Logenex
SCDM-SD Series Manual 1.0
select the desired Contrast value (0 to 255) and press the OK button to
set. Factory default is 128.
Saturation –Use the Scroll Up/Down button to select Saturation. Press
the OK button to enter the Saturation menu. Use the Scroll Up/Down
button to select the desired Saturation value (0 to 255) and press the OK
button to set. Factory default is 128.
Sharpness –Use the Scroll Up/Down button to select Sharpness. Press
the OK button to enter the Sharpness menu. Use the Scroll Up/Down
button to select the desired Sharpness value (0 to 255) and press the OK
button to set. Factory default is 64.
Hue –Use the Scroll Up/Down button to select Hue. Press the OK button
to enter the Hue menu. Use the Scroll Up/Down button to select the
desired Hue value (0 to 255) and press the OK button to set. Factory
default is 128.
Device Address –Use the Scroll Up/Down button to select Device
Address. Press the OK button to enter the Device Address menu. Use the
Scroll Up/Down to select the Desired Address ranging from 1 to 32 then
press the OK button to set.
Reserve –Factory set and not adjustable.
Stream ID –Use the Scroll Up/Down button to select Stream ID. Press
the OK button to enter the Stream ID menu. Use the Scroll Up/Down
button to select the desired Stream ID ranging from 0 to 65535 then press
the OK button to set. Factory default is 1000.
Network ID –Use the Scroll Up/Down button to select Network ID. Press
the OK button to enter the Network ID menu. Use the Scroll Up/Down
button to select the desired Network ID ranging from 0 to 65535 then
press the OK button to set. Factory default is 100.
ORG Network ID –Use the Scroll Up/Down button to select ORG
Network ID. Press the OK button to enter the ORG Network ID menu.
Use the Scroll Up/Down button to select the desired ID ranging from 0 to
65535 then press the OK button to set. Factory default is 10.
Network Name –Use the Scroll Up/Down button to select Network
Name. Press the OK button to enter the Network Name menu. Use the
Scroll Up/Down button to select the first character for the desired Network
Name then press the OK button to set. Repeat the process for each
character in the desired Network Name. A Network Name can consist up
to 16 characters.
Default Configuration –If you wish to set the modulator back to the
factory default settings use the Scroll Up/Down button to reach Default
Configuration then press the OK button. Caution: Once the OK button is
pressed the unit will automatically reset to the factory default.
LCN Mode –Use the Scroll Up/Down button to select LCN Mode. Press
the OK button to enter the LCN Mode menu. Use the Scroll Up/Down
button to select the desired LCN Mode: APN, EACEM, ITC, NorDig. The
factory default is APN. Press the OK button to set.
