TROUBLE-SHOOTING AND STORAGE
10
Most treadmill problems can be solved by following the simple steps below, Find the symptom
that applies to your treadmill and follow the steps listed. If further assistance is needed, please call our
Customer Sewice Department toll-free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m.
Mountain Time (excluding holidays).
1. SYMPTOM: THE POWER DOES NOT TURN ON
d, Make sure that the power cord is plugged into a properly grounded outlet. (See OPERATION
_'_AND ADJUSTMENT on page 7.) If an extension cord is needed, use only a 14-gauge general-
purpose cord of five feet or less in length.
b. After the power cord has been plugged in, make sure that the safety key is fullyinserted intothe
console. Various indicators on the console should light. (See OPERATION AND ADJUSTMENT
on parle 7.)
C, Check the circuitbreaker located on the treadmill
frame near the power cord. If the switch protrudes as
shown, the circuit breaker has tripped. To reset the cir-
cuit breaker, wait for five minutes and then press the
switchback in.
2. SYMPTOM: THE POWER TURNS OFF DURING USE Tripped Reset
a. Check the circuit breaker located on the treadmill frame near the power cord. If the circuit breaker
has tripped, the switch will protrude. (See the drawing above.) To reset the circuit breaker, wait
for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in.
c. Remove the safety key from the console. Reinsert the safety key fully into the console. Various
indicators on the console should light.
3. SYMPTOM: THE WALKING BELT SLOWS WHEN WALKED ON
a. Apply silicone lubricant to the walking platform before use. Reapply lubricant after every 10 hours
of use, and whenever a decrease in performance is noticed. (Uni.Sport silicone spray is recom-
mended.) CAUTION: UNPLUG THE POWER CORD WHEN APPLYING LUBRICANT. (See
OPERATION AND ADJUSTMENT on page 7 application instructions.)
b. If an extension cord is needed, use only a14-gauge general-purpose cord of five feet or less in length.
c. If the walking belt is overtightened, treadmill performance
may decrease and the walking belt may be permanently
damaged. Remove the safety key and UNPLUG THE
POWER CORD. Using the allen wrench, turn both rear
roller adjustment bolts counterclockwise, 1/4 of a turn.
When the walking belt is properly tightened, you should
be able to lift each side of the walking belt 3-4 inches off
the walking platform. The center of the walking belt should
be just above the walking platform. Be careful to keep the
walking belt centered. Plug in the power cord, insert the
safety key and run the treadmill for a few minutes. Repeat
until the walking belt is properly tightened. Rear Roller Adjustment Bolts
