5. Move slider assembly manually closer to you until it
stops moving. This condition is to be maintained till
Step 10. t
6. Impress 5V voltage on the sensor assembly
connector in 1. and confirm on the output voltage.
y
7. Confirm that the output is shown to be in the range
of 0.6 - 0.8V.
8. If the output is not showing the range of 0.6 - 0.8V,
turn the metal gear to right or left, as shown in the
diagram. Adjust so that the output will be in 0.6 -
0.8V range. i
9. After confirming that the output is in 0.6 - 0.8V
range, assemble the bracket and sensor assembly
to the slider assembly from the side direction while
making the gear and the metal gear to come into
contact. o
10. After procedure in 9. is finished, confirm the output
to be in 0.6 - 0.8V range using the procedure in 6.
!0
11. After procedure in 10. is finished, manually move
the slider assembly to the rear of chassis
assembly, until it stops moving. !1
12. Confirm that the output is in 4.35V - 4.65V range,
using the procedure in 6. If the output is found to
be out of the range, remove the bracket and
conduct the procedure in 6. again. !2
13. When the procedure in 12 is finished, install the
gear. !3
14. End
DISASSEMBLY FOR REPAIR
How to Install the Slider Assembly
t
!0
!2
!1
!3
o
iy
