Larson Electronics EPL-LP-48W-LED Manuale

EPL-LP-48W-LED

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

1of 2

EPL-LP-48W-LED Instruction Guide

Explosion Proof 48 Watt Low Profile LED Light Fixture

Thank you for your purchase of the Larson Electronics EPL-LP-48W-LED series LED light. This light is completely

assembled, tested and ready for installation when shipped from the factory. Please follow the steps below in order to

operate and maintain this product.

IMPORTANT

READ CAREFULLY BEFORE OPERATING THIS LIGHT. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. IF UNSURE

ABOUT ANY PART OF THESE INSTRUCTIONS, CONSULT A QUALIFIED ELECTRICAL PROFESSIONAL. THE EPL-LPBS-70LED

MUST BE OPERATED IN ACCORDANCE WITH NATIONAL ELECTRICAL CODE AND ALL APPLICABLE LOCAL CODES. PROPER

GROUNDING IS REQUIRED FOR SAFETY.

FOR PERSONAL SAFETY, ALWAYS CONFIRM THE RATING OF ANY KNOWN HAZARDOUS OR POTENTIALLY HAZARDOUS

LOCATION WHERE THE LIGHT IS TO BE USED.

WARNING: OPERATE ONLY AT THE VOLTAGE LISTED ON THE PRODUCT LABEL.

WARNING: TO PREVENT IGNITION OF A HAZARDOUS ATMOSPHERE, THE SUPPLY CIRCUIT SHOULD BE DISCONNECTED

WHEN INSTALLING OR PERFORMING ANY MAINTENANCE ON THIS UNIT.

WARNING: WHEN INSTALLING THIS LIGHT IN HAZARDOUS LOCATIONS, CHECK THE OPERATING TEMPERATURE LIMITS

PRIOR TO INSTALLATION TO BE SURE IT CONFIRMS TO THE ENVIRONMENTAL TEMPERATURE RESTRICTIONS AND NEC

CLASSIFICATIONS. CHECK THE FIXTURE’S METAL NAMEPLATE FOR TEMPERATURE (T) RATINGS.

WARNING: DO NOT SCRATCH OR CHIP THE FRONT LENS. TURN THE POWER OFF BEFORE STARTING INSTALLATION OR

REPAIR.

WARNING: OPERATE THIS FIXTURE ONLY AT THE VOLTAGE OF YOUR SPECIFIC SUPPLY CIRCUIT. FAILURE TO DO SO

WILL RESULT IN DAMAGE TO THE FIXTURE.

WARNING: SUBSTITUTE COMPONENTS MAY IMPAIR EXPLOSION PROOF SAFETY.

INSTALLATION

Before operation, confirm that the power source will provide the correct voltage

indicated on the product nameplate.

Check product nameplate for Ratings and Approvals.

Place the light in the desired location and run its power cord to a power source.

Ensure all safety requirements are followed for the hazardous area. If longer

lengths of cables are required a minimum of 18awg (1.5mm diameter) is required.

General Mounting

For maximum long term reliability and light output, the light must be installed in free air. Pendant mount through ¾” NPT

on back of light following all applicable codes for the area.

For maximum long term reliability and light output, the light must be installed in free air.

The Area Light series luminaire fixture design incorporates an over-temperature control circuit that reduces input power

should internal temperatures reach a maximum level. As a result, light output may be reduced.

An internal power-factor-corrected supply allows it to be used from any nominal 100V 277V, 50/60Hz single phase AC

supply without any variation in light output.

Voltage: 100-277V AC 50/60Hz

It is recommended that to ensure moisture does not flow through the cable a loop

in the cord should be implemented where possible during installation. If this is not

practical for the install than necessary precautions should be taken to prevent

moisture entering the conduit thus entering the fixture.

Recommended mounting height: 8 feet to 24 feet (2.4 m to 7.3 m)

This light is instant-on and will illuminate once energized.

WIRE(AC)

WIRE(DC)

COLOURED CABLE

AC LIVE

DC LIVE

BLACK

AC NEUTRAL

DCNEUTRAL

WHITE

GROUND

GREEN

EPL-LP-48W-LED

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

2of 2

MAINTENANCE

To avoid personal injury, disconnect power to the light and allow the unit to cool down before performing maintenance.

WARNING:

Risk of electric shock. Removal of the lens will void the warranty.

Perform visual, mechanical and electrical inspections on a regular basis. We recommend routine checks to be made on

a yearly basis. Frequency of use and environment should determine this. It is recommended to follow an Electrical

Preventive Maintenance Program as described in NFPA 70B: Recommended Practice for Electrical Equipment.

The lens should be cleaned periodically as needed to ensure continued photometric performance. Clean the lens with a

damp, non-abrasive, lint-free cloth. If not sufficient, use mild soap or a liquid cleaner.

Do not operate if the lens is cracked or damaged. All fasteners should be properly seated

This LED Luminaire should require a minimum amount of maintenance. If any unforeseen repairs are required then

always observe explosion protection regulations and requirements.

WARNING:

This LED Luminaire should not require any electrical maintenance. Never open the luminaire (other than the junction

box lid if supplied); there are no user- serviceable parts inside.

