Larson Electronics EPL-LED-2X150W-RT Manuale utente

EPL-LED-2X150W-RT

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

1of 2

Explosion Proof 300 Watt LED Flood Light Fixture

Paint Spray Booth Approved

Instruction Manual

This explosion prooflightis designed for illumination of industrial locations. It uses the latest in

solidstate lighting technology forlong life, low maintenance and high efficiency.

The unique design focuses the light where itis needed, giving improved efficiency over a

conventional HIDluminaire.

An internal, universal input, power-factor-corrected switch-mode supplyallowsit to be used from

any nominal100-277V AC 50/60 Hz power supplywithout any variation in light output. We also

offer a low voltage 11-25V DC version of this light fixture as an option.

WARNING

To avoidthe risk of fire,explosion or electric shock, thisproduct should be installed, inspected

and maintained by a qualified electricianonly, in accordancewith all applicableelectrical codes.

To avoidelectric shock:

•Be certain electrical power is OFF before and during installation and maintenance.

•Luminaire must be connected to a wiring system with an equipment-grounding conductor.

To avoid explosion:

•Make sure the supply voltage is within the luminaires’ voltage rating.

•Ensure the marked T rating is less than the ignition temperature of the Hazardous

Atmosphere.

•Do not operate in ambient temperatures above those indicated on the luminaire nameplate.

•Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.

For supplyconnections, use wire rated for at least 110°

C Recommendedmounting height is 15-40 feet.

MOUNTING

This fixture offers an adjustable swivel mounting system that allows itto be mounted to any

flat surface including walls and ceilings. Three heavydutybolts are used to mount the fixture to the

surface through pre-drilled holes on mount. Hole diameter is.563”. Fixture is heavy- two people and

capable equipment are required for hanging fixture. An optional pendant mount is also included with

this fixture, which screws into the 3/4'' NPT hub on the back of the fixture.

Fixture angle can be adjusted by loosening the set screws on either side of mount. Swap outer bolts

to move mount in opposite direction. Keep center bolt in place! Otherwise fixture will free from

mount.

Use appropriate wiring methods for the areafollowing all NEC, local, and state electrical codes.

Conduit attaches to the junction box on the back for wiring.

ADJUSTMENT BOLTs

CENTER BOLT

ONLY LOOSEN

DO NOT REMOVE COMPLETELY

WHILE MOUNTED TO SURFACE

EPL-LED-2X150W-RT

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

2of 2

WIRING (see attached wiring diagram)

This unit comes preconfigured in selected voltage,beam angle, and color temp. Wire light via

junction box on the back to thecorrect voltage. Follow applicable local and/or National Electrical

Code for the hazardous area. Voltage: 100-277 Volts AC, 50/60Hz or 11-25 Volts AC/DC based

on model selected.

MAINTENANCE

Caution: To avoid personal injury, disconnect power to the light and allow the unit to cool

down before performing maintenance.

Warning: No user serviceable parts inside of fixture. Risk of electric shock. Removal of the lens

will void the warranty.

1. Perform visual, mechanical and electrical inspections on a regular basis. We recommend

routine checks to be made on a yearly basis. Frequency of use and environment should

determine this. It is recommended to follow an Electrical Preventive Maintenance Program

as described in NFPA 70B: Recommended practice for Electrical Equipment.

2. The lens should be cleaned periodically as needed to ensure continued photometric

performance. Clean the lens with a damp, non-abrasive, lint-free cloth. If not sufficient, use

mild soap or a liquid cleaner.

3. Inspect the cooking fins on the luminaire to ensure that they are free of any obstructions

or contamination (i.e. excessive dust build-up). Clean with a non-abrasive cloth if

needed.

4. Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.

WARRANTY

Should further information not covered by these instructions be required, please contact Larson Electronics at

1-800-369-6671 or sales@larsonelectronics.com for further assistance.

Please visit LarsonElectronics.com for Warranty and Return information.

WARNING: CHECK NAMEPLATE

FOR PROPER VOLTAGE. DAMAGE

FROM IMPROPER VOLTAGE WILL

VOID WARRANTY.

Indice

Altri manuali Larson Electronics Proiettore

Larson Electronics

Larson Electronics WAL-QP-4X500-25 Manuale utente

Larson Electronics

Larson Electronics HAL-LED-174W Manuale utente

Larson Electronics

Larson Electronics EPL-LED-150W-RT-JB2-X24V-75C-24W07 Manuale utente

Larson Electronics

Larson Electronics EPL-LED-150W-RT-20-HDBC Manuale utente

Larson Electronics

Larson Electronics LEDWP-720 Manuale utente

Larson Electronics

Larson Electronics EPLC2-WPLED-50W-RT Manuale utente

Larson Electronics

Larson Electronics EPL-LED-150W-RT-DIMM Manuale utente

Larson Electronics

Larson Electronics EPLC2-LED-150W-RT-DIMM Manuale utente

Larson Electronics

Larson Electronics HAL-TRN Series Manuale utente

Larson Electronics

Larson Electronics RCL200-RF Manuale utente

Larson Electronics

Larson Electronics EPLC2-LED-150W-RT-JB2-25C Manuale utente

Larson Electronics

Larson Electronics LEDWP-600E-SSB-1227-56K Manuale utente

Larson Electronics

Larson Electronics Golight RadioRay 7901 Manuale

Larson Electronics

Larson Electronics BL24-LED Manuale utente

Larson Electronics

Larson Electronics RL-16-LED-M Manuale utente

Larson Electronics

Larson Electronics LEDWP-LP-450-KNL-DCM Manuale utente

Larson Electronics

Larson Electronics EPLC2-LED-150W-RT-JB2-50C Manuale utente

Larson Electronics

Larson Electronics EPLC2-LED-150W-RT-JB2 Manuale utente

Larson Electronics

Larson Electronics EPL-WPLED-150W-RT-140DB Manuale utente

Larson Electronics

Larson Electronics HID-22-SL-3M-GAP Manuale utente

Larson Electronics

Larson Electronics WAL-QP-2X-25 Manuale utente

Larson Electronics

Larson Electronics LEDWP-LP-450-TRN-DCM Manuale utente

Larson Electronics

Larson Electronics GL-4600-F-M-12I Manuale

Larson Electronics

Larson Electronics RT-100C-XEMG-10C Manuale utente

Manuali Proiettore popolari di altre marche

VIZULO

VIZULO Micro Martin Guida utente

EuroLite

EuroLite LED IP FL-100 SMD Manuale utente

Cooper Wheelock

Cooper Wheelock XB12 Manuale utente

Allen + Roth

Allen + Roth 17624-000 Manuale utente

ADJ

ADJ 4 STAGE PAK Manuale utente

Cooper Lighting

Cooper Lighting EGL91SW233 Manuale utente

Max

Max 37496 Manuale utente

BEGA

BEGA 85 143 Manuale utente

Beamz

Beamz 151.226 Manuale utente

EuroLite

EuroLite LED IP FL-8 Manuale utente

Ledj

Ledj PERFORMER 36 RGB Manuale utente

Perel

Perel ELS3 Manuale utente

Perel

Perel ELS3WD Manuale utente

LumX

LumX LM 36130 Manuale utente

Xtricity

Xtricity 4-80053 Manuale utente

Stahl

Stahl 6521/4 Series Manuale utente

Ecosense

Ecosense EcoSpec Manuale utente

Ayrton

Ayrton minipanel FX Manuale utente