Linksys AM200 Manuale utente

Model No.

WIRED

ADSL Modem

AM200 (EU/LA)

User Guide

ADSL Modem

Specifications are subject to change without notice. Linksys is a registered trademark or trademark of Cisco

rights reserved. Other brands and product names are trademarks or registered trademarks of their respective

holders.

How to Use this Guide

Your Guide to the ADSL Modem has been designed to make understanding networking with the Modem easier

than ever. Look for the following items when reading this User Guide:

In addition to these symbols, there are definitions for technical terms that are presented like this:

Also, each figure (diagram, screenshot, or other image) is provided with a figure number and description, like

this:

Figure numbers and descriptions can also be found in the “List of Figures” section in the “Table of Contents”.

This exclamation point means there is a Caution or

Warning and is something that could damage your

property or the Modem.

word: definition.

This checkmark means there is a Note of interest and

is something you should pay special attention to while

using the Modem.

This question mark provides you with a reminder about

something you might need to do while using the Modem.

Figure 0-1: Sample Figure Description

AM200-EU/LA-UG-60519NC DF

ADSL Modem

Table of Contents

Chapter 1: Introduction 1

Welcome 1

What’s in this Guide? 2

Chapter 2: Getting to Know the ADSL Modem 3

The Back Panel 3

The Front Panel 4

Chapter 3: Setting Up and Connecting the ADSL Modem 5

Overview 5

Wall-Mount Option 5

Connecting the Modem 5

Chapter 4: Configuring the ADSL Modem 7

Overview 7

How to Access the Web-based Utility 9

The Setup Tab 9

The Security Tab 15

The Applications and Gaming Tab 18

The Administration Tab 20

The Status Tab 24

Appendix A: Troubleshooting 25

Common Problems and Solutions 25

Frequently Asked Questions 28

Appendix B: Upgrading Firmware 30

Appendix C: Glossary 31

Appendix D: Specifications 36

Appendix E: Warranty Information 37

Appendix F: Regulatory Information 38

Appendix G: Contact Information 44

ADSL Modem

List of Figures

Figure 2-1: Back Panel 3

Figure 2-2: Front Panel 4

Figure 3-1: Wall-Mount Option 5

Figure 3-2: DSL Connection 5

Figure 3-3: Ethernet Connection 6

Figure 3-4: Power Connection 6

Figure 4-1: Password Screen 9

Figure 4-2: Basic Setup Tab 9

Figure 4-3: Dynamic IP 10

Figure 4-4: Static IP 10

Figure 4-5: RFC Routed 10

Figure 4-6: RFC 2516 PPPoE 11

Figure 4-7: RFC 2364 PPPoA 11

Figure 4-8: Bridged Mode Only 12

Figure 4-9: Network Setup 12

Figure 4-10: DynDNS.org 13

Figure 4-11: TZO.com 13

Figure 4-12: Advanced Routing 14

Figure 4-13: Routing Table 14

Figure 4-14: Firewall 15

Figure 4-15: Access Control 15

Figure 4-16: Edit Schedule Rule 16

Figure 4-17: MAC Filtering 16

Figure 4-18: URL Blocking 17

Figure 4-19: Intrusion Detection 17

Figure 4-20: VPN Passthrough 18

Figure 4-21: Port Range Forwarding 18

Figure 4-22: Port Triggering 19

ADSL Modem

Figure 4-23: NAT Mapping Table 19

Figure 4-24: DMZ 19

Figure 4-25: Management 20

Figure 4-26: SNMP 20

Figure 4-27: Log 21

Figure 4-28: Incoming Log 21

Figure 4-29: Outgoing Log 21

Figure 4-30: Diagnostic Tests 22

Figure 4-31: Ping Test 22

Figure 4-32: Traceroute Test 22

Figure 4-33: Firmware Upgrade 23

Figure 4-34: Factory Defaults 23

Figure 4-35: Reboot 23

Figure 4-36: Status 24

Figure 4-37: Local Network 24

Figure 4-38: DHCP Clients Table 24

Figure B-1: Upgrade Firmware 30

Chapter 1: Introduction

Welcome

ADSL Modem

Chapter 1: Introduction

Welcome

Thank you for choosing the ADSL Modem. The Linksys ADSL Modem gives you an instant, high-speed connection

to the Internet. ADSL technology lets you access the Internet using your existing phone lines, without interfering

with your voice phone service. You can talk on the phone and surf the net at the same time. Web surfing and your

e-mail are instantly available, anytime.

