Kova F766C52E101TS-PT Guida alla configurazione
Install
Instructions
Appliance Name:
30” Digital Electric Range
Part Number:
F766C52E101TS-PT
Read these instructions completely and carefully. Save these instructions for
local inspector’s use. Observe all governing codes and ordinances.
Note to Installer – Be sure to leave these instructions with the Consumer.
Keep these instructions for future reference. Product failure due to improper
installation is not covered under warranty agreement.
30" Electric Free-
Standing Range
Cuisinière électrique
autoportante de 30"
IMPORTANT SAFETY INSTRUCTIONS
Carefully read the important information regarding installation, safety and
maintenance. Keep these instructions for future reference.
INSTRUCTIONS IMPORTANTES DE SÉCURITÉ
Lire attentivement l’importante information concernant la sécurité,
l’installation et l’entretien. Conserver ces instructions pour référence future.
MAAN2203-01
Instalation Instructions
Instructions d'installation
2
Range Safety
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual
and on your appliance. Always read and obey all safety messages.
DANGER
WARNING
CAUTION
This is the safety alert symbol.
This symbol alerts you to potential hazards that can
kill or hurt you and others. All safety messages will
follow the safety alert symbol and either the word
“DANGER,” “WARNING” or “CAUTION.”
These words mean:
An imminently hazardous situation. You
could be killed or seriously injured if
you don’t immediately follow instructions.
A potentially hazardous situation which, if
not avoided, could result
in death or serious bodily injury.
A potentially hazardous situation
which, if not avoided, may result
in moderate or minor injury.
All safety messages will tell you what the potential hazard is, tell
you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Tip Over Hazard
WARNING
3
State of California Proposition 65 Warnings:
WARNING: This product contains one or more chemicals known to
the State of California to cause cancer.
WARNING: This product contains one or more chemicals known to
the State of California to cause birth defects or other reproductive
harm.
A child or adult can tip the range and be killed.
Connect anti-tip bracket to rear range foot.
Reconnect the anti-tip bracket, if the range is moved.
Failure to follow these instructions can result in death or serious
burns to children and adults.
Range Safety
4
TOOLS AND PARTS
Gather the required tools and parts before starting installation. Read and follow
the instructions provided with any tools listed here.
TOOLS NEEDED
•Tape Measure
•Flat-Blade Screwdriver
•Phillips Screwdriver
•Level
•Cordless Electric Drill
•Hammer
•Wrench or Pliers
•Metal Saw
•Metal Snips or Large Wire Cutters
•15/N6" Combination Wrench
•3/8" Nut Driver
•1/4" Nut Driver
•1/8" (3.2 mm) Drill Bit (for wood oors)
•Marker or Pencil
•Masking Tape
PARTS SUPPLIED
Check that all parts are included.
a
b
a 16 x 15/8" Screws (2)
b Anti-tip Bracket
NOTE: The Anti-tip bracket must be securely mounted to the suboor.
The thickness of ooring may require longer screws to anchor bracket to
suboor. Longer screws are available from your local hardware store.
PARTS NEEDED
If using a power supply cord:
•A UL listed power supply cord kit marked for use with ranges. The cord should
be rated at 250 volts minimum, 40 amps or 50 amps that is marked for
use with nominal 13/8" (3.5 cm) diameter connection opening and must
end in ring terminals or open-end spade terminals with upturned ends.
•A UL listed strain relief.
If direct wiring:
•Flexible Metal Conduit
•UL Listed Conduit Connector
•4- ire or 3- ire Electrical Cable (where local codes permit a 3-wire connection).
•UL Listed Wire Connectors
Check local codes. Check existing electrical supply. See the appropriate
“Electrical Requirements” section. It is recommended that all electrical
connections be made by a licensed, qualied electrical installer.
Installation Requirements
5
LOCATION REQUIREMENTS
VENTILATION
IMPORTANT: Observe all governing codes and ordinances.
