
Page 2
Carbon Monoxide Hazard
This product burns gas to produce heat. The
appliance must be properly installed, operated, and
maintained to avoid exposure to appreciable levels
of carbon monoxide and the installer is required to
conrm that at least one carbon monoxide alarm is
installed in the living space before the appliance is put
into operation.
It is important for carbon monoxide alarms to be
installed, maintained, and replaced following the alarm
manufacturer’s instructions and applicable local codes.
Should overheating occur or the gas supply fail to
shut o, do not turn o or disconnect the electrical
supply to the pump. Instead, shut o the gas supply
at a location external to the appliance.
Do not use this heater if any part has been under
water. Immediately call a qualied service technician
or Gas Company personnel to inspect the site.
Heater replacement is recommended.
AVERTISSEMENT
Danger lié au monoxyde de carbone
Ce produit brûle des gaz pour produire de la chaleur.
L’appareil requiert une installation, un fonctionnement
et une maintenance adéquates an d’éviter l’exposition
à des niveaux appréciables de monoxyde de carbone;
l’installateur est requis de conrmer qu’au moins une
alarme de détection de monoxyde de carbone est
installée dans l’espace de vie avant que l’appareil ne
soit mis en service.
Il importe que les alarmes de détection de monoxyde
de carbone soient installées, maintenues et remplacées
selon les directives du manufacturier et les codes
locaux applicables.
LAARS Heating Systems
A. General Care
Your MightyTherm will require very little Mainte-
nance. However, as with any ne appliance there are
certain steps that should be taken to ensure continu-
ing optimum performance.
Keep the area around the MightyTherm clean
and free from combustible materials, gasoline and
other ammable liquids and vapors.
The MightyTherm must be completely isolated
and protected from any source of corrosive chemical
fumes such as trichlorethylene, perchlorethylene,
chlorine, etc.
Keep grille openings on the boiler free for proper
ventilation of interior components.
Do not obstruct or block a free ow of air to the
boiler to ensure proper ventilation.
If desired, clean the jacket surfaces with a
damp cloth and mild detergent. Do not use ammable
cleaning materials.
If sidewall vented, keep the vent terminal clear
of obstructions — do not pile snow against the vent
terminal. Clean the air lter(s) often, and then develop
an appropriate maintenance schedule.
B. Annual Inspection of Flue and Vents
Visually inspect the vent pipe once a year.
Should any deterioration exist, have the aected parts
replaced by a qualied service person.
C. D.