Kicker KMC5 Manuale utente
Owner’s Manual | English
Manual del Propietario | Español
KMC5 Receptor Multi-Media
Benutzerhandbuch | Deutsch
KMC5 Multi-Media-Receiver
Manuel d’utilisation | Française
KMC5 Multi-Media Receiver
KMC5
Media Center
KMC5
1
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC Statement
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
The Load Equivalency Number (LEN) indicates the amount of current a device draws from the NMEA 2000 network. Each device should have an LEN specified on the product or in the product
documentation.
KMC5 NMEA 2000 Load Equivalency Number (LEN): 1 (50mA)
Caution! Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
IC Notice - CAN ICES-3 (B) - This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device.
Avis d’Industrie Canada - Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes :
(1) l’appareil ne doit pas produire de brouillage; (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement. mauvais fonctionnement de I’appareil.
Cet appareil numériquie de la classe B est conforme à la norme NMB-003 du Canada. CAN NMB-3 (B)
The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS-102 RF exposure, users can obtain Canadian information on RF exposure
and compliance.
Le dispositif rencontre l’exemption des limites courantes d’évaluation dans la section 2.5 de RSS 102 et la conformité à l’exposition de RSS-102 rf, utilisateurs peut obtenir l’information
canadienne sur l’exposition et la conformité de rf.
FCC ID: 2ADQMKMC1001 IC ID: 11078A-KMC5
2
mounting hole cutout template:
3 inches, 76.2 mm
gabarit de montage trou découpé:
3 pouces, 76,2 mm
plantilla de recorte del agujero de montaje:
3 pulgadas, 76.2 mm
montageloch ausschnittschablone :
3 Zoll, 76,2 mm
3 inches, 76.2 mm
3 pouces, 76,2 mm
3 pulgadas, 76.2 mm
3 Zoll, 76,2 mm
3
mounting hole cutout template:
3 inches, 76.2 mm
gabarit de montage trou découpé:
3 pouces, 76,2 mm
plantilla de recorte del agujero de montaje:
3 pulgadas, 76.2 mm
montageloch ausschnittschablone :
3 Zoll, 76,2 mm
3 inches, 76.2 mm
3 pouces, 76,2 mm
3 pulgadas, 76.2 mm
3 Zoll, 76,2 mm
4
KMC5 OWNER’S MANUAL
Contents
Specs 5
Overview 6
Installation 7
Operation 10
Troubleshooting 13
Warranty 41
Contentido
Especificaciones 14
Descripción general 15
Instalación 16
Funcionamiento 19
Resolución de problemas 22
Garantía 41
Contentu
Spécifications 23
Généralités 24
Installation 25
Utilisation 28
Dépannage 31
Garantie 41
Inhalt
Technische Daten 32
Übersicht 33
Installation 34
Betrieb 37
Fehlersuche 40
Garantie 41
5
Model KMC5
Power Output @ 14.4V, 2Ω stereo, <10% THD+N 40W x 6
Power Output @ 14.4V, 4Ω stereo, <10% THD+N 25W x 6
Frequency Response [Hz] 20 – 20k
Signal-to-Noise Ratio [dB] 100
Pre-Amp Outputs Front, Rear, Sub, Zone2
Input Sensitivity Adjustable 500mV–1.5V
USB Playback MP3/WMA/FLAC/WAV
USB Charging DC 5V, 1A
USB Compatible File System FAT32
IP Rating IP66
Line-Out Level [V] 4
Outer Trim Dimensions[in, cm] 3.5 x 5.5, 8.89 x 13.97
Protrusion From Mounting Surface [in, cm] 1-5/16, 3.33
Total Mounting Depth [in, cm] 5, 12.7
Mounting Hole Diameter [in, cm] 3, 7.62
Be careful not to drill into wiring or vehicle mechanisms.
You are solely responsible for securely mounting the KMC5
Media Center. See page 2–3 for mounting hole cutout
template.
Before installation, you may wish to plan your placement of
the USB and Auxiliary inputs, and the optional KRC12 and
KRC15 remotes (sold separately), for both convenience
and looks!
With a KICKER KXM amplifier, a pair of KICKER KM
speakers, and a few KICKER cables, you’re looking at a full
system upgrade that will dominate! KICKER amplifiers and
accessories make upgrading a snap. Ask your dealer about
KICKER amplifiers and speaker upgrades to complete your
system!
All specifications and performance figures are subject
to change. Please visit www.kicker.com for the most
current information.
WARNING: KICKER products are capable of producing sound levels
that can permanently damage your hearing! Turning up a system to a level
that has audible distortion is more damaging to your ears than listening to
an undistorted system at the same volume level. The threshold of pain is
always an indicator that the sound level is too loud and may permanently
damage your hearing. Please use common sense when controlling
volume.
Authorized KICKER Dealer:
Purchase Date:
Serial Number:
SPECIFICATIONS
6
SOURCE
FAVORITES
MENU
•power on/off (long press)
•change input source (short press)
•change volume/value/selection
•confirm/select (press)
•enter audio menu (short press)
•enter main menu (long press)
•save/select favorite presets
•digital display
•seek
•previous track/rewind
•change tuner
•back/return/previous
•seek
•next track/fast forward
•change tuner
•play/pause
•mute
NOTE: Use short and long presses to operate.
Some input sources do not support all functions.
OVERVIEW If the battery voltage is low (<+10.5V), an on-screen warning will appear.
Recharge battery and avoid becoming stuck or marooned.
7
USB input
USB charging
front RCA out
(grey)
sub RCA out
(red)
rear RCA out
(green)
zone 2 RCA out
(purple)
AUX input
(black)
reverse camera/
video input
reverse trigger
remote SiriusXM®
port
digital
remote
NMEA
port
antenna
INSTALLATION
Remember to cap unused wires
and avoid electrical shorts!
8
12V
+12V (switched)
+12V
≤7”
18cm
dimmer (leave
disconnected if no
dimmer circuit present)
fuse: 20A ATC
rear right
(purple)
Z2 right
(brown) Z2 left
(pink)
rear left
(green)
front right
(grey)
front left
(white)
ground
ground
ground
Zone 2 Output RGB Input
Main harness
fuse
fuse
battery
remote
auto-turn
on output
positive
negative
9
1. Remove adhesive from rear gasket and apply to the back of the KMC5.
2. Securely fasten the KMC5 to the mounting surface using the including screws.
3. Attach the snap-on trim ring to the front of the KMC5.
Altri manuali per KMC5
1
Indice
Lingue:
Altri manuali Kicker Lettore DVD