•It is the installer’s responsibility to comply with installation clearances, if
specified, on the model/serial rating plate. The model/serial rating plate is
located on the left-hand side of the oven frame. Open oven door to view
label. See label on back panel of range for additional element and oven
power ratings.
a
a Rating Plate
TEMPERATURE
IMPORTANT: Some cabinet and building materials are not designed to
withstand the heat produced by the oven for baking and self-cleaning. Check
with your builder or cabinet supplier to make sure that the materials used will
not discolor, delaminate or sustain other damage.
•Contact a qualified floor covering installer to check that the floor covering
can withstand at least 200°F (93°C).
•Use an insulated pad or 1/4" (0.64 cm) plywood under range if installing
range over carpeting.
GENERAL
•The range should be located for convenient use in the kitchen.
•Recessed installations must provide complete enclosure of the sides and
rear of the range.
•To eliminate the risk of burns or fire by reaching over heated surface units,
cabinet storage space located above the surface units should be avoided. If
cabinet storage is to be provided, the risk can be reduced by installing a
range hood or microwave hood combination that projects horizontally a
minimum of 5" (12.7 cm) beyond the bottom of the cabinets.
•All openings in the wall or floor where range is to be installed must be sealed.
•Do not seal the range to the side cabinets.
•Grounded electrical supply is required. See “Electrical Requirements” section.
Installation Requirements
6
DIMENSIONS
PRODUCT/OPENING
Opening dimensions shown are for 25" (64 cm) countertop depth, 24" (61 cm)
base cabinet depth and 36" (91.4 cm) countertop height.
30" (77 cm)
Min.
a
5.9" (15 cm)
Min.
b
c
ed
Dimension
a 30" (76 cm)
b 29 7/8" (76 cm)
c 25" (63.5 cm)
d 36" (91.4 cm)
e 37 3/4" (96 cm)
NOTE: Range can be raised approximately 1" (2.5 cm) by adjusting the leveling
legs. Front of door and drawer may extend farther forward depending on styling.
BACK OF RANGE
a
b
c
a Access Panel to Electrical
Supply Connection
b Power Cord Opening
c Recessed Area
Installation Requirements
7
POWER SUPPLY
IMPORTANT: To connect to an outlet in the wall, the electrical outlet must be
recessed. If the electrical outlet is in the floor, it can be either recessed or
surface mounted.
a
b
d
ce
a 30" (76 cm)
b 171/2" (44 cm)
c 71/4" (18.4 cm)
d 3" (7.6 cm)
e Recommended
Location for
Electrical Outlet
ELECTRICAL REQUIREMENTS
IMPORTANT: This appliance is manufactured with the chassis connected to the
neutral by a green ground jumper wire. Use a 3-wire, UL listed, 50-amp power
supply cord (pigtail); or if local codes do not permit ground through the neutral,
use a 4-wire power supply cord rated at 250 volts, 50 amps and intended for
use with ranges. The ground must be revised so the green ground wire of the 4-
wire power supply is connected to the chassis. See “4-Wire Connection: “Power
Supply Cord” and “Direct Wire - U.S.A. Only” “4-Wire Connection (Ungrounded
Neutral)” sections.
If codes permit and a separate ground wire is used, it is recommended that
a qualified electrical installer determine that the ground path is adequate
and wire gauge is in accordance with local codes.
To properly install your range, you must determine the type of electrical
connection you will be using and follow the instructions provided for it here.
•Range must be connected to the proper electrical voltage and frequency as
specified on the model/serial number rating plate. All models are dual rated,
and designed to be connected to either 120/208 or 120/240V AC, 60Hz, 3-
wire or 4-wire, single-phase power supply.
Voltage and
Frequency Amps Circuit Required
240V, 60 Hz 50 A 50 Amp Circuit
208V, 60 Hz 43 A 45 Amp Circuit
•When a 4-wire, single phase 120/240 volt, 60 Hz., AC only electrical
supply is available, a 50-amp maximum circuit protection is required (or, if
specified on the model/serial rating plate, when a 4-wire, single phase
120/208 volt 60 Hz., AC only electrical supply is available, a 45-amp
maximum circuit protection is required).
Installation Requirements
Indice
Lingue:
