Operation
Before attempting to cut actual tiles to be
installed, it is recommended to familiarize
yourself with the operation of this Tile Cutter by
test cutting scrap ceramic tiles first.
1) Lift lever and position ceramic tile on the Tile
Cutter table.
2) Align marked cut line with the cutting wheel
(B) Fig.1. Score whole tile length evenly.
Refer to score line (A) Fig.1.
3) Make sure the tile snapping pressure plate
(C) Fig.1 is lifted and not engaged.
4) Position the tile snapping pressure plate (A)
Fig.2 vertically as shown and press down on
the lever evenly to snap tile cleanly.
5) To make repeat cuts of the same width, an
edge guide (B) Fig.2 is provided. Loosen
lock knob (C), set the edge guide to the
desired distance and retighten lock knob.
Figure 1
GETTING TO KNOW YOUR
TILE CUTTER
Figure 2
Getting to know your Tile Cutter
1. Lever
2. Dual sliding rails
3. Base
4. Table with rubber pads
5. Tile snapping pressure plate
6. 16mm cutting wheel
7. Edge guide lock knob
8. Edge guide
Specifications
Max cutting length: 24”
Diagonal cutting: up to 16” tile
Maximum cutting thickness: 1/2” (12mm)
Cutting wheel diameter: 16mm
Replacement cutter wheel: Model KW-160
