LG NB2020A Manuale utente
Please read this manual carefully before operating
your set and retain it for future reference.
NB2020A
OWNER’S MANUAL
Sound Bar System
ENGLISH
FOR THE WARRANTY TERMS & CONDITIONS,
PLEASE REFER TO BACK COVER OF THIS MANUAL.
NB2020A-N0_DGBRLLK_ENG_4459.indd 1 2012-07-26 2:45:58
1 Getting Started
Getting Started2
Getting Started
1
Safety Information
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK DO NOT REMOVE COVER (OR BACK) NO
USER-SERVICEABLE PARTS INSIDE REFER SERVICING
TO QUALIFIED SERVICE PERSONNEL.
This lightning ash with
arrowhead symbol within an
equilateral triangle is intended to
alert the user to the presence of
uninsulated dangerous voltage
within the product’s enclosure
that may be of sucient
magnitude to constitute a risk of
electric shock to persons.
The exclamation point within an
equilateral triangle is intended
to alert the user to the presence
of important operating and
maintenance (servicing)
instructions in the literature
accompanying the product.
WARNING: TO PREVENT FIRE OR ELECTRIC SHOCK
HAZARD, DO NOT EXPOSE THIS PRODUCT TO RAIN
OR MOISTURE.
WARNING: Do not install this equipment in a
conned space such as a book case or similar unit.
CAUTION: Do not block any ventilation openings.
Install in accordance with the manufacturer’s
instructions.
Slots and openings in the cabinet are provided for
ventilation and to ensure reliable operation of the
product and to protect it from over heating. The
openings shall be never be blocked by placing
the product on a bed, sofa, rug or other similar
surface. This product shall not be placed in a built-
in installation such as a bookcase or rack unless
proper ventilation is provided or the manufacturer’s
instruction has been adhered to.
Most appliances recommend they be placed upon
a dedicated circuit;
That is, a single outlet circuit which powers only
that appliance and has no additional outlets or
branch circuits. Check the specication page of this
owner’s manual to be certain. Do not overload wall
outlets. Overloaded wall outlets, loose or damaged
wall outlets, extension cords, frayed power cords, or
damaged or cracked wire insulation are dangerous.
Any of these conditions could result in electric
shock or re. Periodically examine the cord of your
appliance, and if its appearance indicates damage
or deterioration, unplug it, discontinue use of the
appliance, and have the cord replaced with an
exact replacement part by an authorized service
center. Protect the power cord from physical or
mechanical abuse, such as being twisted, kinked,
pinched, closed in a door, or walked upon. Pay
particular attention to plugs, wall outlets, and
the point where the cord exits the appliance. To
disconnect power from the mains, pull out the
mains cord plug. hen installing the product, ensure
that the plug is easily accessible.
This device is equipped with a portable battery or
accumulator.
Safety way to remove the battery or the
battery from the equipment: Remove the
old battery or battery pack, follow the steps
in reverse order than the assembly. To prevent
contamination of the environment and bring on
possible threat to human and animal health, the
old battery or the battery put it in the appropriate
container at designated collection points. Do
not dispose of batteries or battery together with
other waste. It is recommended that you use
local, free reimbursement systems batteries and
accumulators. The battery shall not be exposed to
excessive heat such as sunshine, re or the like.
NB2020A-N0_DGBRLLK_ENG_4459.indd 2 2012-07-26 2:45:59
Getting Started 3
Getting Started
1
Disposal of your old appliance
1. When this crossed-out wheeled bin
symbol is attached to a product it
means the product is covered by the
European Directive 2002/96/EC.
2. All electrical and electronic products
should be disposed of separately
from the municipal waste stream
via designated collection facilities
appointed by the government or the
local authorities.
3. The correct disposal of your old
appliance will help prevent potential
negative consequences for the
environment and human health.
4. For more detailed information about
disposal of your old appliance,
please contact your city office, waste
disposal service or the shop where
you purchased the product.
Disposal of waste batteries/accumulators
1. When this crossed-out wheeled
bin symbol is attached to batteries/
accumulators of Your product it
means they are covered by European
Directive 2006/66/EC.
2. This symbol may be combined with
chemical symbols for mercury(Hg),
cadmium(Cd) or lead(Pb) if the
battery Contains more that 0.0005%
of mercury,0.002% of cadmium or
0.004% of lead.
3. All batteries/accumulators should
be disposed separately from
the municipal waste stream via
designated collection facilities
appointed by the government or the
local authorities.
4. The correct disposal of Your old
batteries/accumulators will help
to prevent potential negative
consequences for the environment,
animal and human health.
5. For more detailed information
about disposal of Your old batteries/
accumulators, please contact Your city
office, waste disposal service or the
shop where You purchased the product.
LG Electronics hereby declares that this/
these product(s) is/are in compliance
with the essential requirements and other
relevant provisions of Directive 2004/108/
EC, 2006/95/EC and 2009/125/EC.
European Standards Centre:
Krijgsman1, 1186 DM Amstelveen The Netherlands
yPlease note that this is NOT a Customer Service
contact point. For Customer Service Information,
see Warranty Card or contact the dealer that you
purchased this product.
POWER: This unit operates on a mains supply of
200-240V~, 50/60Hz.
