Litelume Flood Light 135/200W Manuale utente
Flood Light 135/200W
Installation Instructions
LITELUME™ seeks to deliver the most advanced and efficient LED technology. Due to
technology progression, specifications may change. We reserve the right to update product
specifications without notice. Contact LITELUME™ for the most up-to-date data.
www.litelume.com
833.LED.LUME
Page 1/2
Rev Date: 05/3/2019
©Lite Lume Corporation 2018
Warning
PLEASE READ ALL INSTRUCTIONS BEFORE ATTEMPTING INSTALLATION
1. To prevent personal injury or product damage only licensed electricians should install.
2. To avoid electric shock or component damage disconnect power before attempting installation or servicing.
3. This product must be installed in accordance with the national electric code (NEC) and all applicable federal, state and local
electric codes and safety standards.
4. Disconnect product and allow cooling prior to servicing.
5. Any alteration or modification of this product is expressly forbidden as it may cause serious personal injury, death, property
damage and/or product malfunction.
6. To prevent product malfunction and/or electrical shock this product must be properly grounded.
7. This luminaire is designed to operate in ambient temperatures ranging from -40°c to 45°c.
8. LIMIT RANGE OF ADJUSTMENT TO.
9. This product must be installed in accordance with the applicable installation code by a Person familiar with the construction and
operation of the product and the hazards involved.
10. In 75°c supply conductors.
11. This product is not available for several special environments, such as places with corrosive gas liquids or high pressure water
vapor
Slipfitter Mount Installation
screw
center bolt
cover plate
screw
1. Connect the wires to L / N / GND
2. Remove the cover and adjust the bracket to the desired angle
3. Install the bracket on the pole and fix it with screws
Trunnion Mount Installation
screw
stents
1. Mount fixture to surface using the hole pattern provided on the trunnion bracket.
2. Loosen center bolts and set screw.
3. Rotate fixture to desired aiming position and tighten center bolts.
4. Tighten set screw.
5. Refer to wiring diagrams for power connection.
Flood Light 135/200W
Installation Instructions
LITELUME™ seeks to deliver the most advanced and efficient LED technology. Due to
technology progression, specifications may change. We reserve the right to update product
specifications without notice. Contact LITELUME™ for the most up-to-date data.
www.litelume.com
833.LED.LUME
Page 2/2
Rev Date: 05/3/2019
©Lite Lume Corporation 2018
Photocell Installation
Universal voltage driver permits operation at 120V to 277VAC, 60 Hz except fixtures factory ordered with a 120V photocell
(P1) or 277V photocell (P2) or 120-277V photocell(P0).
1. Install photocell and wire as per diagram.
2. Use photocell rated for your supply voltage.
BLACK
BLACKBLACK
INPUT
LAMPLOAD
RED
PHOTOCONTROL
WHITE
WHITEWHITE
Troubleshooting
1. Check that the line voltage at the fixture is correct. Refer to wiring diagram above.
2. Is the fixture grounded properly?
3. Be sure the photocell, if used, is functioning properly.
Indice
Altri manuali Litelume Proiettore
