Keenon Robotics W3 Manuale utente

Smart Delivery Robot

W3 User Manual

Notice

This document may not be copied, reproduced, transcribed, or translated, in part

or in whole, by any individual or organization, or be transmitted in any form or by

any means (electronic, photocopy, recording, etc.) for any commercial purposes

without the prior written permission of Keenon Robotics Co., Ltd.

This manual is for reference only and may not be exhaustive. Please contact our

Technical Support if you have any questions.

This manual is subject to change (such as content and picture updates) without

prior notice.

This manual is for reference only and may differ from the actual product. All the

statements are provided without warranties of any kind.

Safety Instructions

Warnings:

This wheeled robot is intended for indoor use on flat surfaces (smooth surface

with a slope less than 5 degrees and a stair height no more than 15 mm). Do not

use it outdoors (e.g., on an open balcony) or on any rugged ground (e.g., on

stairs).

This appliance can be used by children aged from 8 years and above and persons

with reduced physical, sensory or mental capabilities or lack of experience and

knowledge if they have been given supervision or instruction concerning use of

the appliance in a safe way and understand the hazards involved

- Children shall not play with the appliance

- Cleaning and user maintenance shall not be made by children without

supervision

- The appliance is only to be used with the unit provided

- This appliance contains batteries that are non-replaceable

For the purposes of recharging the battery, only use the detachable supply unit

provided with this appliance

This appliance can be used by children aged from 8 years and above and persons

with reduced physical,

sensory or mental capabilities or lack of experience and knowledge if they have

been given supervision or

instruction concerning use of the appliance in a safe way and understand the

hazards involved. Children shall not play with the appliance. Cleaning and user

maintenance shall not be made by children without supervision.

Staring into the source for not very long times, greater not than 100 s.

Do not use the robot in suspended environments (such as in a duplex apartment,

on an open balcony, on top of furniture, or on stairs) or in environments without

guardrails.

Do not use the robot at a temperature above 45°C or below 0°C, or on surfaces

with liquids or sticky substances.

Before use, tidy up all cables on the ground to prevent the robot from being

entangled.

Before use, remove all sharp objects (such as decoration wastes, glass, and nails)

from the ground to prevent damage to the robot chassis.

Do not place any non-transportable objects (including children and pets) on the

robot, whether it is stationary or in motion.

Do not push or move the robot while it is working.

Follow the instructions in the user manual when moving the robot.

Clean or maintain the robot and the charging pile when they are turned off or

disconnected from the power.

Avoid contact with hard or sharp objects.

Do not spill any liquid into the robot.

Do not push over the robot or place it upside down.

The robot is an electronic product. Please keep it away from fire.

Make sure the robot is powered off in shipment and the original packaging is

recommended.

Use the product in accordance with the User Manual or Quick Start Guide. Any

loss or damage caused by improper use shall be borne by the user.

WARNING! This product contains a button/coin cell battery. If the button/coin cell

battery is swallowed, it can cause internal chemical burns in as little as two hours

and lead to death. Dispose of used batteries immediately. Keep new and used

batteries away from children. If the battery compartment does not close securely,

stop using the product. If you think batteries might have been swallowed or

placed inside any part of the body, seek immediate medical attention.

Battery & Charging:

Do not use batteries, power adapters, or charging piles from any third party. Do

not dismantle, repair, or modify the battery or charging pile without

authorization. For use with BC254480030 supply unit only.

Do not place the charging pile near heat sources (such as heating radiators).

Do not wipe or clean the charging contacts with a piece of wet cloth or wet

hands.

Do not discard waste batteries. Leave them to a professional recycling

organization.

If the product will be left unused for a long period, store it in a cool and dry place

after having it fully charged and switched off. Charge it at least once a month to

avoid any damage to the battery.

- For pluggable devices: The socket should be located close to the device and

easily accessible.

Note: Using the wrong type of battery can create an explosion hazard. Make sure

to dispose of used batteries as instructed.

Caution:

This device complies with Part 15 of the FCC Rules / Innovation, Science and

Economic Development Canada’s licence-exempt RSS(s). Operation is subject to

the following two conditions: (1) this device may not cause harmful interference.

(2) this device must accept any interference received, including interference that

may cause undesired operation.

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est

conforme aux CNR d’Innovation, Sciences et Développement économique

Canada applicables aux appareils radio exempts de licence. L’exploitation est

autorisée aux deux conditions suivantes :

1. L’appareil ne doit pas produire de brouillage;

2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le

brouillage est susceptible d’en compromettre le fonctionnement.

Changes or modifications not expressly approved by the party

responsible for compliance could void the user's authority to operate the

equipment.

This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates

uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged

to try to correct the interference by one or more of the following

measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

MPE Reminding

To satisfy FCC / IC RF exposure requirements, a separation distance of 20 cm or

more should be maintained between the antenna of this device and persons

during device operation.

To ensure compliance, operations at closer than this distance is not

recommended.

L'antenne installée doit

être située de facon à ce que la population ne puissey être exposée à une distance

de moin de 20 cm. Installer l'antenne de facon à ce

que le personnel ne puisse approcher à 20 cm ou moins de la position centrale de

l’ antenne.

La FCC des éltats-unis stipule que cet appareil doit être en tout temps éloigné

d’au moins 20 cm des personnes pendant son functionnement.

Introduction

This manual describes the functions, features, installation, and use of Keenon

smart delivery robot W3 as well as the precautions during the operation.

It covers:

1. Robot introduction: A brief description of the robot's basic functions and

features and a detailed presentation of its structure.

2. Operations: The preparations and precautions during the installation and

use of the robot.

3. Appendices: Common faults, detailed specifications, and safety precautions

of the robot.

4. Warranty Policy.

   
10 
 
Contents 
Notice ...................................................................................................................... 2 
Safety Instructions ........................................................................................... 3 
Robot Introduction (Getting to Know the Robot) .................................................. 11 
Robot Structure ..................................................................................................... 11 
Operations (Using the Robot) ................................................................................ 14 
Installation ..................................................................................................... 14 
Powering On .................................................................................................. 15 
Settings .......................................................................................................... 16 
Delivery .......................................................................................................... 20 
Charging ......................................................................................................... 21 
Emergency Handling ...................................................................................... 22 
Moving the Robot .......................................................................................... 23 
Appendices ............................................................................................................ 25 
Faults & Troubleshooting ............................................................................... 25 
Specifications ................................................................................................. 27 
Warranty Policy...................................................................................................... 29 
 
 
  