JuiceGoose PS1-24 Manuale utente

PS1-24

7320 Ashcroft, Suite 104

Houston, Texas 77081

p: 713-772-1404

f: 713-772-7360

e: [email protected]

www.juicegoose.com

OWNERS MANUAL

24 VAC

90 WATT

WALL MOUNTED

CCTV POWER SUPPLY

06-06

PS1-24 Owners Manual.pub

page 1 Tuesday, September 26, 2006 13:27

CONGRATULATIONS

You have purchased a practical source for CCTV power. The Juice Goose PS1-24 is a

wall mountable 24 VAC power supply for attachment to a single high power consumption

camera.

FEATURES SUMMARY

PS1 features include:

WALL MOUNT NEMA 1 ENCLOSURE

EXTERNAL MOUNTING BRACKET

POWER CONNECTION FOR 1 CAMERA

3.75 AMPS @ 24VAC

MASTER POWER FUSE

SAFETY PRECAUTIONS

The PS1 is designed to operate with 120VAC, 60 Hz input. Operation with 220 or 240

volts will damage the unit and possibly cause personal injury.

CAUTIONS

1. The PS1 should always be grounded. Defeating the unit’s grounding capability

could create a hazard.

2. There are no user serviceable parts inside the PS1. Do not attempt service

yourself. Contact Juice Goose as directed in this manual if service is required.

3. Do not expose the PS1 to moisture. Avoid severe physical impacts to the

unit.

DISCLAIMER

Juice Goose shall under no circumstances be held responsible for any loss, damage or

injury resulting from the use of the PS1 in a manner inconsistent with any of the proce-

dures outlined in this document. The user is responsible for determining whether this

product is appropriate for the intended application.

Juice Goose is not responsible for any indirect, secondary or ancillary loss or damage,

including personal injury, loss of or damage to property or loss of income resulting

from the operation or failure of this unit.

MAIN POWER FUSE

The PS1-24 is equipped with a current overload fuse on the 120 volt, power input, side of

the transformer. A maximum 1 amp fuse should be used in this product.

INSTALLATION

1. Make sure the PS1 is NOT connected to power when installing it and making connec-

tion to a camera.

2. The PS1 is to be hardwired by a qualified electrician.

PS1-24 Owners Manual.pub

page 2 Tuesday, September 26, 2006 13:27

3. Remove desired “knock out” to route utility power input and camera power output leads

into the enclosure. Mount the PS1 in the desired location using the four screw holes on the

mounting bracket.

4. Power Leads

The blue wire leads on the transformer are to be connected to 120 volt, utility power. One

blue lead is connected to the fuse holder. Connect the fuse holder lead and one blue lead to

main utility hot and neutral leads. Connect the utility ground (green) lead to the ground lug

on the chassis. Connect the red, 24 volt output, leads to the camera.

5. Replace front panel and secure with the 4 screws provided.

6. Fuse Replacement –Always turn off power to the PS1 before replacing the fuse. Use a

maximum 1 amp fuse in the PS1-24.

TROUBLE SHOOTING

Before trouble shooting this power supply disconnect the power. If there is no power output check the

fuse and power connections, both input and output.

REPAIR

Should your PS1 need service contact Juice Goose for assistance and authorization to return the unit.

PLEASE NOTE: a return authorization number is required in order for the service personnel to correctly

and promptly identify, repair and return your unit.

You may obtain a Return Authorization Number by calling: 713-772-1404 or sending email to

[email protected].

DIMENSIONS (INCHES) 6.0 x 6.0 x 4.0

WEIGHT (LBS) 7

POWER INPUT 120 VAC, 60Hz

POWER OUTLETS RED WIRE LEADS

CURRENT CAPACITY .75 Amps @ 120 VAC

3.75 AMPS @ 24 VAC

CURRENT OVERLOAD PROTECTION 1 AMP MASTER CIRCUIT

CHASSIS DESIGN NEMA 1 METAL ENCLOSURE

CHASSIS FINISH POWDER COAT ENAMEL –TAN

SPECIFICATIONS

PS1-24 Owners Manual.pub

page 3 Tuesday, September 26, 2006 13:27

POWER FACTS AND CALCULATIONS

TERMINOLOGY

& RELATIONSHIPS

Amperage is a measure of current flow. (Similar to capacity or volume

of flow.) A power supply with greater amperage capacity than the current

demand of the equipment being powered is OK.

Amps = Watts / Volts (100 Watts at 24 Volts = 4.17 Amps)

Current (Amps) = Voltage / Resistance(Ohms)

Impedance in an AC circuit is very similar to resistance in a DC circuit

and is often used interchangeably.

Resistance is a force that opposes current flow in a circuit.

Voltage is a measure of potential electromotive force (similar to pres-

sure).

A power supply with higher voltage than recommended for a camera is

NOT OK.

