Control Center™ 540C settings
It is possible to change individual settings on the Control
Center™ 540C. Settings that can be adjusted include the
following:
CH1 OUT - output configuration
LIGHT – changes backlight
INVERT - display text color invert
BRIGHT - display brightness
SPEAKER - audible bleep
RESTORE - restore factory default settings.
CH NAME - channel input names
To change settings:
1) Ensure the Control Center™ 540C is switched ON.
2) Carefully remove the Control Center™ 540C Faceplate.
3) Using the display navigation buttons (< / >) cycle through
the setting options.
4) At the desired setting, press the green button to access
options. Adjust the settings by using the navigation buttons
(< / >). Confirm and store the desired setting with the green
button or cancel with the red button.
Setting 1: CH1 OUT
The Xbox 360™ console outputs many different AV signals
and the Control Center™ 540C must be adjusted to output
the correct signal for your chosen method of connection to
a TV. The default setting is “YUV” for displaying component
video. Set to “S-V” to output an S-video signal by following
these steps:
Use the display navigation buttons (< / >) to cycle through
the settings to “CH1 OUT”. Press the green button to
access options. Use the display navigation buttons (< / >) to
select either “S-V” or “YUV”. Save the setting by pressing
the green button.
NOTE: If you see no picture on your TV, check CH1 output
is set correctly for your method of connection.
Setting 2: LIGHT
Three different back light settings are available: (OFF always
/ ON always / AUTO)
Follow the above procedure to make required setting
changes.
Setting 3: INVERT
Change the background display color by inverting the dis-
play screen: (light green or black)
Follow the above procedure to make required setting
changes.
Setting 4: BRIGHT
Change the backlight level of the display screen: (two levels
of brightness are available)
Follow the above procedure to make required setting
changes.
Setting 5: SPEAKER
The Control Center™ 540C features an audible bleep for
confirming selection of each Input Channel: (the sound can
be set to either ON and OFF)
Follow the above procedure to make required setting
changes.
Setting 6: RESTORE
Reset all user made settings to the original default
factory settings.
Follow the above procedure to make required setting
changes.
Setting 7: CH NAME
The input number (1) CAN NOT be adjusted.
CH 2 - 6 can be adjusted from the default names if
required. The 8 character name can be adjusted for easy
identification of AV devices connected to the Control
Center™ 540C.
For example should you wish Input 2 to read ‘PS2’,
follow this simple setup procedure:
1) Ensure the Control Center™ 540C is switched ON.
2) Carefully remove the Control Center™ 540C Faceplate.
3) Use the Remote Control to select the input channel you
want to rename.
4) Use the display navigation buttons (< / >) to cycle
through the settings to “CH NAME”. Press the green button
to begin changing the channel name.
5) The cursor on the display screen will flash under the first
letter on the left “C”. Use the display navigation buttons (< /
>) to cycle through the letters until the letter you want is dis-
played. Press the green button to confirm the selection and
move the next letter to change.
6) To save the new Input Channel name, push and hold
down the green button for 3 seconds.
6 ENGLISH
