WARNING
----------------------------------------------------
The air collected must not be conveyed into
a duct used to blow off smokes from
appliances fed with an energy other than
electricity (central heating systems, ther-
mosiphons, water-heaters, etc.).
Comply with the official instructions provided
by the competent authorities in merit when
installing the disposal duct. In addition,
exhaust air should not be discharged into a
wall cavity, unless the cavity is designed for
that purpose.
The room must be well aerated in case a
hood and some other heat equipment fed
with an energy other than electricity (gas,
oil, coal heaters, etc) operate at the same
time. In fact the intake hood, disposing of
air, could create a vacuum in the room. The
vacuum should not exceed 0,04mbar. This
prevents the gas exhausted by the heat
source from being intaken again. It is
therefore advisable to ensure the room
contains air taps able to ensure a steady
flow of fresh air.
ATTENTION: This appliance must be
grounded.
The following warning is valid in the United
Kingdom only: in case your cable is not
furnished with a plug, read the following
instructions; as the colours of the wires in
the mains lead of this appliance may not
correspond with the coloured markings
identifying the terminals in your plug, proceed
as follows:
– the wire which is coloured green and yellow
must be connected to the terminal in the
plug which is marked with the letter E or by
the earth symbol [ ], or coloured green
or green and yellow;
– the wire which is coloured blue must be
connected to the terminal which is marked
with the letter N or coloured black;
– the wire which is coloured brown must be
connected to the terminal which is marked
with the letter L or coloured red.
When making the electrical connections,
check that the current socket has a ground
connection and that the voltage values
correspond to those indicated on the data
English
plate inside the appliance itself.
In case your appliance is not furnished with
a non separating flexible cable and has no
plug, or has not got any other device ensu-
ring omnipolar disconnection from the elec-
tricity main, with a contact opening distance
of at least 3 mm, such separating device
ensuring disconnection from the main must
be included in the fixed installation.
Always switch off the electricity supply be-
fore carrying out any cleaning or servicing
operations on the appliance.
Thorough servicing guarantees correct and
long-lasting operation.
To get optimal conditions the air venting
pipe should:
– be as short as possible.
– have the lowest number of bends (max
bende angle: 90°).
– be made of material approved by local
authorities (according to the State).
– have its inner side as regular and
smooth as possible.
It is moreover recommended to avoid
drastic changes of pipe cross section
(recommended diameter: 200 mm).
INSTALLATION
----------------------------------------------------
This unit has been purposely designed to extract
vapours and smells from the kitchen in an
efficient and silent manner.
It can be installed on an outside wall (Fig. 1) or
on the roof (Fig. 2), and connected to a hood
located in the kitchen.
FITTING TO OUTSIDE WALL
A 150 mm or 200 mm diameter air extraction
pipe may be used (the pipe is not supplied);
select the one most suited to your needs and
follow the instructions below.
Installation with 150 mm air extraction pipe:
Remove the outer metal structure by loosening
the 4 screws (A) - Fig. 3.
Mount the pipe fitting (provided) on the unit as
indicated in Fig. 4.
Take the drilling template and place this on the
outer wall, in the exact position where the unit
is to be installed; make sure it is the right way
up – the side of the unit from where the air exits
must be at the bottom (Fig. 5).
Mark on the wall all the holes shown on the
sheet; the hole marked 200 Ø is used only as
“invitation” for the projection of the flange and
the pipe fitting. Drill the holes in the wall.
