Low/High Range Shift Lever –
Located on right side of machine base. Pull toward the front of the machine to shift into the
low speed range. Push toward the rear of the machine to shift into the high-speed range.
Caution: Do not change the speed range while the machine is running. Adjust only when
the machine is stopped NOTE: If the lever will not mesh the speed range, slightly rotate the
band wheel and the lever will go into gear.
Variable Speed Hand Wheel –
Located below the worktable on right side of machine base. Turn clockwise to increase
speed and counter-clockwise to decrease speed.
Caution: Do not turn handle while machine is stopped. Adjust speed only when machine is
running. RPMs will be displayed on the control panels digital readout.
Upper Guide Post Lock Knob –
Located on right side of upper frame. Turn counter-clockwise to loosen and clockwise to
tighten. Always support the guide post when adjusting this knob to prevent unexpected
dropping of the guide post.
Work Lamp Switch – Turn lamp on and off. Caution must be used as light will be hot.
Blade Shear Lever –
Located on upper left hand side of the column. Lever up position allows insertion of the
blade into the shear. Pull lever downward to cut the blade. (This shear unit must be
mounted during set up)
Grinder Toggle Switch –
Located on the blade welder panel found on columns front. Flip switch up to start grinder;
flip down to stop grinder. This motor has temperature protection which will turn off the
power automatically when the motor is over-hearting. Motor will reset once it cools down.
Weld Button –
Located on the blade welders panel found on the front of the column. Depress and hold to
start welding. Shuts off automatically when weld is done. Release when weld is completed
Anneal Button –
Located on the blade welders panel found on the front of the column. Depress and hold to
anneal blade, release to stop.
Blade Clamp Pressure Knob –
Located on the blade welders panel found on front of the column. Sets pressure for different
width blades.
Blade Clamps –
Located on the blade welder panel found on the front of the column. Down position allows
insertion of the blade into the clamp. Up position locks blade
Blade Tension Hand Wheel –
Located on underside of the upper frame. Turn clockwise to tension the blade;
counter-clockwise to release tension on the blade.
Blade Tracking Hand Wheel –
Located at the upper rear of the saw. Turn clockwise to track the blade toward front of the
blade wheel Turn counter-clockwise to track blade toward rear of the blade wheel. (Do not
let the blade ride up onto the wheel lip)
Table Tilt Mechanism – Located under worktable. To tilt table left or right, loosen hex cap
