6
Congratulations –
With your new OASIS granite socket from
Knirps you decided on a top-quality prod-
uct. And you will see: your pleasure will
even increase the longer you take ad-
vantage of its benefits. With more than
200 million produced articles, Knirps is
one of the leading manufacturers around
the world. Sophisticated technology and
careful material selection are a matter of
course for us.
Last, but not least, we wish you plenty of
sunny days with your new OASIS product
or put simply: relaxation at its finest!
Granite base with and with-
out roll system and pull han-
dle – Setup and operating
instructions
Carefully read through the
complete instruction manual,
particularly the safety notes.
Failure to heed this instruction
may result in severe injury or damage to
the product. Hold onto the instruction
manual for future reference or in order to
pass them onto third parties.
Your safety
Please observe the following
safety notes. The manufactur-
er is not liable for damages on
the basis of failure to observe
these notes.
The granite socket is not a children‘s toy
as children could crush their fingers or
feet.
The product should be set up by a com-
petent adult.
Never leave the granite socket unattend-
ed in an upright position – if it tips over, it
could inflict serious injury.
Keep in mind that, depending on the wind
intensity and the diameter of the shade,
even this granite socket may be too “light”.
Make sure that the shade is closed in the
event of incoming wind.
Proper use
The granite socket is, depending on the
configuration, suitable as a stand for sun
shades with a pole diameter of no more
than 60 mm. The granite socket is only in-
tended for private use. It is not suitable for
commercial application.
Before you use the granite socket, please
first carefully read through the safety
notes. Only in this way, will you be able
to use the socket in a safe and reliable
manner.
Be absolutely sure to observe the nation-
al regulations in force, which apply in your
country and which are also valid in addi-
tion to the regulations specified in these
instructions.
Mounting the standpipe
You will need:
– the enclosed socket key
– the assistance of 1 person
1. Lift the granite socket and set it upright
on one of its sides.
Have another person hold onto the
socket!
2. Slip the small rubber washer a, wash-
er band snap ring cover the screw d.
3. Run the screw through the gran-
ite socket from the underside (see
Figure A).
4. Push the large rubber washer eon
the top of the granite socket over the
threading of screw d(see Figure A).
5. Screw tighten the threaded hole of the
standpipe fon the screw d.
6. Carefully tip the granite socket back
onto the ground area.
Mounting the sun shade pole
Using the inserts
Use the inserts based on the size of your
sun shade pole.
1. Place the required inserts in the stand-
pipe (see Figure D).
GB
92393 i 20150715.indd 692393 i 20150715.indd 6 15.07.15 10:5215.07.15 10:52
