Lithonia Lighting MRP Manuale utente

Installation Instructions

MRP LED

Lithonia Lighting Outdoor

One Lithonia Way, Conyers, GA 30012

Phone: 800-279-8041 Fax: 770-918-1209

www.lithonia.com

Part Number: RJ521312LED Rev A

Revision Date: 03-31-10

SAVE THESE INSTRUCTIONS

WARNING

To reduce the risk of death, injury or property damage from fire, electric shock, cuts,

abrasions, falling parts, and other hazards:

•Serviceoftheequipmentmustbeperformedbyqualifiedservicepersonnel.

•Installationandmaintenance must be performed byaperson familiar with the constructionand

operationofthis product and any hazards involved.Allapplicable codes and ordinances must

befollowed.

•Readthisdocument before installing, servicing, ormaintaining this equipment or installinga

lamp.These instructions do not coverall installation, service, and maintenancesituations. If

your situation is not covered, or if you do not understand these instructions or additional

informationisrequired, contactLithoniaLighting or your local Lithonia LIghting Distributor.

•Readandfollowallwarningsandinstructionsprovidedbythe lamp manufacturer.

WARNING

Before installing, servicing, or maintaining this equipment, follow these general precautions.

To reduce the risk of electrocution:

•Makesuretheequipment is properly grounded.

•Alwaysde-energizethe circuit and/or equipment before connecting to,disconnecting

from,orservicingtheequipment.

To reduce the risk of fire:

•Use supply conductors with a minimum installation temperature rating as specified on

equipment.

To reduce the risk of personal injury from cuts, abrasions, or falling parts:

•Wearglovestopreventcutsorabrasionsfromsharpedgeswhen removing from carton,

handlingandmaintainingthisequipment.

•Donot use abrasive materials, glasscleaners or other solventsonreflector or lens.

Thesesubstancesmay damage equipment and causepartstoeventually break and

fall.

•Do not install a damaged fixture.

Lithonia Lighting, a division of Acuity Brands Lighting, Inc., assumes no responsibility for claims arising out of

improper or careless installation or handling of this product.

IMPORTANT SAFETY INSTRUCTIONS

READ AND FOLLOW ALL SAFETY INSTRUCTIONS!

SAVE THESE INSTRUCTIONS AND DELIVER TO OWNER AFTER INSTALLATION

Installation Instructions

MRP LED

Lithonia Lighting Outdoor

One Lithonia Way, Conyers, GA 30012

Phone: 800-279-8041 Fax: 770-918-1209

www.lithonia.com

Part Number: RJ521312LED Rev A

Revision Date: 03-31-10

1. Make electrical connections to the fixture before installing it into the pole. Make certain that all power is disconnected prior to

installing the fixture.

2. Using a 5/32" hex wrench, remove the driver compartment cover 1/4 - 20 screw (provided). Keep for re-installation. See Figure 1.

3. Using a 3/8" nut driver remove the (2) power door retaining screws and detach the reflector and power supply using the quick-

disconnects. Keep the removed hardware for re-installation. See Figure 2.

4. With the power door removed, and the electrical connections made, slide the internal slipfitter and fixture into the pole. Using a 3/4"

socket with extension, tighten the internal slipfitter. Do not over tighten. Over tightening will cause stripping and void all warranties.

The fixture should be level on the pole and should not move or rotate.

5. Re-connect the reflector and power supply using the quick disconnects removed earlier in step 4. Using a 3/8" nut driver reinstall the

(2) power door retaining screws. Using a 5/32" hex wrench, re-install the driver compartment cover and tighten the (1) one driver

compartment 1/4 - 20 screw. Do not over tighten. Over tightening will cause stripping and void all warranties.

Figure 1 Figure 2

To access fixture for aiming the LED source:

1. Disconnect power.

2. Loosen the three optical door retaining screws.

3. Using a ¼” nut driver, remove the four optic ring retaining screws. See Figure 3.

4. Lift the optic ring, heat sink, and wiring harness as one assembly and rotate in

90 degree increments. The optic ring accommodates an additional 15 degree

slide adjustment to better direct light distribution based on application.

Note: The wiring harness is held in place by zip ties which can be removed if

required when rotating the assembly. All zip ties must be replaced and harness

secured to the optic ring prior to placing the fixture into service.

5. When aiming is complete, re-install the four optic retaining screws and tighten

them with a ¼” nut driver.

6. Close the optical top and re-tighten the three optical door retaining screws. Do

not over tighten. Over tightening will cause stripping and void all warranties.

TROUBLESHOOTING

If this fixture fails to operate properly, check to make sure:

•The fixture is wired correctly. • The fixture is grounded correctly. • The line voltage at the fixture is correct.

Figure 3

Tools Required: 5/32" hex wrench. 1/4" and 3/8" nut driver. 3/4" socket with extension.

Indice

Altri manuali Lithonia Lighting Luce esterna

Lithonia Lighting

Lithonia Lighting BGR ALO SWW2 MVOLT PER Manuale utente

Lithonia Lighting

Lithonia Lighting RSX1 LED P4 Manuale utente

Lithonia Lighting

Lithonia Lighting TWR2 Manuale utente

Lithonia Lighting

Lithonia Lighting TDD LED 2 Manuale utente

Lithonia Lighting

Lithonia Lighting Aeris ASF1 Manuale utente

Lithonia Lighting

Lithonia Lighting DLSD1 Manuale utente

Lithonia Lighting

Lithonia Lighting OLWX2 LED Manuale utente

Lithonia Lighting

Lithonia Lighting OVWP LED 40K 120 PE Manuale utente

Lithonia Lighting

Lithonia Lighting WPX Series Manuale utente

Lithonia Lighting

Lithonia Lighting Aeris ASBX Manuale utente

Lithonia Lighting

Lithonia Lighting BGR Manuale utente

Lithonia Lighting

Lithonia Lighting KAD Manuale utente

Lithonia Lighting

Lithonia Lighting OLWX1 Manuale utente

Lithonia Lighting

Lithonia Lighting CNY LED Manuale utente

Manuali Luce esterna popolari di altre marche

Sealey

Sealey LED37 Manuale utente

nordlux

nordlux VEJERS Guida utente

SImx

SImx ELITE LED LHTC637 Manuale utente

GEV

GEV CAROLINE 10833 Manuale utente

NEBO

NEBO NEB-LSP-0020 Manuale utente

WE-EF

WE-EF PFL540 LED Manuale utente

Lindby

Lindby 9949029 Manuale utente

HEPER

HEPER DOGO Side LW6048.585-US Istruzioni per l'installazione e il funzionamento

HEPER

HEPER LW8034.003-US Istruzioni per l'installazione e il funzionamento

Maretti

Maretti VIBE S 14.6080.04.A Manuale utente

BEGA

BEGA 84 253 Manuale

HEPER

HEPER MINIMO Istruzioni per l'installazione e il funzionamento

LIGMAN

LIGMAN BAMBOO 3 Manuale utente

Maretti

Maretti TUBE CUBE WALL 14.4998.04 Manuale utente

Maxim Lighting

Maxim Lighting Carriage House VX 40428WGOB Manuale utente

urban ambiance

urban ambiance UQL1273 Manuale utente

TotalPond

TotalPond 52238 Manuale utente

Donner & Blitzen

Donner & Blitzen 0-02661479-2 Manuale utente