LanReady Technologies WDR2000 Manuale utente
1
IEEE802.11 b/g Outdoor
AP/Bridge
（Support IEEE802.11a Client Backhaul）
WDR2000
User’s Manual
Version 1.2
2
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate this
equipment.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
FCC ID：SCD0059
3
Table of Contents
Table of Contents...........................................................................................................3
Package Contents...........................................................................................................5
Hardware Setup..............................................................................................................5
Ethernet & RS-232 Console Connector:................................................................5
PSE BOX : for Power Over Ethernet (POE) .........................................................6
Minimum System Requirements....................................................................................7
Introduction....................................................................................................................7
Features and Benefits.............................................................................................8
Four Operational Modes................................................................................................9
AP Mode................................................................................................................9
Repeater Mode.....................................................................................................10
Point to Point Mode.............................................................................................10
Point to Multi Point Mode ...................................................................................11
Using the Configuration Menu ....................................................................................11
Device IP Setting ÆEthernet..............................................................................13
AP Setting --> Wireless0 or Wireless1 ................................................................14
Encryption............................................................................................................18
Set Encryption to Open System...................................................................19
Set Encryption to Shared Key......................................................................19
Set Encryption to Open System/Shared Key...............................................20
Set Encryption to WPA-PSK .......................................................................20
Set Encryption to WPA-Enterprise(802.1x).................................................20
Point to Point Mode Setting ÆWireless0 or Wireless1......................................21
Point to Multi Point Mode Setting ÆWireless0 or Wireless1............................22
Repeater Mode Setting ÆWireless0 or Wireless1..............................................24
Dual Radio Setting For Simultaneous Operation.................................................25
AP and Bridge..............................................................................................25
AP and AP....................................................................................................25
Bridge and Bridge........................................................................................25
DHCP Server Setting ÆDHCP...................................................................................26
WAN Setting ÆWAN ...............................................................................................28
WAN Status ÆWAN Status........................................................................................30
Admin setting ÆAdmin..............................................................................................31
4
Firewall setting ÆFirewall .........................................................................................33
Virtual Server setting ÆVirtual Server.......................................................................36
Connection Status ........................................................................................................37
Firmware upgrade ÆUpgrade ....................................................................................38
Reset System ÆReset.................................................................................................39
5
Package Contents
The standard package of the system includes:
zWireless-G Outdoor AP/Bridge x 1
zPSE BOX x 1
zArrester x 2
zRF Cable x 2
zEthernet cable x 2
zConsole cable x 1
zAC Power cable x1
zAccessories package x1
zCD-ROM x 1
Note: Using a power supply with a different voltage than the one
included with the Outdoor Bridge will cause damage and void the
warranty for this product.
Hardware Setup
Ethernet & RS-232 Console Connector:
Console Port --- It is used for initial setup and configuration of the device
LAN Port --- It is used for connecting the enclosed PSE for Power Over Ethernet
Ethernet RJ-45 Connector
(
LAN
)
Ethernet RJ-45 Connector
(
WAN
)
Console Port Connector
6
WAN Port --- It used for connecting to ADSL for ISP
PSE BOX : for Power Over Ethernet (POE)
Power Over Ethernet :
RJ-45 cable connecter PSE BOX
(POWER &DATA OUT port) and
Wireless-G Outdoor AP/Bridge WAN or
LAN E
t
h
e
rn
et
P
o
r
t
Power LED
Link Active LED
PSE BOX
A
C Power cable
7
Minimum System Requirements
Computers with Windows, Macintosh, or Linux-based operating systems
with an installed Ethernet Adapter
Internet Explorer version 6.0 or Netscape Navigator version 7.0 and above
Introduction
The OUTDOOR BRIDGE covers a large operating distance, providing an
802.11a/b/g outdoor WLAN which enables users to access the Internet or an
organization’s network.
At up to five times the speed of previous wireless devices, you can work faster
and more efficiently, increasing productivity. With the OUTDOOR BRIDGE,
bandwidth-intensive applications like graphics or multimedia will benefit
significantly because large files are able to move across the network quickly.
TheOUTDOOR BRIDGE features a die-cast watertight housing and a built-in
lightning protector to protect the access point from harsh environmental
conditions, including extreme variance in temperature. It also includes Power
over Ethernet (POE) and a unique outdoor remote-mounted design for easy
installation. With two mounting kits, you have the option of either pole or wall
mounting.
The OUTDOOR BRIDGE is suitable for manufacturing plants, industrial sites,
military bases, universities, hotels, airports and golf courses.
The OUTDOOR BRIDGE has Dual Radio functionality for simultaneous AP
and Bridge operations for backhaul applications.
Configurable in four different modes (access point, bridge, multi-point bridge,
and wireless client), the OUTDOOR BRIDGE offers 128-bit encryption, WPA
and 802.1X authentication when used with a RADIUS server, MAC address
access control, and additional security features.
8
Features and Benefits
Features the benefit of Robust Outdoor Housing - Designed for harsh
outdoor environments, with die-cast, watertight housing, built-in heater and
temperature sensor
High Performance Dual Radio usage for simultaneous operations of AP and
Bridge for backhaul applications. The dual radio can be configures for AP
and Bridge ; AP and AP ; Bridge and Bridge for various applications
Features the benefits of repeating up to 6 MAC ID for each radio, therefore
ability to repeat up to 12 MAC ID with dual radio functionality for great
coverage and benefits
4 Different Operation modes with WDS (Wireless Distribution System) –
Capable of operating in one of four different operation modes to meet your
wireless networking requirements: access point (AP), Point-to-Point (PtP)
bridge, Point-to-multipoint (PtMP) bridge, Repeater.
Embedded DHCP Server automatically assigns IP addresses to wireless
clients.
Connect networks in different buildings when used in conjunction with
high-gain outdoor antennas.
Easy Installation with PoE.
Compatible with IEEE802.11g standards to provide a wireless data rate of
up to 54Mbps.*
Backward compatible with the 802.11b standard to provide a wireless
data rate of up to 11Mbps with 802.11b devices - that means you can migrate
your system to the 802.11g standard on your own schedule without sacrificing
connectivity.
Better security with WPA and 802.1X- The OUTDOOR BRIDGE can
securely connect to wireless clients on the network using WPA (Wi-Fi
Protected Access) providing a much higher level of security for your data and
communications than has previously been available. In conjunction with a
RADIUS server, 802.1X authentication verifies the identity of would-be clients.
Communicate between IEEE802.11b and IEEE802.11g bands - Optional
configuration allows communication between bands.
Two mounting kits - Gives you the flexibility of either wall or pole outdoor
mounting.
9
Four Operational Modes
AP Mode
AP Mode
Cable/ADSL Modem
Eth WAN Port
Wireless
Internet
10
Repeater Mode
Point to Point Mode
Repeater Mode
Access Point
Repeater1
Repeater2 Wireless Client
Point to Point (P2P : Wireless Bridge) Mode
L2 Switch L2 Switch
P2P-1 P2P-2
LAN1 LAN2
Wired Network Wired Network
Indice
Manuali Hardware di rete popolari di altre marche
Matrix Switch Corporation
Matrix Switch Corporation MSC-HD161DEL Manuale utente
B&B Electronics
B&B Electronics ZXT9-IO-222R2 Manuale utente
Yudor
Yudor YDS-16 Manuale utente
D-Link
D-Link ShareCenter DNS-320L Manuale utente
Samsung
Samsung ES1642dc Istruzioni per l’uso
Honeywell Home
Honeywell Home LTEM-PV Istruzioni per il montaggio
