Programming Instructions Powerbolt 2 Touchpad Keyless Entry
2
Step 2:
Set locking and unlocking direction
1. Make sure the door is open and in the unlocked position.
2. Press 0 –0 –0 –0 – – 00 –
Note: Each button represents two numbers (i.e. ONLY push the button once for 0). If
you incorrectly enter the code, wait 10 seconds until you hear three beeps. Then you
can try again.
You may or may not see your keypad light up
orange during this step. Either way, complete the
step.
TIP
3. If the step was completed correctly, the latch bolt will extend out and retract back in
completely.
The lock will also beep twice and the keypad will
flash Green when the step is successful.
TIP
Step 2:
Set locking and unlocking direction
