ASSEMBLY & ADJUSTMENTS
ASSEMBLY
Some assembly is required. Carefully remove the
workstation and loose parts from the box. Position the
top of the workstation down on the floor with folded
legs facing upwards.
INSTALLING TRANSPORT HANDLES
1) Install the transport handles (A) Fig.1 to the leg
base (B) at both ends of the workstation using 4
cap screws and nylon hex. nuts.
UNFOLDING WORKSTATION LEGS
1) Press the spring locking pin (A) Fig.2 on the leg
and lift the leg up until the spring locking pin snaps
into place as shown. Repeat for the other 3 legs.
Make sure all spring locking pins have locked into
place.
2) Position the workstation on its legs in the upright
position.
INSTALLING ROLLER ASSEMBLIES AND
SUPPORTS TO EXTENSIONS
1) Insert roller support bracket (A) Fig.3 into the opening
of the extension bar (B), then install and tighten the
lock knob (C) to secure it in place.
2) Install the roller support assembly (D) Fig.3 into the
slot (F) of the roller support bracket (A). Position
the head of the carriage bolt attached under the
roller support lock knob (E) into the round end of
the slot (F), slide the assembly into place. Tighten
roller support lock knob (E) to secure it in place.
3) Tolock the extension (B) at a desired distance,
install and tighten the extension lock knob (I), to
secure it in place.
ADJUSTING ROLLER ASSEMBLIES WITH WORK
STOPS
1) The position of each roller assembly can be adjusted side-to-side, loosen lock knob (E) Fig.5,
adjust position and retighten lock knob.
2) The position of each roller assembly can be adjusted up or down, loosen lock knobs (G)
Fig.5, adjust position and retighten lock knobs.
3) Each roller assembly comes with a work stop (H) Fig.5. To use work stop, simply flip it
upwards as shown in Fig.5, when not in use, flip it downwards.
FIGURE 1
FIGURE 2
FIGURE 3
ASSEMBLY & ADJUSTMENTS
INSTALLING POWER TOOL ON QUICK MOUNT
SUPPORTS
Warning! This workstation was designed to install
power tools having a foot print no larger than 18”
deep. If your power tool has a larger foot print, we
recommend mounting your power tool on a board
and mounting the board to the workstation quick
mount supports.
1) Fix the quick mount supports (A) Fig.4 to your
power tool using 4 carriage bolts, washers, spring
washers and hex. nuts (B) as shown. At this point,
only hand tighten the hex. nuts.
2) Position the power tool and quick mount supports
assembly onto the top of the workstation bed, place
the rear of the quick mount supports onto the bed
first, then squeeze the locking handles (A) Fig.5
and lower the front of the quick mount supports to
secure the assembly in place.
3) Once the power tool and quick mount supports
assembly is installed on bed, slide the power tool
back or forth until power tool is in the desired
position (in relation to the roller supports). Completely tighten the hex. nuts using a
wrench.
Note: Additional optional quick mount support kits (model KW-125) are available. These
allow quick interchangeability without having to unbolt your power tool.
INSTALLING ROLLER ASSEMBLY ON WORK LIGHT QUICK MOUNT SUPPORT
If supporting short workpieces is required, it is
recommended to install the roller assembly onto the
work light quick mount support.
1) Install roller assembly (A) Fig.6 into one of two
slots (C) on top of the work light quick mount
support (B). Position the head of the carriage bolt
attached under the roller support lock knob (D) into
the round end of desired slot (C), slide the
assembly into place. Tighten roller support lock
knob (D) to secure it in place.
FIGURE 4
FIGURE 5
FIGURE 6
