Kidde 900-0122 Manuale utente
Assembly Number 900-0122-UK
ALARM
OPERATE
O
N
T
W
I
S
T
O
F
F
KIDDE
SMOKEAND CARBON
MONOXIDE ALARM
M
O
V
E
T
O
F
R
E
S
H
A
I
R
PUSH &
HOLD
TO TEST
WEEKLY
Manual P/N 810-1808-Rev. A
For questions concerning your
Smoke and Carbon Monoxide
Alarm, please call
0800 917 0722
(Mon-Frid 9am-5pm)
Installation instructions
MUST be adhered to.
For your convenience, write down the following
information. If you call our consumer hotline,
these are the first questions you will be asked:
Alarm Model Number (located on back of alarm):
Date of Manufacture (located on the back of the alarm):
Date of Purchase:
Where Purchased:
Alarm Assembly Number (located on the back of the alarm)
With 2-LED Display and Peak Level Memory
Kidde Safety Europe Limited
Battery Operated
COMBINATION SMOKE &
CARBON MONOXIDE ALARM
User’s Guide
TESTED BY THE LOSS
PREVENTION COUNCIL/B.R.E.
BOARD FOR ALARM POINTS TO
BS7860-1996-Carbon Monxide
BS5446-2000-Smoke Alarm
Introduction ..............................................................................Page 1
Product View ........................................................................Pages 2-3
Features ..................................................................................Pages 4-7
Operating/Installation Instructions
Step 1 Installing Batteries ............................................................Page 8
Step 2 Installation Instructions:
A. Recommended Installation Locations ........................Pages 9-10
B. Where Not to Install ..................................................Page 11-12
C. How to Install..................................................................Page 12
D. Tamper Resist Feature ....................................................Page 13
Step 3 Testing the Alarm ..........................................................Page 14
Step 4 Peak Level Memory ........................................................Page 15
What to do if the Alarm Sounds
Smoke Alarm........................................................................Pages 15-16
Carbon Monoxide Alarm ....................................................Pages 17-18
Battery Replacement ......................................................Pages 18-19
General Alarm Maintenance ........................................Pages 19-20
Carbon Monoxide Safety Information
General CO Information............................................................Page 21
Possible Sources ..........................................................................Page 21
CO Safety Tips............................................................................Page 22
Symptoms of CO Poisoning ................................................Page 22-23
Fire Safety Information
Escape Plan..................................................................................Page 23
Fire Prevention ............................................................................Page 24
Warranty and Service Information ............................Pages 25-27
Product Registration ................................................................Page 28
Details on CO alarm installation as stated in Annex B of
BS7860-1996 ................................................................................Page 29
Table of Contents
Thank you for purchasing the Kidde Combination Smoke and
Carbon Monoxide Alarm model 900-0122-UK. This alarm
has a five-year limited warranty. Please take a few minutes to
thoroughly read this user’s guide, and save for future reference.
Teach children how to respond to the alarms, and that they
should never play with the unit. Your Kidde Smoke/CO
Alarm was designed to detect both smoke and carbon
monoxide from any source of combustion in a residential
environment. It is not designed for use in a
caravan or boat. If you have any questions about the
operation or installation of your alarm, please call 0800 917
0722 (Monday to Friday 9am - 5pm). The guide on page 24
will help you determine the correct location of safety products
that will help keep your home a safer place.
Introduction
1
2
Product View
ALARM
OPERATE
O
N
T
W
I
S
T
O
F
F
KIDDE
SMOKE AND CARBON
MONOXIDE ALARM
M
O
V
E
T
O
F
R
E
S
H
A
I
R
PUSH &
HOLD
TO TEST
WEEKLY
FRONT
Red LED Light
Green LED Light
Test/Reset
Button
Alarm
Sounder
3
Product View
3
2
1
WARNING:
BATTERIES
MISSING
INSTALL
LAST
INSTALL
SECOND
INSTALL
FIRST
+
+
+
BACK
3
2
1
INSTALL
THIRD
INSTALL
SECOND
INSTALL
FIRST
WARNING:
BATTERIES
HAVE BEEN
REMOVED
AA Battery
AA Battery
AA Battery
Battery
Chamber
Battery Placement
• Permanent independent smoke and carbon monoxide
sensors.