Installation is quick and simple. Connect it directly to any PC with an available Ethernet port, and you’re ready to

surf the Internet. Or connect it to a Linksys router and share that high-speed Internet access with everyone on

your home network.

Use the instructions in this user guide to help you connect the ADSL Modem and configure it to access the

Internet. These instructions should be all you need to get the most out of the ADSL Modem.

Chapter 1: Introduction

What’s in this Guide?

ADSL Modem

What’s in this Guide?

This user guide covers the steps for setting up and using the ADSL Modem.

• Chapter 1: Introduction

This chapter describes the ADSL Modem applications and this User Guide.

• Chapter 2: Getting to Know the ADSL Modem

This chapter describes the physical features of the ADSL Modem.

• Chapter 3: Connecting the ADSL Modem

This chapter instructs you on how to connect the ADSL Modem to your network.

• Chapter 4: Configuring the ADSL Modem

This chapter explains how to use the Web-Based Utility to configure the settings on the ADSL Modem.

• Appendix A: Troubleshooting

This appendix describes some problems and solutions, as well as frequently asked questions, regarding

installation and use of the ADSL Modem.

• Appendix B: Upgrading Firmware

This appendix instructs you on how to upgrade the firmware on your ADSL Modem if you should need to do

so.

• Appendix C: Glossary

This appendix gives a brief glossary of terms frequently used in networking.

• Appendix D: Specifications

This appendix provides the technical specifications for the ADSL Modem.

• Appendix E: Warranty Information

This appendix supplies the warranty information for the ADSL Modem.

• Appendix F: Regulatory Information

This appendix supplies the regulatory information regarding the ADSL Modem.

• Appendix G: Contact Information

This appendix provides contact information for a variety of Linksys resources, including Technical Support.

Chapter 2: Getting to Know the ADSL Modem

The Back Panel

ADSL Modem

Chapter 2: Getting to Know the ADSL Modem

The Back Panel

The Modem’s ports, where cables are connected, are located on the back panel. The Modem’s reset button is also

located on the back panel.

DSL The DSL port connects to the DSL line.

Ethernet The Ethernet port connects to your computer and other network devices.

Reset Button There are two ways to reset the Modem's factory default settings. Either press the Reset

Button, for approximately ten seconds, or restore the defaults on the Factory Defaults screen

of the Administration tab in the Modem’s Web-Based Utility.

Power The Power port is where you connect the power adapter.

With these, and many other, Linksys products, your networking options are limitless. Go to the Linksys

international website at www.linksys.com/international for more information about products that work with the

Modem.

Important: Resetting the Modem to factory

defaults will erase all of your settings (WAN

and LAN settings, etc.) and replace them with

the factory defaults. Do not reset the Modem if

you want to retain these settings.

Figure 2-1: Back Panel

Chapter 2: Getting to Know the ADSL Modem

The Front Panel

ADSL Modem

The Front Panel

The Modem's LEDs, where information about network activity is displayed, are located on the front panel.

Power Green. The Power LED lights up when the Modem is powered on.

Ethernet Green. The Ethernet LED serves two purposes. If the LED is continuously lit, the Modem is

successfully connected to a device through the Ethernet port. If the LED is blinking, it is an

indication of any network activity.

DSL Green. The DSL LED lights up whenever there is a successful DSL connection. The LED blinks

while establishing the DSL connection.

Internet Green. The Internet LED lights up green when an Internet connection to the Internet Service

Provider (ISP) session is established. The Internet LED lights up red when the connection to

the ISP fails.

Figure 2-2: Front Panel

Chapter 3: Setting Up and Connecting the ADSL Modem

Overview

ADSL Modem

101.6 mm (4 inches)

Chapter 3: Setting Up and Connecting the ADSL Modem

Overview

In thischapter, you will connect the Modem to your DSL line and to a computer in your home or business. It isnot

necessary to mount your Modem, but may be useful to conserve space. There are 2 slotson the underside of the

Modem that can be used for wall mounting.