Voltage Drop/100 Feet = .2 x Amperage x 1.26 (AWG-10)

Watts = Volts x Amps(24 Volts with 4.17 Amps = 100 Watts)

PS1-24 Owners Manual.pub

page 4 Tuesday, September 26, 2006 13:27

0.5 1.0 2.0 4.0 10.0

Distance

(Feet)

25 22 22 22 20 18

50 22 22 20 18 14

100 22 20 18 16 12

200 22 18 16 12 -

300 20 16 14 10 -

400 18 16 12 10 -

500 16 14 12 --

0.5

Amps 1.0

Amps 2.0

Amps 4.0

Amps 10.0

Amps

AWG

10 .10 .20 .40 .80 2.00

12 .16 .32 .64 1.25 3.2

14 .25 .50 1.0 2.0 5.0

16 .40 .80 1.60 3.20 8.00

18 .64 1.32 2.64 5.28 12.80

20 1.01 2.02 4.04 8.08 20.20

22 1.60 3.20 6.40 12.80 32.00

VOLTAGE DROP

MINIMUM WIRE GAUGE FOR

MAXIMUM 3.2 VOLT DROP

This table lists the required minimum wire size necessary to complete a paired

wire run of the stated length and experience no more than a 3.2 volt drop be-

tween the power supply and the camera or other powered device. In the exam-

ple above, should the cable run have been 200 feet rather than 100, with a 2

amp load, in order to not have a drop in excess of 3.2 volts, the wire size would

need to be at least 16 AWG. An alternative solution would be to power the load

with an original voltage of 28 VAC.

This chart illustrates voltage drop per 100 feet of paired wire as a function of

wire gauge and load current. By matching load current (Amps) across the top of

the chart with wire gauge (AWG) down the left side of the chart, one can deter-

mine voltage drop per 100 feet of paired wire run. Note: at 24 volts, 2 amps = 48

watts. For that size load the voltage drop for 100 feet of 18AWG would be 2.64

volts.

PS1-24 Owners Manual.pub

page 5 Tuesday, September 26, 2006 13:27

JUICE GOOSE

CCTV POWER SUPPLIES

PART NUMBER DESCRIPTION

RPS16-RX-24-12 AC PROTECTION, 24VAC + 12 VDC, 16 CAMERAS

RPS16-RX-24-24 AC PROTECTION, 24VAC + 24VAC, 16 CAMERAS

RPS16-RX-24-0AC PROTECTION, 24VAC, 8 CAMERAS

RPS16-RX-12-12 AC PROTECTION, 12VDC + 12 VDC, 16 CAMERAS

RPS12-RX-12-0AC PROTECTION, 12 VDC, 8 CAMERAS

RPS16-0-24-12 24VAC + 12 VDC, 16 CAMERAS

RPS16-0-24-24 24VAC + 24VAC, 16 CAMERAS

RPS16-0-24-024VAC, 8 CAMERAS

RPS16-0-12-12 12VDC + 12 VDC, 16 CAMERAS

RPS16-0-12-012 VDC, 8 CAMERAS

PS1-24 24VAC, 90W, 1 CAMERA.

PS1-24-424VAC, 90W, 1 CAMERA, NEMA 4 ENCLOSURE

PS4-24 24VAC, 90W, 4 CAMERAS, INCL. POWER CORD

PS4-24-424VAC, 90W, 4 CAMERAS, NEMA 4 ENCLOSURE

PS4-24-300 24 or 28VAC, 300W, 4 CAMERAS, INCL. POWER CORD

PS4-24-300-424 or 28 VAC, 300W, 4 CAMERAS, NEMA 4 ENCL.

PS8-24 24VAC, 90W, 8 CAMERAS, INCL. POWER CORD

PS8-24-424VAC, 90W, 8 CAMERAS, NEMA 4 ENCLOSURE

PS8-24-300 24 or 28VAC, 300W, 8 CAMERAS, INCL. POWER CORD

PS8-24-300-424 or 28VAC, 300W, 8 CAMERAS, NEMA 4 ENCL.

RACK MOUNTED

WALL MOUNTED

For additional Juice Goose products log on to our web site

www.juicegoose.com

or call

713.772.1404

PS1-24 Owners Manual.pub

page 6 Tuesday, September 26, 2006 13:27

Indice

Altri manuali JuiceGoose Alimentazione elettrica

JuiceGoose

JuiceGoose JG 8 Manuale utente

Manuali Alimentazione elettrica popolari di altre marche

Monacor

Monacor PS-12CCD Manuale utente

VOLTIMA

VOLTIMA MagicBox 15 Manuale utente

Agilent Technologies

Agilent Technologies 6032A Manuale utente

Miller

Miller Auto Deltaweld 452 Manuale utente

BCP

BCP PUOUBK Foglio di istruzioni

HC 2210 Manuale utente

Puls

Puls CT5.241 Manuale utente

OCZ

OCZ ZX1250W Manuale utente

iseg

iseg ECH 238 Manuale utente

Power

Power XXL A Series Manuale utente

Agilent Technologies

Agilent Technologies 6631B Manuale utente

Renogy

Renogy PHOENIX 300 Manuale utente

HP 6200B Manuale di servizio

Epson

Epson Stylus Scan 2500 Manuale operativo

Pulsar

Pulsar GREEN POWER CCTV PoE POE044816 Manuale utente

Puls

Puls MiniLine ML50.100 Manuale utente

Puls

Puls AS-Interface SLA4.100 Manuale utente

Kenwood

Kenwood PS-60 Manuale utente