Page 5
Service rules
1. Use genuine Johnny Pag Motorcycles or JPM recommended parts and lubricants or
their equivalents. Parts that don’t meet Johnny Pag Motorcycles design
specifications may damage the motorcycle.
2. Use the special tools designed for this product.
3. Install new gaskets, O-rings, cotter pins, lock plates, etc. When reassembling.
4. When torquing a series of bolts or nuts, begin with larger-diameter or inner bolt
first, and tighten to the specified torque diagonally in 2-3 steps, unless a particular
sequence is specified.
5. Clean parts in non-flammable or high flash point solvent upon disassembly.
Lubricate any sliding surfaces before reassembly.
6. After reassembly, check all parts for proper installation and operation.
7. Use only metric tools when servicing this motorcycle. Metric bolts, nuts, and screws
are not interchangeable with English fasteners. The use of incorrect tools and
fasteners may damage the motorcycle.
WARNING
When riding your Johnny Pag Motorcycle, you must always pay attention to traffic
safety laws.
SAFE RIDING RULES
Before you start your engine, you must always check your motorcycle to prevent
accidents or equipment damage.
PROTECTIVE APPAREL
A motorcycle rider usually has his/her head injured in an accident. In order to ensure
personal safety, the rider should always wear a helmet, goggles, boots, gloves etc. The
passenger should always wear the same safety gear as the driver.