Wall-Mount Option

You will need 2 suitable screws(4.4 mm screw diameter) to mount the Modem.

1. Determine where you want to mount the Modem. Ensure that the wall you use issmooth, flat, dry and sturdy

and make sure the location iswithin reach of the power outlet.

2. Drill two holesinto the wall. Make sure the holesare 101.6mm (4 inches) apart.

3. Insert a screw into each hole, and leave 3 mm (0.12 inch) of itshead exposed.

4. Maneuver the Modem so the wall-mount slotsline up with the two screws.

5. Place the wall-mount slotsover the screwsand slide the Modem down until the screwsfit snugly into the

wall-mount slots.

Congratulations! The Wall-Mount installation of the Modem iscomplete. Perform the stepsunder Connecting the

Modem to complete your Modem installation.

Connecting the Modem

1. Connect one end of the provided phone cable to the DSL (RJ-11 phone) port that ison the back of your

Modem. Connect the other end of the phone cable to the wall jack with DSL service.

Figure 3-1: Wall-Mount Option

Figure 3-2: DSL Connection

NOTE:

A small device called a microfilter (not included) may be necessary between each phone

and wall jack to prevent interference. Contact your ISP if you have any questions.

Altri manuali per AM200

Indice

Altri manuali Linksys Modem

Linksys

Linksys USB2128M Istruzioni operative originali

Linksys

Linksys USBDSL1 Manuale utente

Linksys

Linksys BEFCMU10 - Cable Modem With USB Manuale utente

Linksys

Linksys AM300 Manuale utente

Linksys

Linksys CM2P2-NA Manuale operativo

Linksys

Linksys USBDSL1 Manuale utente

Linksys

Linksys WCGP200 Manuale utente

Linksys

Linksys AM300 Manuale utente

Linksys

Linksys AG241 Manuale utente

Linksys

Linksys USB2128M Manuale operativo

Linksys

Linksys WAG54GP2 Manuale utente

Linksys

Linksys AM200 Manuale utente

Linksys

Linksys USBDSL1 Istruzioni operative originali

Linksys

Linksys ADSL2MUE Manuale utente

Linksys

Linksys BEFCMU10 - Cable Modem With USB Manuale utente

Linksys

Linksys CM30XX Manuale utente

Linksys

Linksys Fibe Internet Manuale utente

Linksys

Linksys BEFCMU10 - Cable Modem With USB Manuale utente

Linksys

Linksys CG7500 Manuale utente

Linksys

Linksys BEFCMU10 - Cable Modem With USB Istruzioni operative originali

Linksys

Linksys HA1000 Manuale utente

Linksys

Linksys USBM128M Istruzioni operative originali

Linksys

Linksys ADSL2MUE Manuale utente

Linksys

Linksys ADSLME1 Manuale utente

Manuali Modem popolari di altre marche

Davicom

Davicom DM562AP Manuale utente

EpiValley

EpiValley TATA indicom SXC-1080 Manuale utente

Zte

Zte WiMAX Manuale utente

Intelimax

Intelimax MA-2060 Manuale utente

SMC Networks

SMC Networks D3CM1604V Manuale per l'uso e la cura

Telstra

Telstra Wi-Fi 4G Advanced Pro X Manuale utente

Thrane&Thrane

Thrane&Thrane imarsat EXPLORER 300 Manuale utente

Samsung

Samsung AceLink SAM-335A Manuale utente

Enfora

Enfora Enabler-G Guida rapida alla configurazione

iRZ

iRZ ATM2-232 Manuale utente

Zhone

Zhone 6310 Manuale utente

Paradyne

Paradyne Hotwire 7976 Manuale utente

US Robotics

US Robotics 3453C Manuale utente

MaxTech

MaxTech Plug & Play Internal Voice/FAX/Data/SVD... Manuale utente

Zte

Zte MF823 Manuale utente

Four-Faith

Four-Faith F1403 Manuale utente

Sierra Wireless

Sierra Wireless AIRLINK MP595W Manuale utente

Gemtek

Gemtek WiMAX WIXFBR-103 Manuale utente