komodo SP5733 Manuale utente
SP5733
USER MANUAL
Keep this manual for future reference
QUESTIONS, PROBLEMS, OR MISSING PARTS?
Please Contact Customer Service Before Returning to Store
Please carefully check the unit and make sure there is no damage when you open the carton.
www.soupro.com
• GENERAL INFORMATION
FCC/ICSES Information
Safety Instructions
Warranty
• ASSEMBLY INSTRUCTIONS
Preparation
Assembly
• FIREPLACE OPERATIONS
Operating Instructions
Care And Maintenance
Troubleshooting
Table of Contents
Safety Instructions
2
General InformatIon
Use this rebox only as described in the manual. Any other use is NOT recommended by the manufacturer and may cause
re, electric shock or injury to persons.
CaUtIon:
• If possible, ALWAYS unplug this rebox when not in use.
• DO NOT operate any rebox with a damaged cord or plug or after the heater malfunctions.
• DO NOT operate any rebox if it has been dropped or damaged in any manner. Disconnect power at service panel and have
rebox inspected by a reputable electrician before reusing.
• Any repairs to this unit should be carried out by appropriately qualied service personnel.
• Under no circumstances should this unit be modied. Parts having to be removed for servicing must be replaced prior to
operating this unit again.
• DO NOT use outdoors.
• This unit is not intended for use in bathrooms, laundry areas and similar indoor locations. NEVER place heater where it may
fall into a bathtub or other water container.
• To disconnect this unit, turn all controls to the OFF position, then remove plug from outlet.
• ONLY connect to properly grounded outlets.
• This appliance, when installed, must be electrically grounded in accordance with local codes, with the current CSA C22.1
Canadian Electrical Code or, for USA installations, follow the National Electrical Code, ANSI/NFPA NO.70.
This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to part 15 of the FCC
rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
The equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on. The user is encouraged to try and correct the interference by one or more of the following measures:
(a) Reorient or relocate the receiving antenna
(b) Increase the separation between the equipment and the receiver
(c) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
(d) Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
(a) This device may not cause harmful interference, and
(b) This device must accept any interference received, including interference that may cause undesired operation.
Modications not approved by the party responsible for compliance could void user’s authority to operate the equipment.
This Class B digital apparatus complies with Canadian ICES-003.
FCC / ICES Information
2
2
4
5
7
11
12
13
Please read and understand this entire manual before attempting to assemble, operate or install the product.
IMPORTANT NOTICE
When using electrical appliances, basic precautions should always be followed to reduce the risk of re, electric shock
and injury to persons, including the following:
WARNING: Place this unit in a location that avoids direct sunlight and high temperatures.
WARNING: Plastic bags, nails, etc. should be kept out of reach of children.
WARNING: This appliance is hot when in use. To avoid burns, DO NOT let bare skin touch hot surfaces. Keep
combustible material, such as furniture, pillows, bedding, papers, clothes and curtains, at least 3 feet from the front
of the heater and keep them away from the side and rear.
WARNING: Extreme caution is necessary when any heater is used by or near children or individuals with
disabilities and whenever the replace is left operating and unattended.
WARNING: DO NOT run cord under carpeting. DO NOT cover cord with throw rugs, runners, or similar covering.
Do not route cord under furniture or appliances. Arrange cord away from traffic areas and where it will not be
tripped over.
WARNING: DO NOT insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause
an electric shock or re, or damage the appliance.
WARNING: This appliance has hot and arcing or sparking parts inside. DO NOT use it in areas where gasoline,
paint or ammable vapors or liquids are used or stored. This replace should not be used as a drying rack for
clothing. Christmas stockings or decorations should not be hung in the area of it.
3
General InformatIon
• To prevent a possible re, DO NOT block any air intakes or exhaust in any manner. DO NOT use on soft surfaces, like a
bed, where opening may become blocked.
• ALWAYS plug this unit directly into a wall outlet/receptacle. NEVER use with an extension cord or relocatable power tap
(outlet/power strip).
• This heater includes an automatic protection system that will shut off the unit to prevent overheating. If the unit is at risk of
overheating, the front panel will display "E1" and a thermal cut out will shut off the heater to prevent damage or risk of re.
