e3 One-Box DVR Setup Guide 6 www.linearcorp.com
4. System Configuration
e e3 Controller will need to be set to the DVR’s IP address before the two systems can communicate.
Overview
1. Apply power to the e3 system.
2. Setup DVR’s IP address, Subnet, etc using the settings provided by network administrator.
is can be done with the DW Web interface or using VGA monitor and USB mouse.
3. Setup the e3 Controller’s IP address, Subnet, etc using the settings provided by network
administrator.is can be done by logging into the e3 Controller or using IP Installer utility.
4. Disconnect power to the e3 system.
5. Connect the DW DVR to the e3 Controller (see Section 5).
DVR Factory Defaults
e DVR is set with these factory defaults:
Login
• User: Admin
• Password: BLANK (enter nothing)
Network Settings:
• IP Address: 192.168.1.160
• Subnet Mask: 255.255.255.0
• Gateway: 192.168.1.1
• DNS Server 1: 0.0.0.0
• DNS Server 2: 0.0.0.0
• TCP/IP Port: 9010
• Web Port: 80
e3 Controller Setup
Use these steps to setup the e3 Controller to communicate with the DVR.
1. Open a web browser on a local computer on the same network as the e3 and enter the IP
address of the e3 Controller (Default = 192.168.0.250).
2. e browser presents the login screen as shown.
3. To log on, enter the user name (default = admin) and password (default = admin).
4. Select the VIDEO icon on the tool bar, then click DVR SETTING.
5. If this is the rst time accessing the DVR with this computer, you will be prompted to
install WebACS. Follow the prompts until it is fully installed.
6. Click NEW.
NOTE: Before proceeding,
you will need to obtain
the following information
from your network
administrator:
IP, Subnet Mask,
Gateway, and DNS Server
information for the e3
Controller and the DW
DVR.
NOTE: eMerge One Box
and the WebACS is only
compatible with 32-bit
version of Microsoft
Internet Explorer (IE)
version 9 and higher. It
will not work with Firefox,
Chrome or other browsers.
NOTE: Recommend
synchronizing the DW
DVR clock and the e3
Controller clock.
The DW DVR can be
set to access external
NTP time servers and
configured to be a
time server for the e3
Controller.
NOTE: If you have
tried to use the DVR
before software version
v0.32-02e, please uninstall
all previous versions of
Web ACS and ACS SDK
from the Add/Remove
Programs list.
