Light-N-Carry LNC1841 Manuale utente
COB LED Rechargeable Work Light
Operator’s Manual
Model No. LNC1841
Failure to follow instructions may
cause damage or explosion,
always shield eyes. Read entire
instruction manual before use.
WARNING
WARNING: This product can expose you to chemicals,
including Vinyl-Chloride, Styrene and Acrylonitrile, which
are known to the State of California to cause cancer.
For more information go to www.P65Warnings.ca.gov.
2
PLEASE SAVE THIS OWNERS MANUAL
AND READ BEFORE EACH USE.
This manual will explain how to use the work light safely and
effectively. Please read and follow these instructions and pre-
cautions carefully. In the rare event that your work light contains
a damaged or missing item, does not perform as specied,
or requires warranty service, please call Technical Service at
(913) 310-1050. Save your purchase receipt, it is required for
warranty service.
This unit has a sealed lithium battery that should be kept at full
charge. Recharge when rst received, immediately after each
use, and every three months if not used. Failure to perform
maintenance charges may cause the battery life to be reduced
greatly.
Read these instructions completely before using the
Light-N-Carry and save them for future reference.
Fire Risk – do not disassemble, crush, puncture or
ignite internal battery.
Always wear eye protection, appropriate protective
clothing and other safety equipment when working
on vehicles or other equipment.
3
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS – This manual contains
important safety and operating instructions for Model No.
LNC1841. Read, understand and follow all instructions,
cautions and warnings listed in this manual. Failure to follow
all instructions could result in personal injury, injury to others
and property damage.
IMPORTANT! – Charge work light immediately after
purchase, after each use, and at least every 3 months
when not in use.
DO NOT turn on the work light while it is being charged.
DO NOT handle or move the work light while it is being
charged.
DO NOT look directly into the light or shine the light directly
into the eyes of any person or animal.
DO NOT allow children to use the work light.
DO NOT operate the work light if it has received a sharp
blow, been dropped, or otherwise damaged in any way; take
it to a qualied service person.
DO NOT allow the unit’s battery to stay in a discharged state
for long periods of time. This has a detrimental effect on
battery life.
AC CHARGER FOR INDOOR USE ONLY. DO NOT expose
the charger to water or use in damp conditions.
4
WARNING: Do not use any other charger except the one
provided to charge the work light. Use of a charger not sup-
plied by the manufacturer may result in a risk of re, injury to
persons
and/or damage to property.
DO NOT use the work light with a charger which has a dam-
aged cord or plug. Replace the cord or plug immediately.
To reduce the risk of damage to the charger plug, pull by the
plug, rather than the cord, when disconnecting the charger.
DO NOT use the provided charger to charge or power any
other electrical item.
PERSONAL SAFETY PRECAUTIONS
WARNING: To reduce risk of re or burns, do not disas-
semble, crush or puncture internal battery, short external
contacts, or dispose of in re or water.
WARNING: Avoid direct exposure of LED light to eyes.
Do not shine into the eyes of people or animals. Keep away
from children.
DO NOT disassemble the work light; take it to a qualied
service person when service or repair is required. Incorrect
reassembly may result in a risk of re.
DO NOT expose to temperatures above 140˚F (60˚C).
Recycle or dispose of the used battery as required by local
regulations.
5
FEATURES
- ON/OFF Power Button
- COB LED Work Light with 2 Settings
- SMD LED Focus Beam light
- USB Power Outlet (5V, 1.1A)
- State of Charge / Charging Status LED Indicator
- Dual Magnets on Rear of Unit
- Dual Mounting Hooks
- AC Wall Charger
CHARGING
NOTE: CHARGE THE WORK LIGHT IMMEDIA TEL Y AFTER
PURCHASE, AFTER EACH USE, AND A T LEAST EVERY 3
MONTHS WHEN NOT IN USE. Failure to do this will reduce
the battery’s useful life.
Connect the pin jack end of the charging cable to the pin jack
port on the work light. Connect the USB end of the charging
cable to the USB port of the AC charger. Plug the AC charger
into a functioning AC outlet.
The blue state of charge / charging status LEDs will blink
in succession to indicate charging progress. To reach full
charge, continue charging until all four LEDs are lit solid.
Charging will take approximately 4 hours, depending on the
unit’s state of charge at the start of the cycle.
The charging process is fully automatic and the light can
remain connected to the charger indenitely without adverse
consequences.
6
OPERATING INSTRUCTIONS
Do not turn on the work light while it is being charged.
Direct the lens away from your eyes before turning on the
work light.
Press the POWER button to achieve the operational mode
desired:
– Press POWER for COB Work Light low brightness mode.