Wiring: This unit is supplied with a BS 1363
approved main plug. When replacing the fuse,
always use of the same rating approved to BS
1362. Never use this plug with the fuse cover
omitted. To obtain a replacement fuse cover
contact your dealer. If the type of plug supplied is
not suitable for the mains sockets in your home,
then the plug should be removed and a suitable
type tted. Please refer to the wiring instructions
below:
Warning: A mains plug removed from the mains
lead of this unit must be destroyed. A mains plug
with bared wires is hazardous if inserted in a
mains socket. Do not connect either wire to the
earth pin, marked with the letter E or with the
earth symbol or coloured green or green and
yellow. If any other plug is tted, use same rating
of fuse in the plug.
Important: The wires in this mains lead are
coloured in accordance with the following codes:
- BLUE: NEUTRAL, BROWN: LIVE - As the colours
of the wires in the mains lead of this unit may
not correspond with the coloured marking
identifying the terminals in your plug, proceed
as follows: The wire which is coloured blue must
be connected to the terminal which is marked
with the letter N or coloured black. The wire
which is coloured brown must be connected to
the terminal which is marked with the letter L or
coloured red.
NB2020A-N0_DGBRLLK_ENG_4459.indd 3 2012-07-26 2:45:59
Table of Contents4
Table of Contents
1 Getting Started
2 Safety Information
6 Accessories
6 Introduction
6 – Symbols Used in this Manual
7 Remote control
8 Front panel
8 Rear panel
9 Installing the sound bar
9 Installing the cover foot
2 Connecting
10 Mounting the main unit on a wall
11 Optional Equipment Connection
11 – OPTICAL In connection
3 Operating
12 Operations
12 – DOLBY DRC (Dynamic Range
Control)
12 – AV Sync
12 – AUTO POWER DOWN
12 – AUTO POWER On/Off
12 – Turn off the sound temporarily
13 Controlling a TV with the Supplied
Remote Control
4 Troubleshooting
14 Troubleshooting
NB2020A-N0_DGBRLLK_ENG_4459.indd 4 2012-07-26 2:45:59
Table of Contents 5
1
2
3
4
5
5 Appendix
15 Maintenance
15 – Handling the Unit
16 Trademarks and Licenses
17 Specifications
6 Warranty
18 Warranty
NB2020A-N0_DGBRLLK_ENG_4459.indd 5 2012-07-26 2:45:59
Getting Started6
Getting Started
1
Accessories
Please check and identify the supplied accessories.
Remote control (1) Batteries (1)
Wall Mount Bracket
Installation Template
(1)
Wall bracket (2)
Optical cable (1) Cover foot (2)
Introduction
Symbols Used in this Manual
, Note
Indicates special notes and operating features.
> Caution
Indicates cautions for preventing possible damages
from abuse.
NB2020A-N0_DGBRLLK_ENG_4459.indd 6 2012-07-26 2:46:00
Getting Started 7
Getting Started
1
Remote control
Battery Installation
Remove the battery cover on the rear of the
Remote Control, and insert (size AAA) battery with
and matched correctly.
• • • • • • • • • • a • • • • • • • • •
1(Power): Switches the unit ON or OFF.
DOLBY DRC (ON/ OFF) : Sets the Dobly DRC.
• • • • • • • • • • b • • • • • • • • •
: Mutes the sound.
VOL -/+ : Adjusts speaker volume.
AV SYNC -/+ : Synchronizes the audio and video.
yWhen the volume reaches the highest/
lowest level and you push VOL+/- on the
remote control again, red LED on the unit
turns on for 2 seconds to signal on what the
volume level is.
yWhen the unit turns on, volume of the unit
will rise gradually to the volume level set at
the unit turned o.
, Note
• • • • • • • • • • c • • • • • • • • •
TV Control buttons: See page 13.
AUTO POWER (ON/OFF) : This function is
automatically turned on the unit.
NB2020A-N0_DGBRLLK_ENG_4459.indd 7 2012-07-26 2:46:00
Getting Started8
Getting Started
1
A1(Standby/On)
B– / + (Volume)
Adjusts speaker volume.
Front panel
Rear panel
AS/W Download Connector - Only for service. BOPTICAL IN
NB2020A-N0_DGBRLLK_ENG_4459.indd 8 2012-07-26 2:46:00
Getting Started 9
Getting Started
1
Installing the sound
bar
You can hear the sound by connecting the unit to
the other device : TV, Blu-ray disc player, DVD player,
etc.
Place the unit in front of the TV and connect it to
the device you want. (Refer to page11)
Installing the cover
foot
You can extend the height of the unit.
1. Turn the unit upside down.
2. After detaching a release layer on the cover
foot, Put it on the foot of the unit.
3. Make the cover foot attached firmly to the unit
by pushing it strongly.
NB2020A-N0_DGBRLLK_ENG_4459.indd 9 2012-07-26 2:46:00
2 Connecting
Connecting10
Connecting
2
Mounting the main
unit on a wall
You can mount the main unit on a wall.
Prepare screws and brackets.
Unit
Wall bracket
Wall Mount Bracket
Installation Template
1. Match the TV’s BOTTOM EDGE of Wall Mount
Bracket Installation Template with the bottom
of TV and attach to the position.
TV
2. When you mount it on a wall (concrete), use
the wall plugs (Not supplied). You should drill
some holes. A guide sheet (Wall Mount Bracket
Installation Template) is supplied to drill. Use the
sheet to check the point to drill.
Wall Mount Bracket Installation Template
Screws and Wall Plugs are not supplied for
mounting the unit. We recommend the Hilti
(HUD-1 6 x 30) for the mounting. Please
purchase it.
, Note
NB2020A-N0_DGBRLLK_ENG_4459.indd 10 2012-07-26 2:46:01
Altri manuali per NB2020A
2
Indice
Altri manuali LG Sistema di altoparlanti
