LITESHEET BriteCor AC Direct BCO Manuale utente
BriteCor AC Direct
BCO/BWP Wallpack
Installation Manual
BCO/BWP BriteCor Wallpack Installation Manual
Page 2of 4
NOTES
•WARNING –Risk of fire or electric shock.
•WARNING - It is recommended that installation be
performed by a certified electrician.
•All electrical connections must be in compliance with
local codes, ordinances or the national electrical code
(NEC). Contact your municipal building department to
learn about your local codes, permits and/or
inspections.
•Do not connect this Luminaire to an electrical system
that does not provide means for equipment grounding.
Never use a fixture in a two-wire system that is not
grounded.
•If dimming functionality is included, use only with
Litesheet approved dimmers.
•This unit is not approved for use in ducted ceilings.
•Do not use excessive force when manipulating cables
and wires.
•WARNING –To prevent wiring damage or abrasion, do
not pinch wires between surfaces.
•WARNING –Only connect Luminaire to the voltage
indicated by the Luminaire label. It is intended for
direct connection to this voltage. DO NOT connect to a
different or unknown voltage.
•Enclosure is rated for Wet Location and IP65. When
installing incoming connections, all wire ports must be
sealed using similar rated hardware to maintain Wet
Location and IP65 rating.
Document #: 11-00035
Rev: B
Date: 4/19/2022
LiteSheet Solutions
Page 3of 4
CONTENTS OF KIT
•BCO/BWP or BCOG3/BWPG3 LED Luminaire
TOOLS AND ADDITIONAL PARTS REQUIRED
•Mounting screws
•Silicon sealant
•#2 Philips head screw driver
•Flat head screw driver
Preparation
1. Turn off power source.
Installation
1. Open luminaire by loosening the two screws
located on the side of the housing.
2. Knock out / drill holes in the rear housing for
mounting fixture to wall and for securement
to junction box (j-box not provided.)
3. Apply silicon sealant (not provided) to any
unused holes to prevent water entry.
4. Secure fixture to wall with two or more
screws (not provided).
5. Secure fixture to junction box with screws
(not provided).
BCO/BWP BriteCor Wallpack Installation Manual
Page 4of 4
Installation (Continued)
6. Connect the incoming ground connection to
the green ground wire provided. Connect the
incoming line power to the luminaire
disconnect provided.
•Black –Line Power (Hot)
•White –Neutral
•Green –Safety Ground
7. Close the luminaire lid and reinsert the
machine screws. Tighten the screws fully to
ensure a tight seal.
For warranty information and
technical support, contact us at:
434-446-1460
Find more great products at:
www.litesheet.com
Questo manuale è adatto per i seguenti modelli
1
Indice
Altri manuali LITESHEET Attrezzatura di illuminazione
LITESHEET
LITESHEET BriteCor AC BAA Manuale utente
LITESHEET
LITESHEET BriteCor AC Direct BBS Manuale utente
LITESHEET
LITESHEET BriteCor AC BCF Manuale utente
LITESHEET
LITESHEET BriteCor AC BHBC Manuale utente
LITESHEET
LITESHEET BriteCor AC Direct BFHB G3 Manuale utente
LITESHEET
LITESHEET BriteCor AC Direct BHLB Series Manuale utente
LITESHEET
LITESHEET BriteCor AC BDEK Manuale utente
LITESHEET
LITESHEET BriteCor AC BWB Manuale utente
LITESHEET
LITESHEET BriteCor AC BTS Series Manuale utente
LITESHEET
LITESHEET BLTL BriteCor Manuale utente
