Kiwitron ETS Manuale di istruzioni
ETS quick start manual
Placement
The card reader (ETS-UP) device must be in an easy to reach location as the
driver needs to use it to unlock the truck before use.
For the best shock detection, we advise to place the IO expansion (ETS-DN)
firmly connected to the truck frame and perpendicular with the ground and
the moving direction.
Avoid installing the ETS in environmentally hard location such as close to
strong heat sources or exposed to the elements (although the ETS is IP65).
Also be aware not to place the card reader (ETS-UP) close to metallic objects
which can prevent the wireless transmissions.
Pinout
X1 connector pinout
Position
Function
1
Power input positive (10 - 120 Volts DC)
2
Power input negative
3
Digital input IP1 (positive activation threshold >1,7 Volts - 150 Volts max)
4
Digital input IP2 (positive activation threshold >1,7 Volts - 150 Volts max)
5
Analog input (0 - 10 Volts)
6
Digital input IN1 (negative activation threshold < 0,5 Volts - 150 Volts max)
7
Digital input IN2 (negative activation threshold < 0,5 Volts - 150 Volts max)
8
Relais 1 - common contact
9
Relais 1 - normally open contact (6Amp max)
10
Relais 2 - common contact
11
Relais 2 - normally open contact (6Amp max)
12
Relais 3 - common contact
13
Relais 3 - normally open contact (6Amp max)
14
Analog input AIN1 (0 - 5Volts) (used for current sensor)
X2 connector pinout
Position
Function
1
Power output positive (5 Volts DC)
2
Power output negative
3
CAN +
4
CAN -
Canbus line on X2 connector has line closure resistor (120 ohm)
Connection diagram example
Software setup
Only few steps are needed to configure the device. Download and install the
PC software from www.kiwitron.it/ets
Connect the USB cable and start the ETS software.
Shock sensor calibration
Go to “Settings → Advanced → Accelerometer” and configure the mounting position
according to the drawings.
Click
“Save”
and then
“0 Accelerometer”.
Battery percent sensor calibration
Go to “Settings → System → Battery” and change the
“Elements”
field according to the
number of elements present in the truck battery (e.g.: a 48 Volts battery has 24
battery elements).
Click
“Save”.
Battery current sensor calibration
Go to “Settings → System → Battery”. Ensure the truck is ON and that no actuation is
in progress then click
“0 Current sensor”.
Badge configuration
Go to
“Users”
. Click the green button to configure a new driver. When
prompted, choose
“Wizard”
to start the guided badge configuration.
Insert a driver name and click
“Next”.
Put the badge on the reader (in front for
ETS device; on the left side for ETS Touch device). The badge code shall
appear on the PC screen. Click
“Next”
until the wizard ends.
Insert any other driver desired using the same procedure.
Click
“Send to device”
to save the user list (important!).
Close a relay contact on shock detection
Go to “Settings → Signals→ ETS”.
Altri manuali per ETS
2
Indice
Altri manuali Kiwitron Lettore di schede
