Kogan KAMESHWFI6A Manuale utente
AX1800 WHOLE-HOME MESH
WI-FI 6 DUAL-BAND SYSTEM
(1 PACK)
KAMESHWFI6A
1
LED indicator
2
DC power input
3
Power switch
4
Reset button
5
Pair button
6
LAN ports
7
USB port (x2)
8
Touch-link pad
9
WAN port
OVERVIEW
Install the Kogan Mesh App
Download the Kogan Mesh App on your mobile device by searching for “Kogan Mesh” in
App Store or Google Play or by scanning the OR code. Then, install the App.
INSTALLATION
Connect the Primary node:
The first node you set up functions as the primary node, while the rest are referred to as the
secondary nodes.
1. Power off your modem and remove its battery (if any).
2. Use the included Ethernet cable to connect to a LAN port on your modem to the
WAN/LAN port on one of the nodes. This node will be your primary node.
3. Reinstall its battery and power on your modem.
4. Use the included power adapter to connect the primary node to a power source,
the LED indicator lights solid purple.
Internet
Ethernet jack
Modem
Connect the primary node to the internet
1. Go to the Wi-Fi network list on your mobile device, select the SSID of the primary
node and enter its password. The SSID and password are specified on the bottom
label of any node.
2. Run the Kogan Mesh App and follow the onscreen instructions to connect the
primary node to the internet. After the primary node is connected to the internet,
its LED indicator lights solid blue.
Connect the secondary nodes to the internet
1. Place each node:
• In a high and open area.
• Ensure that there are less than two walls between any two nodes.
• Keep your nodes away from electronics with strong interference, such as microwave
ovens, induction cookers and refrigerators.
2. Use other power adapters to connect the secondary nodes to a power outlet, the LED
indicators will turn solid green. Wait for about 40 seconds. The secondary node is
connecting to another node when its LED indicator flashes blue.
3. Observe the LED indicator of the secondary nodes until their LED indicators are one of
the following colours:
Solid Blue
Internet is connected
Slowly flashing Red
Disconnected
4. If a node's LED indicator does not light solid blue, you can relocate it ensuring you avoid
obstructions and any electronic interference.
To access the internet:
• Wired devices: Connect wired devices to the LAN ports of your nodes.
• Wireless devices: Connect wireless devices to the Wi-Fi network using the SSID and Wi-
Fi password you set.
• To manage the network anytime anywhere, tap “ ” icon in the app and use your
account to login.
After completing the setup and installation using the Kogan Mesh App, a login prompt
page appears. You can authorize the Kogan Mesh App to use Google+, alternatively press
the “Other” button to create a login using your email address.
REGISTERING
If you miss the page above, tap on the upper-left corner and tap Login. Then choose
one type of account to login.
To Register an account
1. Run the Kogan Mesh App and tap in the upper-right corner.
2. Tap Login.
3. Tap Register on the upper-right corner.
4. Enter a valid email address.
5. Create a password for your account.
6. Tap Register.
A confirmation email will be sent to your email inbox. Check your email and follow the
instruction to activate your account. After following these guided steps, your account will be
registered successfully.
Altri manuali per KAMESHWFI6A
1
Indice
Altri manuali Kogan Router wireless
