KLINGER EMXN1010 Manuale utente
EMXN1010
Manual
V1.0
TOP
EMXN1010
DIMENSION
FRONT
SPECIFICATIONS
111
60
136
PALNTSC
1/3" Sony Super HAD CCD
Color - 600TV lines / B&W - 700TV lines
)V(285x)H(357)V(494x)H(867
2:1 Interlace
Internal
0.1Lux @F1.2(Normal mode)
52 dB (AGC Off/Weight ON)
1Vp-p Composite 75Ω
15.734KHz(H)/ 60HZ (V) 15.625KHz (H) / 50Hz (V)
1/50 ~ 1/120,000sec1/60 ~ 1/120,000sec
ATW1/ATW2/AWC/Manual
ON / OFF (54 ea / 2 line)
ON / OFF (Level setting)
x2 ~ x256
ON / OFF (Aera setting)
LOW / HIGH / OFF selectable
ON /OFF
ON /OFF (8 zone)
ON /OFF
ON /OFF
ON /OFF
ON /OFF (Level adjustable)
ON / OFF ( x 10)
COLOR / BW / AUTO / EXT
f = 2.8~11mm Aspheric AI Lens (F1.2)Standard
mm22~9,mm6~6.2noitpO
DC12V(±10%) / AC24V(±10%) Power regulated
500mA Max.
-25°C ~ +50°C
30% ~ 90% RH
Weight875g
136 (Dia) x 111 (H)
Lens
Sharpness
Power Source
Scanning Frequency
Power Consumption
Operating Temperature
Electronic Shutter Speed
Operating Humidity
Dimensions (HxDmm)
Scanning System
Synchronization
S/N ratio
Horizontal Resolution
Min.lllumination
SPECIFICATION
Video Output
CCD
Effective Pixels
Digital Zoom
Sens-up
DNR
AGC
Motion Detection
Day & Night
DIS
Privacy Function
Camera ID
BLC
White Balance
Mirror(H-rev)
Flip(V-res)
20m ( IR LED 5pie - 24EA )Indoor
)AE42-eip5DELRI(m31roodtuO
Visible Range
(LED ON)
INSTALLATION
1
567
234
SLIDEPIG 1
PIG 2
Mount Base Mount Base
Mount Base
“L” Wrench
“L” Wrench
“L” Wrench
Wrench Screw
Fixing Screw
Fixing Point
Insert Point
Camera
Camera
Gimbal
Gimbal Cap
OSD Controller
Video test Port
Camera
Body
Camera
Body
Cover
Ring
Fix the mount base onto the ceiling
or wall by the fixing screw and insert
the camera like the arrow direction.
Open the bubble cap and move the camera gimbal
to left, right and up, down to set the viewing direction.
After set the viewing direction, open the gimbal cap
like the arrow diection snd adjust the viewing angle.
Set the desired OSD feature by using the OSD controller.
(Refer the SOD manual to set up the desired OSD)
in case of a installer has portable monitor, connect the
video jack to the video test port to set up the OSD.
Tighten the screw by using the “L”wrench
and complete the installation.
After insert the camera body to the mount base
like the Fig1 and slide the camera body just like
the Fig2 to fix the camera onto the base.
Fix the screw into screw hole in the mount-
base by using the “L”wrench and tighten
the camera body onto the base.
Unscrew the cover ring screw by
using the “L”wrench and open
the cover ring.
Cover
Ring
Altri manuali KLINGER Macchina fotografica digitale
