When ready, with water supply opened and power applied to machine, for the first time only, touch
the circular button and the screen will come on and ask to perform the priming of the chemicals. As
the lines and pumps are empty, this priming is recommended but not mandatory. The chemicals will
fill and the unit will load washing water. While filling the screen will note “loading”. When full the
screen will note “heating”. Allow machine to warm to operating temperature ( 10 to 20 minutes
depending on supply water temperature).
Perform an initial programming as follows:
To see video of set-up go to https://www.youtube.com/watch?v=lad6TVQKqqs
Press gently and hold “on/off” button and “rinse” button simultaneously for 4 seconds. Display should
then change to “password”.
Password is entered by touching buttons in sequence as follows:
Down arrow (left side of screen)
Up arrow (left side of screen)
Rinse spray (right upper side of screen)
Drain (right lower side of screen pot with arrow down)
Drain (right lower side of screen pot with arrow down)
Rinse spray (right upper side of screen)
Display should then change to entry mode in numerical order as below. To advance to the next
position, touch the “Drain (Pot with arrow down)” button. There are approximately 42 positions and
if you have to go back to a previous position touch the rinse spray button. To end and save the entries,
press “on/off” button for 4 seconds. Screen should then display “standby”.
Suggested settings of program.
1. Language of display after completing entries.
2. Temperature scale C. or F. Will change if set after program is completed.
3. Autostart On or Off. “ON”determines whether the machine starts by closing the door. “OFF”
setting requires a touch to the “START”button after closing door
4. Automatic priming of detergent chemical line. Only the first time the machine is installed.
5. Automatic priming of Rinse Aid chemical line. Only the first time the machine is installed.
6. General prime loading of wash detergent in wash water. Suggestion set to 40.
7. General prime loading of Rinse Aid in rinse line water. Suggestion set to 45.
8. Program 1, Booster temperature setting. 87C
9. Program 1, Wash Tank temperature setting. 64C
10. Program 1, Detergent load time. 15’may be adjusted to local requirements.
11. Program 1, Rinse Aid load time. 19’may be adjusted to local requirements.
12. Program 2, Booster set. 87C
13. Program 2, Wash Tank set. 64C
14. Program 2, Detergent load time. 15’ may be adjusted to local requirements.
15. Program 2, Rinse Aid load time. 19’ may be adjusted to local requirements.
16. Program 3, Booster set. 87C
