W1：Wave Mode
Adjusting the dial will alter the pump on/off period. This will create
a wave in the tank which can be adjusted to suit your needs. Increase
the wave length by turning the dial clockwise, and reduce by turning
the dial anti clockwise.
Tip: You should change the dial gradually and observe the wave
pattern for a while after each adjustment. Press “SPEED/FEED” to
adjust the flow rate.
W2：Sine Mode
One or more pumps can operate at the same time in this mode. The
power various between 15%-100% in a sinusoidal fashion.
Else：Random Mode
One or more pumps can operate at the same time in this mode. The
power of pump is altered randomly.
H：Constant Flow Mode
One or more pumps can operate at the same time in this mode. Flow
rate can be adjusted by “SPEED/FEED” button.
C – Anti Sync mode.
Pump 1 & 2 operate alternately (Anti SYNC). P1 run, P2 stop--P1
stop, P2 run--P1 run -- P2 stop - the cycling is repeated. The flow
rate of P1 & P2 can be adjusted with P1_FLOW & P2_FLOW.
The interval dial will adjust the frequency of the alternating between
P1 & P2.
C：Anti Sync mode
Two pumps are needed to run in anti sync. Pump 1 & 2 operate
alternately (Anti SYNC). P1 run, P2 stop--P1 stop, P2 run--P1 run --
P2 stop - the cycling is repeated. The cycle period can be adjusted
with the dial (1s – 1min). The flow rate of P1 & P2 can be adjusted
rate by pressing SPEED/FEED.
Night Function:
Enter into Night Mode by a long press of MODE/NIGHT button until
yellow “NIGHT” indicator lights. Wavemakers function normally
during day and enter into NIGHT mode automatically when it’s dark
–wavemaker output will be reduced to 30% flow. Exit mode by a long
press of ”MODE/NIGHT” button until the yellow indicator goes out.
FEED Function:
Enter feed mode by a long press of “SPEED/FEED” button until the
blue indicator lights. The pump will stop working and allow fish to
feed for 10 minutes. Pump will revert back to normal mode after that.
Exit mode by a long press of ”FEED/SPEED” button until the 10 min
indicator goes out.
Dial Locking Function: Enter lock mode by a long press of the
Wi-Le/LOCK button until the red LOCK indicator lights. It prevents
the wave pattern and time from being altered – the dial has no effect
when the lock mode is on.
Warnings
The controller must not be subjected to any moisture – please position
the controller away from any area where it can be splashed with water.
If it is splashed, dry immediately with a soft cloth.
Do not disassemble the controller and the power adaptor.
This product is indoor use only.
Appendix: TYPICAL PUMP LOCATIONS
l
