Lippert Components 285318 Manuale

Rev: 09.29.2015 Page 1 Power Tongue Jack Install Manual





Rev: 09.29.2015 Page 2 Power Tongue Jack Install Manual

Safety and System Information

Safety Information

The “WARNING” symbol above is a sign that an installation procedure has a safety risk involved and may cause

death or serious injury if not performed safely and within the parameters set forth in this manual. Always wear eye

protection when performing this installation procedure. Other safety equipment to consider would be hearing

protection, gloves, and possibly a full face shield, depending on the nature of the installation procedure.

Failure to act in accordance with the following may result in death, serious

injury, coach or property damage.

Preparation

Tools and Components Required

• Power Tongue Jack

• ⁄" - 16x1; serrated flange Grade 5 zinc bolts

• Cordless, power, or impact screw gun

• ½" socket bit

1. Remove the foot pad from the Power Tongue Jack (if necessary).

A. Remove the clevis pin holding the foot pad to the jack leg, and set the pin and the foot pad aside

(Fig. 1).

Fig. 1

2. Support the travel trailer according to OEM instructions.

Foot Pad

Clevis Pin

Moving parts can pinch, crush, or cut. Keep clear at all times.

Rev: 09.29.2015 Page 3 Power Tongue Jack Install Manual

The coach MUST be supported per OEM specifications before working underneath.

Failure to do so may result in death or serious injury.

Installation

1. Carefully slide the jack leg (Fig. 2A) through the hole in the coupler (Fig. 2B) on the travel trailer “A”

frame (Fig. 2C).

Fig. 2

2. Align the three (3) holes in the Power Tongue Jack mounting plate (Fig. 3A) with the three (3) holes in

the coupler (Fig. 3B).

Fig. 3

AA B

Rev: 09.29.2015 Page 4 Power Tongue Jack Install Manual

3. Secure the Power Tongue Jack to the coupler plate with three (3) ⁄" - 16x1; Serrated Flange Grade 5

Zinc coated bolts (Fig. 4).

Fig. 4

4. Connect the red power wire from the Power Tongue Jack housing to a grounded 12V power supply on

the travel trailer.

NOTE: The Power Tongue Jack MUST be wired through a 30 amp fused circuit.

5. Reattach the foot pad to the jack leg by sliding the foot pad back over the bottom of the jack leg and

securing it with the clevis pin previously removed.

Rev: 09.29.2015 Page 5 Power Tongue Jack Install Manual

Notes

The contents of this manual are proprietary and copyright protected by Lippert Components, Inc. (“LCI”).

LCI prohibits the copying or dissemination of portions of this manual unless prior written consent from an

authorized LCI representative has been provided. Any unauthorized use shall void any applicable warranty.

The information contained in this manual is subject to change without notice and at the sole discretion of LCI.

Revised editions are available for free download from www.lci1.com.

Please recycle all obsolete materials.

For all concerns or questions, please contact

Lippert Components, Inc.

Ph: (574) 537-8900 | Web: lci1.com | Email: [email protected]

Rev: 09.29.2015 Page 6 Power Tongue Jack Install Manual

Indice

Altri manuali Lippert Components Jack

Lippert Components

Lippert Components JT's Strong Arm 191023 Istruzioni per l'installazione

Lippert Components

Lippert Components Smart Jack 643589 Istruzioni per l'installazione

Lippert Components

Lippert Components Power Stance Manuale utente

Lippert Components

Lippert Components Standalone Smart Jack Manuale

Lippert Components

Lippert Components 285318 Istruzioni per l'installazione

Lippert Components

Lippert Components Atwood RV Power Jack Manuale del proprietario

Lippert Components

Lippert Components Stabilizer Jack Manuale utente

Lippert Components

Lippert Components LCI Manuale utente

Lippert Components

Lippert Components Level-Up 5th Wheel Manuale utente

Manuali Jack popolari di altre marche

Omega Lift Equipment

Omega Lift Equipment 18122C Istruzioni per l’uso

Pittsburgh

Pittsburgh 58816 Istruzioni per il montaggio

Unimec

Unimec TP Manuale utente

Sonic

Sonic 4800703 Manuale utente

BGS technic

BGS technic 70039 Manuale utente

TradeQuip

TradeQuip 1128T Manuale utente

VEVOR

VEVOR TJD-12000SP-F Manuale utente

ULTIMATE SPEED

ULTIMATE SPEED URW 2 A1 HYDRAULIC TROLLEY JACK Manuale utente

Stels

Stels 51131 Manuale utente

Bushranger

Bushranger RJX01 Manuale utente

Clarke

Clarke CTJ2500QLG Manuale di installazione e funzionamento

Valex

Valex 1650520 Manuale utente

Pfaff

Pfaff Merkur M0 Manuale utente

Beta

Beta 3050/K Supplemento

Sealey

Sealey 1050CXHV Manuale utente

Jung

Jung JH Series Manuale utente

URIAH

URIAH UC200020 Manuale utente

Kennedy

Kennedy KSJ010 Manuale utente