Manuale utente
iWave
iWave iW-RainboW-G37M Manuale di installazione
iWave
iWave FNM-8416 Manuale utente
iWave
iWave FIM-2430 Manuale utente
iWave
iWave FDM-615PTM Manuale utente
iWave
iWave FIM-2405 Manuale utente
iWave
iWave FPS-8408 Manuale utente
iWave
iWave i.MX 8M Mini Manuale utente
Manuali Hardware per computer popolari di altre marche
EMC2
EMC2 VNX Series Manuale del proprietario
Panasonic
Panasonic DV0PM20105 Manuale utente
Mitsubishi Electric
Mitsubishi Electric Q81BD-J61BT11 Manuale utente
Gigabyte
Gigabyte B660M DS3H AX DDR4 Manuale utente
Raidon
Raidon iT2300 Manuale utente
National Instruments
National Instruments PXI-8186 Manuale utente
