INTRODUCTION
Thank you for purchasing this
Lec appliance that has been made
from the very best materials
available and has been
extensively tested and inspected
before leaving our factory. This
Bottle Cooler has been
specifically designed to store
bottled and canned drinks and
when properly installed and cared
for, will give years of good
service.
UNPACKING
Please remove all internal
packing. When unpacked is
complete the appliance should
stand for 2 hours to allow coolant
to settle.
POSITIONING
In order to conserve electricity do
not put your appliance near a
source of heat, such as a
radiator. Try to avoid locations
where the sun shining through
glass can raise the room
temperature.
An unheated location such as a
cellar is undesirable as it may
cause frost build up and slow
defrosting. It may also cause
excessive condensation on the
outer surface of your cabinet.
INSTALLATION
It is important to note that the
appliance can be installed
built-in, without air gaps as the
appliance has been designed to
gain ventilation from the front.
The air ventilation at the bottom
of the cabinet must be
unobstructed to allow air to
circulate around the cabinet. The
Bottle Cooler is also fitted with
adjustable feet on the front. If the
cabinet is placed on an uneven
surface this can cause
misalignment of the cabinet and
doors. The feet must be adjusted
so that the cabinet stands firm
and level, with a slight tilt from
front to back to prevent any
defrost water dripping from the
front. The cabinet should be
placed on a hard flat surface for
ventilation.
WHAT TO DO BEFORE
STARTING
Clean the interior of your
appliance (See the section
"Cleaning your Appliance").
SAFETY AND SERVICING
THIS APPLIANCE MUST BE
EARTHED
If this appliance is fitted
with a non-rewirable plug
for which your socket is
unsuitable the plug should
be cut off and an
appropriate plug fitted.
The removed plug must be
disposed of as insertion of
the plug into an electrical
socket is likely to be
dangerous.
ELECTRIC PLUG WIRING (UK
ONLY)
The wires in the mains lead are
coloured in accordance with the
following code:
GREEN AND YELLOW - EARTH
BLUE - NEUTRAL
BROWN - LIVE
As the colours of the wires in the
mains lead of your appliance may
not correspond with the coloured
marking identifying the terminals
in your plug, proceed as follows:
CONNECT GREEN & YELLOW
coloured wire to plug terminal
marked ‘E’ or earth symbol or
coloured green or green and
yellow.
CONNECT BLUE coloured wire to
plug terminal marked ‘N’ or
coloured black.
CONNECT BROWN coloured wire
to plug terminal marked ‘L’ or
coloured red.
Do not push excess mains lead
into the compressor
compartment.
If it is necessary to change the
fuse in a moulded plug and the
fuse cover is detachable, it must
be refitted after the fuse has
been changed. If the fuse cover is
lost or damaged the plug must
not be used until a replacement
is obtained.
It is important that the colour of
the replacement fuse cover
corresponds with the coloured
insert or as indicated in
embossed words on the base of
the plug. Replacement fuse
covers are available from the
Spares Department, Lec
Refrigeration plc. at the address
on the rear cover of this leaflet.
When a non-rewirable plug or a
rewirable 13 Amp (BS 1363) plug
is used it must be fitted with a
13 Amp ASTA approved (BS 1362)
fuse. If any other type of plug is
used it must be protected by a 15
Amp fuse either in the plug or at
the distribution board.
21