• DO NOT place any objects on top of rebox and top air intake vents as this will cause the unit to overheat and can cause a
re.
eleCtrICal ConneCtIon:
• A 15-amp, 120-volt, 60 Hz circuit with a properly grounded
outlet is required. Preferably, the fireplace will be on
a dedicated circuit as other appliances on the same
circuit may cause the circuit breaker to trip or the fuse
to blow when the heater is in operation. The unit comes
standard with 6-ft. three-wire cord, exiting from the rear
of the fireplace. DO NOT exceed the current rating of
the current tap. ALWAYS plug this unit directly into a wall
outlet/receptacle. NEVER use with an extension cord or
relocatable power tap (outlet/power strip).
• This rebox is for use on 120 volts. The cord has a plug as
shown below. See illustration for grounding instruction. An
adapter as shown at C is available for connecting three-
blade grounding type plugs to two-slot receptacles. The
green grounding lug extending from the adapter must
be connected to a permanent ground such as a properly
grounded outlet box. The adapter should not be used if a
three-slot grounded receptacle is available.
Grounding Pin
Grounding Pin
Grounding Means
Adapter
a
C
B
D
Metal Screw
Cover of
Grounding Box
eleCtrICal SPeCIfICatIonS
Voltage:
Amps:
Watts:
120 VAC, 60 Hz
11.7 Amps
1400 Watts
Warranty
1-YEAR LIMITED WARRANTY
Soupro Limited Inc. (hereinafter referred to collectively as “the Company”) warrants that your new KOMODO Electric
Fireplace is free from manufacturing and materials defects for a period of one (1) year from date of purchase. Subject to the
following conditions and limitations:
1. The electric fireplace must be installed and operated at all times in accordance with the installation
and operating instructions furnished with the product. Any unauthorized repair, alteration, willful abuse,
accident, or misuse of the product shall nullify this warranty.
2. This warranty is non-transferable, and is made to the original owner, provided that the purchase was
made through an authorized supplier of the Company.
3. The warranty is limited to the repair or replacement of part(s) found to be defective in material or
workmanship – provided that such part(s) have been subjected to normal conditions of use and service –
after said defect is conrmed by the Company’s inspection. All replacement parts or products will be new,
remanufactured, or refurbished.
4. The Company may, at its discretion, require that any defective part(s) be returned in exchange for the
replacement part(s).
5. The Company may, at its discretion, fully discharge all obligations with respect to this warranty by
refunding the wholesale price of the defective part(s).
6. This warranty does not cover the LED light bar included with the electric replace.
7. Any installation, labor, construction, transportation, or other related costs/expenses arising from defective
part(s), repair, replacement, or otherwise of same, will not be covered by this warranty, nor shall the
Company assume responsibility for the same.
8. The owner/user assumes all other risks – if any – including but not limited to the risk of any direct, indirect
or consequential loss or damage arising out of the use, or inability to use the product, except as provided
by law.
9. All other warranties – express or implied – with respect to the unit, its components and accessories, or
any obligations/liabilities on the part of the Company are hereby expressly excluded.
10. The Company neither assumes, nor authorizes any third party to assume on its behalf, any other liabilities
with respect to the sale of the unit.
11. The warranties as outlined within this document do not apply to non-accessories used in conjunction with
the installation of this product.
12. This warranty gives you specic legal rights, and you may also have other rights which vary from state to
state.
This warranty is void if:
(a) The replace is subjected to prolonged periods of dampness or condensation.
(b) Any unauthorized alteration, willful abuse, accident, or misuse of the product.
(c) You do not have the original purchase receipt.
4
GENERAL INFORMATION
IF WARRANTY SERVICE IS NEEDED
Please Contact Customer Service
Make sure you have the following information ready:
• Warranty
• Sales Receipt
• Product Model/Serial Number
• Date of Purchase
• Location of Purchase
www.soupro.com
Preparation
IMPORTANT INFORMATION
1. Before you begin, locate the instructions and hardware. Be sure you have all of the parts and can identify
them.
2. To avoid scratching the finish, assemble the product on a soft, non-abrasive surface such as carpet or
cardboard.
3. Assembly of this product may require more than one person.
4. Selectalocationthatisnotsusceptibletomoisture,dustandisawayfromhightrafclocationsandthings
thatmanycatchreorblockopeningssuchasdrapes,pillows,furnitureetc.