– Press POWER a second time for COB Work Light high
brightness mode.
– Press POWER a third time for Focus Beam Light mode.
– Press POWER a fourth time to turn the unit OFF.
NOTE:
All light operating modes are adjustable. When in
any light operating mode, hold down the power button.
The light will ash twice and begin to dim until it reaches the
lowest setting and then begin to increase again.
The unit incorporates a rotating arm with an integrated mag-
net in its base for ideal positioning, allowing it to be attached
to any ferrous metal surface. In addition, the unit has dual
magnets and hooks for mounting on the rear of the unit.
Recharge the work light after use, and at least every 3
months when not is use.
7
MAINTENANCE INSTRUCTIONS
After use and before performing maintenance, disconnect
the work light from the charger.
Use a dry cloth to wipe any dirt or oil from the charger, cord
and light.
Any servicing should be performed by qualied service
personnel.
STORAGE INSTRUCTIONS
Store inside, in a cool, dry place.
Take care to avoid/prevent damage to the charger, cord
and unit. Failure to do so could result in personal injury or
property damage.
Charge the work light’s internal battery immediately after
purchase, after use and every 3 months when not in use.
All batteries are affected by temperature. The ideal storage
temperature is 70˚F. The internal battery will gradually
self-discharge (lose power) over time, especially in warm
environments. Leaving the battery in a discharged state may
result in shorter than expected battery life.
REPLACEMENT PARTS
Charger replacement kit (includes wall charger and
USB/pin jack) – PART NO. LNC217
LIMITED WARRANTY
Clore Automotive warrants this product to be free from defects in
material or workmanship for a period of one year from the date of
original end user purchase.
This warranty extends to each person who acquires lawful own-
ership within one year of the original retail purchase, but is void
if the product has been abused, altered, misused or improperly
packaged and damaged when returned for repair.
This warranty applies to the product only and does not apply to
any accessory items included with the product, which are subject
to wear from usage. Accessories include, but are not limited to,
wall chargers, charging cables and hooks. The replacement or
repair of these items shall be at the expense of the owner.
THE TERMS OF THE CLORE AUTOMOTIVE LIMITED WAR-
RANTY CONSTITUTE THE BUYER’S SOLE AND EXCLUSIVE
REMEDY. IMPLIED WARRANTIES OF MERCHANTABILITY
AND FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED
IN DURATION TO THIS EXPRESS WARRANTY. AFTER 1 YEAR
FROM DATE OF PURCHASE, ALL RISK OF LOSS FROM WHAT-
EVER REASON SHALL BE PUT UPON THE PURCHASER.
CLORE AUTOMOTIVE SHALL NOT BE LIABLE FOR INCIDEN-
TAL AND CONSEQUENTIAL DAMAGES UNDER ANY CIRCUM-
STANCES: CLORE AUTOMOTIVE’S LIABILITY, IF ANY, SHALL
NEVER EXCEED THE PURCHASE PRICE OF THIS PRODUCT
REGARDLESS OF WHETHER LIABILITY IS PREDICATED
UPON BREACH OF WARRANTY (EXPRESS OR IMPLIED),
NEGLIGENCE, STRICT TORT OR ANY OTHER THEORY.
Some states do not permit the limitation of warranties or limitation
of consequential or incidental damages, so the above disclaimer
and limitation may not apply to you. This warranty gives you
specic legal rights, and you may also have other
rights which vary from state to state.
9
Instructions for obtaining service under this warranty:
If this product fails within the warranty period due to a
defect in material or workmanship, return it to your place
of purchase for an exchange.
Registering Your Purchase
For best service and to receive periodic product updates,
please visit www.cloreregistration.com, click on the
Light-N-Carry logo, choose your model number, complete the
information in the web form and click “submit.”
It’s that easy!
For answers to questions concerning use, out-of-warranty
service, or warranty/service information on this or other
Clore Automotive products, contact:
Clore Automotive Technical Service
800.328.2921
913.310.1050
www.cloreautomotive.com
10
Luz de trabajo recargable LED COB
Manual del operador
Modelo LNC1841
El incumplimiento de las instrucciones
puede causar daños o explosión, siempre
proteger los ojos. Lea todo el manual de
instrucciones antes de usarlo.
ADVERTENCIA:
ADVERTENCIA: Este producto puede exponerlo a sustancias químicas
como cloruro de vinilo, estireno y acrilonitrilo, indicadas por el estado
de California como causantes de cáncer y defectos de nacimiento u
otros daños reproductivos. Lávese las manos después de manipularlo.
Para obtener más información, ingrese a www.P65Warnings.ca.gov.
Indice
Lingue:
Altri manuali Light-N-Carry Luce da lavoro
