JADE TEAM EDGE540 Manuale utente
1. Check if the aircraft parts and accessories in the box are complete
Check whether the carbon rods, carbon chips, and accessories are complete.
If the accessories are missing, please contact the manufacturer in time.
Specication:
0.5X4mm carbon chip 1 piece
0.2X3mm carbon sheets 6 pcs
1.0mm carbon rods 6 pcs
2.0X220mm carbon rods 2 pcs
Foam glue 1 pcs
2. Use heavy objects to press each rudder surface for 1-2 hours
3. Glue the horizontal plane of the fuselage and the at tail, prepare a ruler and a marker,
use the ruler to align the tenon in the middle of the fuselage
and mark the left and right sides with a marker.
After the false group is correct, the bonding part is double-sided glued for bonding
After the bonding is completed, use a utility knife to cut along the slot of the
cut carbon sheet again (do not cut through the sheet) to make the carbon sheet
smoothly embedded.
4. Glue the horizontal plane of the fuselage and the left and right wings,
use a marker to mark the dummy assembly of the wing and apply glue on both sides
of the bonding surface after the dummy assembly is correct
5. Take out the 0.5X4mm carbon sheet from the carbon ber package.
The bonding surface of the carbon sheet and the board needs to be glued to the
front carbon sheet of the wing.
6. Install the carbon sheet of the machine head, take out the 0.2X3mm carbon sheet
from the package, cut the carbon sheet to an appropriate length and insert it into
the cut slot to x it with 502 glue. As EPP is permeable, please pay attention to the
amount of 502 glue.
It is recommended to cooperate with JADE The CA glue accelerator
produced by TEAM has better quick-drying eect.
After the carbon sheet is xed, use a ruler and a marker to bond the head and the body
7. Install the horizontal tail wing carbon sheet, use 0.2X3mm carbon sheet,
the installation method is the same as above
8. The main wing is strengthened. Use 0.2X3mm carbon sheet.
The installation method is the same as above.
Note : The use of carbon sheet should follow the principle of rst long and short,
rst strengthen the long carbon sheet and then strengthen the short part.
9. Reinforced on both sides of the fuselage
At this point, the installation and reinforcement of the horizontal fuselage is over.
10. Install the fuselage and the rudder surface carbon sheet,
take out the vertical fuselage and use 0.2X3mm carbon sheet