5. It is strongly recommended that the screws be screwed into the wall studs where possible. If the wall studs
cannot be used, wall anchors must be used.
CAUTION: Enclosed wall anchors (BB) only can be use on the concrete wall.
6. Forthebesteffectinstallthereplaceoutofdirectsunlightandawayfromoverheadlighting.
Tools Required
Site Selection
Philips Screwdriver Hand Drill Hex Key
5
ASSEMBLY INSTRUCTIONS
WARNING: This appliance is hot when in use. To avoid
burns, DO NOT let bare skin touch hot surfaces. Keep
combustible material, such as furniture, pillows, bedding,
papers, clothes and curtains, at least 3 feet from the front of
the heater and keep them away from the side and rear.
Minimum clearance of the replace to the adjacent wall
Sides ------------------------------- 2 inch / 5 cm
Floor ------------------------------- 6 inch / 15 cm
Top ------------------------------- 6 inch / 15 cm
Back ------------------------------- 0 inch / 0 cm
Select a location that is not susceptible to moisture, dust and is away from high trafc locations and things that many
catch re or block openings such as drapes, pillows, furniture etc.
Min. 2 inch
Min. 6 inch
Min. 2 inch
Parts List
Preparation
6
ASSEMBLY INSTRUCTIONS
x 1
x 1
x 1
A
C
B
Front Glass
Fireplace
Mounting Bracket
x 1
x 1
Remote Control
Acrylic Shards
D
E
A
C
D
B
E
Number of spare hardware is indicated in ( ).
Hardware Identication
BB x 4+(1)AA x 4+(1)
1.
7
ASSEMBLY INSTRUCTIONS
Assembly - Wall Mount Installation
2.
Remove mounting bracket (C) from back of replace (B) by unscrew two screws at the top
of the unit.
Minimum distance
between the object:
21 inch
C
B
Choose a wall location to attach the mounting bracket (C). Position the mounting bracket
(C) in the desired location. Use a level to align the bracket and mark the four holes with a
pencil.
C
8
ASSEMBLY INSTRUCTIONS
Assembly - Wall Mount Installation
4.
3.
Hang the fireplace (B) on the hooks at bottom of mounting bracket (C) and push the
replace (B) into mounting bracket (C). Re-fasten the two screws removed in Step 1.
Select the hardware appropriate for mounting bracket installation.
STUD WALL
• Secure the mounting bracket (C) to wall using screws (AA) at marked stud locations.
DRYWALL
• Drill holes at marked locations and secure the mounting bracket (C) to the wall with toggle
bolts and washers (not included).
CONCRETE WALL
• Drill 5/16-inch holes at marked locations, then insert wall anchors (BB) into holes. Secure
the mounting bracket (C) to wall using screws (AA).
STUD WALL DRYWALL CONCRETE WALL
C
C C
AA BB
AA
Assembly - Wall Mount Installation
9
ASSEMBLY INSTRUCTIONS
5.
Distribute the Acrylic Shards (E) evenly in the tray of the replace (B).
E
10
ASSEMBLY INSTRUCTIONS
Assembly - Wall Mount Installation
6.
Hang the front glass (A) on the hooks at both side of replace (B), lock the front glass (A)
by closing the latches on both side as illustrated below.
AA
C
C
Indice
Lingue:
Altri manuali komodo Camino da interno
komodo
komodo SP5749 Manuale utente
komodo
komodo SP5735 Manuale utente
komodo
komodo SP5720 Manuale utente
komodo
komodo SP5741 Manuale utente
komodo
komodo SP5721 Manuale utente
komodo
komodo SP5744 Manuale utente
komodo
komodo SP5740 Manuale utente
komodo
komodo SP5738 Manuale utente
komodo
komodo SP5728 Manuale utente
komodo
komodo SP5747 Manuale utente
komodo
komodo SP5540 Manuale utente
komodo
komodo ALPINE 399-6112-0 Manuale utente
komodo
komodo SP5718 Manuale utente
komodo
komodo SP5729 Manuale utente
komodo
komodo SP5734 Manuale utente
komodo
komodo SP5545 Manuale utente
komodo
komodo SP5736 Manuale utente
komodo
komodo SP5542 Manuale utente
komodo
komodo SP5726 Manuale utente
komodo
komodo SP5719 Manuale utente