• Smoke alarm takes precedence when both fire and
carbon monoxide are present.
• Alarm/Voice message warning system that alerts you of the
following conditions in the manner described below, thus
eliminating any confusion over which alarm is sounding:
FIRE: The alarm/voice pattern is three long alarm beeps
followed by the verbal warning message “FIRE! FIRE!”.
This pattern is repeated until the smoke is eliminated. The
red LED light will flash while in alarm/voice mode.
CARBON MONOXIDE: The alarm/voice pattern is four
short alarm beeps followed by the verbal warning message
“WARNING! CARBON MONOXIDE!” After four
minutes the alarm/voice pattern will sound once every
minute until the unit is reset, or the CO eliminated. The
red Light Emitting Diode (LED) light will flash while in
alarm/voice mode.
LOW BATTERY: When the batteries are low and need
replacing the red LED light will flash and the unit will
“chirp” one time, followed by the warning message “LOW
BATTERY.” This cycle will occur once every minute for
the first hour. After the first hour the red LED light will
continue to flash every minute accompanied by the
“chirp” only sound. The voice message “LOW
BATTERY” will sound once every fifteen minutes during
the “chirp” only cycle. This will continue for at least seven
days.
Features
4
• One “chirp” every 30 seconds is an indication that the alarm
is malfunctioning. If this occurs call the Consumer Hotline
at 0800 917 0722 (Monday to Friday 9am - 5pm).
• Loud 85 decibel alarm.
• Oversized test button for easy activation.
• Test button performs the following functions:
Tests the units electronics and verifies
proper unit operation
Resets the unit during CO alarm
Peak Level Memory (See page 15).
• Mounting bracket designed for easy orientation of unit.
• Green and red LED lights that indicate normal operation
and alarm status.
Green Light: The green Light Emitting Diode(LED)
flashes every 30 seconds to indicate the unit is operating
properly. The green light also flashes before a CO reading is
taken and when any button is pressed.
Red Light: When a dangerous level of smoke or carbon
monoxide is detected the red Light Emitting Diode (LED)
will flash and the corresponding alarm pattern (depending
on the source) will sound. If the unit malfunctions, the red
LED light will flash and the unit will chirp every 30 seconds
indicating a system problem.
• Powered by three (3) AA batteries.
• Battery lockout system that prohibits installation
without using three batteries.
• Tamper Resist Feature that deters children and others from
removing the alarm.
Features
5
Smoke Alarm
The smoke alarm monitors the air for products of combustion
that are produced when something is burning or smouldering.
When smoke particles in the smoke sensor reach a specified
concentration, the alarm/voice message warning system will
sound, and be accompanied by the flashing red LED light.
The smoke alarm takes precedence when both
smoke and carbon monoxide are present.
This unit has a smoke sensor that uses the
ionisation technology. Ionisation units are the fastest at
responding to fast flaming fires that give off little smoke.
Photoelectric smoke alarms are the fastest at responding to
slow smouldering, smoky fires. Kidde Safety recommends
for maximum protection that both ionisation and
photoelectric smoke alarms should be installed.
Home fires can develop in different ways and are often
unpredictable. Neither type of alarm is always best, and a
given alarm may not always provide warning of a fire.
CAUTION: Smoke must reach the sensor to be detected.
Smoke alarms may not sense fires starting in chimneys, walls,
on roofs, on the other side of a closed door, or on a different
floor. The alarm may be unable to wake a sound sleeper, or
someone impaired by alcohol or drugs.