Inspection

Within the scope of a maintenance or inspection routine the following should be included: protective hoses covering the

connection cables. Cable entries must be free of corrosion. Perform visual mechanical and electrical inspections on a

regular basis. We recommend routine checks to be made on a yearly basis. Frequency of use and environment should

determine this. It is recommended to follow an Electrical Preventive Maintenance Program as described in NFPA 70B:

Recommended Practice for Electrical Equipment

The lens should be cleaned periodically, as needed, to ensure continued photometric performance. Clean the lens with

a damp, non-abrasive, and lint- free cloth. If not sufficient, use mild soap or a liquid cleaner. Do not use and abrasive,

strong alkaline, or acid cleaners as damage may occur.

Inspect the cooling fins on the luminaire to ensure that they are free of any obstructions or contamination (i.e. excessive

dust build-up). Clean with a non-abrasive, damp cloth, if needed.

The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire

shall be replaced.

THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR

INSTALLATION REQUIREMENTS. SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE

REQUIRED, PLEASE CONTACT LARSON ELECTRONICS AT

1-800-369-6671 FOR FURTHER ASSISTANCE.

PLEASE VISIT LARSONELECTRONICS.COM FOR WARRANTY AND RETURN INFORMATION.

Indice

Altri manuali Larson Electronics Apparecchio di illuminazione

Larson Electronics

Larson Electronics HALD-24-1X150LED-V3-DIMM Manuale utente

Larson Electronics

Larson Electronics IND-HR-UVC-EXS-R1-24-3L-120V-2X Manuale utente

Larson Electronics

Larson Electronics GVP-48-2L-LED-D-LV Manuale utente

Larson Electronics

Larson Electronics EPL-MBC-1MLED-2023 Manuale

Larson Electronics

Larson Electronics EPL-QP-1X150-100 Manuale utente

Larson Electronics

Larson Electronics EPLC-48-432 Manuale utente

Larson Electronics

Larson Electronics GAU-HB-12L-LED-WP-WCM Manuale utente

Larson Electronics

Larson Electronics EPL-PM-1X30LED-120XLV-100 Manuale

Larson Electronics

Larson Electronics EPL-EMG-HB-50LED-RT-WLM Manuale utente

Larson Electronics

Larson Electronics EPLC2-24-50LED Manuale utente

Larson Electronics

Larson Electronics EPLC2-LED-400W Manuale utente

Larson Electronics

Larson Electronics SPLT-1.59K-800A-30-4X100W-LED-MS Manuale utente

Larson Electronics

Larson Electronics EPLC2-BS-70LED-100 Manuale

Larson Electronics

Larson Electronics ATEX-EHL-1123-LED-50-EPP Manuale utente

Larson Electronics

Larson Electronics WAL-QP-4XWP60E-25-1227 Manuale utente

Larson Electronics

Larson Electronics LEDWP-600E-E2E-10C Manuale utente

Larson Electronics

Larson Electronics EPL-WPLED-100W-RT-DIMM Manuale utente

Larson Electronics

Larson Electronics EPL-LP-70W-LED-WALL Manuale

Larson Electronics

Larson Electronics HAL-PT-LED-CPR-C-100 Manuale utente

Larson Electronics

Larson Electronics LED25WRE-LENSCOVER Manuale utente

Larson Electronics

Larson Electronics EPL-HB-100LED-RT-JB2-6-EPP Manuale utente

Larson Electronics

Larson Electronics EPL-HB-100LED-RT-ASM-JB2-40C-BCE Manuale utente

Larson Electronics

Larson Electronics EPLC2-LB-40LED-RT-CM Manuale utente

Larson Electronics

Larson Electronics EPL-AMB-150LED-250 Manuale utente

Manuali Apparecchio di illuminazione popolari di altre marche

Emos

Emos CLASSIC ZY1431T Manuale utente

Westinghouse

Westinghouse Outdoor Lighting Fixture Manuale utente

Hedler

Hedler C 12 silent Manuale utente

Blizzard Lighting

Blizzard Lighting Puck: CSI Manuale utente

Energetic Lighting

Energetic Lighting ELYSL-5004 Series Manuale utente

Lightmaxx

Lightmaxx Shaft 5R Manuale utente

Triarch

Triarch 31083 Manuale utente

Philips

Philips 32614 Series Manuale utente

IKEA

IKEA TIVED Manuale utente

Lightolier

Lightolier LP200 Manuale utente

Chauvet Professional

Chauvet Professional ROGUE R1 BEAM WASH Manuale utente

Martin

Martin MAC 250 Krypton Manuale utente

Cooper Lighting

Cooper Lighting Halo L3232E Manuale utente

Stageline

Stageline ODW-2410RGBW Manuale utente

Light Sky

Light Sky Tornado Series Manuale utente

Lightolier

Lightolier Paralyte 2424 PLA2G9LS26U Manuale utente

Lightolier

Lightolier Lytespan 83ED17S Manuale utente

Lightolier

Lightolier Calculite CS8226 Manuale utente