Smoke Alarm Features
6
Carbon Monoxide (CO) Alarm
The carbon monoxide (CO) alarm monitors the air for the
presence of CO. It will alarm when there are high levels of CO
present, and when there are low levels of CO present over a
longer period of time. When a CO condition matches either of
these situations, the alarm/voice message warning system will
sound, and be accompanied by the flashing red LED light. The
carbon monoxide sensor uses an electrochemical technology.
CAUTION: This alarm will only indicate the
presence of carbon monoxide gas at the sensor.
Carbon monoxide gas may be present in other
areas.
Individuals with medical problems may consider using warning
devices which provide audible and visual signals for carbon
monoxide concentrations under 30 ppm.
Carbon Monoxide Alarm Features
7
Step 1
Installing Batteries:
Batteries were not installed at the factory and must be
installed for the unit to operate! Install the three (3) AA
batteries in the back of the Smoke/CO Alarm.
• The mounting plate must be removed from the back of the
unit to install batteries. To remove, hold the mounting plate
and twist counterclockwise (left).
• The battery polarity markings on the bottom of the battery
compartment must be adhered to.
• Batteries must be installed in the sequence shown. If batteries
seem difficult to install, they’re not being installed in the
proper sequence.
• Smoke/CO Alarm will not engage to bracket unless all three
batteries are installed. Removal of any or all batteries will
render the Smoke/CO Alarm inoperative!
• After the batteries are correctly installed the unit will beep
once and the red LED light will flash.
After 20-30 seconds the green LED light will flash indicating
the unit is now operational.
CAUTION: Your Smoke/CO Alarm is sealed and the
cover is NOT removable!
3
2
1
WARNING:
BATTERIES
MISSING
INSTALL
LAST
INSTALL
SECOND
INSTALL
FIRST
+
+
+
Operating/Installation Instructions
8
Batteries Must Be Installed in Order Shown Below:
Install
First
Install
Second
Install
Last
3
2
1
INSTALL
THIRD
INSTALL
SECOND
INSTALL
FIRST
WARNING:
BATTERIES
HAVE BEEN
REMOVED
AA Battery
AA Battery
AA Battery
1.
2.
3.
1.
2.
3.
Indice
Altri manuali Kidde Rilevatore di fumo
Kidde
Kidde Fyrewatch 0913 Manuale utente
Kidde
Kidde TRUSENSE SMOKE 3050-VAS10 Manuale utente
Kidde
Kidde P4010LDCS-WCA Manuale utente
Kidde
Kidde FX-PDD Istruzioni per il montaggio
Kidde
Kidde P4010ACLEDS-2 Manuale utente
Kidde
Kidde 0915CA Manuale utente
Kidde
Kidde i9060CA Manuale utente
Kidde
Kidde 1276 Manuale utente
Kidde
Kidde 0916LL Manuale utente
Kidde
Kidde DC-9102E-KID Manuale utente
Kidde
Kidde KIR-PHD Istruzioni per il montaggio
Kidde
Kidde 910 Manuale utente
Kidde
Kidde i12060 Manuale utente
Kidde
Kidde P4010ACSAQ-WF Scheda tecnica
Kidde
Kidde P4010DCSCO-W Manuale utente
Kidde
Kidde 976 Manuale utente
Kidde
Kidde PI9010 Manuale utente
Kidde
Kidde PI9010 Manuale utente
Kidde
Kidde Slick 1SF23/9HI Manuale utente
Kidde
Kidde Smoke Alarm Manuale utente
Manuali Rilevatore di fumo popolari di altre marche
System Sensor
System Sensor DH500ACDC Manuale utente
Resolution Products
Resolution Products RE612 CryptiX Manuale utente
First Alert
First Alert PC900V Manuale utente
Eminent
Eminent EM6590 E-Domotica Manuale utente
Ei Electronics
Ei Electronics Ei Ei168RC Manuale utente
Carrier
Carrier Kidde Quell Q301 Manuale utente
