Logic Instrument Fieldbook E1 Manuale utente
Rugged Android Tablet
FIELDBOOK E1
User’s Guide
Introduction
1. Please read these safety instructions carefully.
2. Please keep this User’s Manual for later reference.
3. Please disconnect this equipment from connecter before cleaning.
Don’t use liquid or prayed detergent for cleaning. User moisture sheet
or cloth for cleaning.
4. Make sure the equipments are connected to the power source with the
correct voltage, frequency, and ampere.
5. All cautions and warnings on the equipment should be noted.
FIELDBOOK E1 User Guide
2
6. Never pour any liquid into opening: this could cause fire or electrical
shock.
7. Never open the equipment. For safety reason, the equipment should
only be opened by qualified service personnel.
8. If one of the following situations arises, get the equipment checked by
a service personnel:
a. Liquid has penetrated into the equipment.
b. The equipment has been exposed to moisture.
c. The equipment has not worked well or you cannot get it work
according to user manual.
d. The equipment has dropped and damaged. If the equipment has
obvious sign of breakage.
9. Caution on use of battery: User the battery recommended by the
manufacturer or the same type of battery installed by the
manufacturer. If incorrect battery is used, it may cause explosion or
fire hazard. Recycle or discard used batteries according the
manufacturer’s instruction or your local authority.
10. The computers use nonvolatile memory that requires a battery to
retain system information when power is removed. The 3V lithium
battery is on the system board. The battery life depends on the
amount of time the computer is powered on. If the computer does not
display the correct time and date, replace the battery.
FIELDBOOK E1 User Guide
3
IMPORTANT：Loss of BIOS settings occurs when the battery is removed.
BIOS settings must be reconfigured whenever the battery is replaced.
WARNING：A risk of fire and chemical burn exists if the battery is not
handled properly. Do not disassemble, crush, puncture, or short external
contacts, or expose the battery to temperatures higher than 60 °C (140
°F). Do not dispose of a used battery in water or fire.
CAUTION：Danger of explosion if battery is incorrectly replaced. Replace
only with same or equivalent type recommended by the manufacturer.
Discard used batteries according to the manufacturer’s instructions.
FIELDBOOK E1 User Guide
4
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-Consult the dealer or an experienced radio/ TV technician for help.
CAUTION:
Any changes or modifications not expressly approved by the grantee of
this device could void the user's authority to operate the equipment.
Labeling requirements
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FIELDBOOK E1 User Guide
5
RF exposure warning
This equipment must be installed and operated in accordance with
provided instructions and must not be co-located or operating in
conjunction with any other antenna or transmitter. End-users and
installers must be providing with antenna installation instructions and
transmitter operating conditions for satisfying RF exposure compliance.
SAR Value: 0.763 W/kg
This device is operation in 5.15 – 5.25GHz frequency range, then
restricted in indoor use only, Outdoor operations in the 5150~5250MHz is
prohibit.
This device is slave equipment, the device is not radar detection and not
ad-hoc operation in the DFS band.
FIELDBOOK E1 User Guide
6
Canada, Industry Canada (IC) Notices
This Class B digital apparatus complies with Canadian ICES-003 and
RSS-210.
Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Radio Frequency (RF) Exposure Information
The radiated output power of the Wireless Device is below the Industry
Canada (IC) radio frequency exposure limits.
The Wireless Device should be used in such a manner such that the
potential for human contact during normal operation is minimized.
This device has been evaluated for and shown compliant with the IC
Specific Absorption Rate (“SAR”) limits when installed in specific host
products operated in portable exposure conditions.
Canada, avis d'Industry Canada (IC)
Cet appareil numérique de classe B est conforme aux normes
canadiennes ICES-003 et RSS-210.
Son fonctionnement est soumis aux deux conditions suivantes : (1) cet
appareil ne doit pas causer d'interférence et (2) cet appareil doit accepter
toute interférence, notamment les interférences qui peuvent affecter son
fonctionnement.
FIELDBOOK E1 User Guide
7
Informations concernant l'exposition aux fréquences radio (RF)
La puissance de sortie émise par l’appareil de sans fil est inférieure à la
limite d'exposition aux fréquences radio d'Industry Canada (IC). Utilisez
l’appareil de sans fil de façon à minimiser les contacts humains lors du
fonctionnement normal.
Ce périphérique a été évalué et démontré conforme aux limites SAR
(Specific Absorption Rate – Taux d'absorption spécifique) d'IC lorsqu'il
est installé dans des produits hôtes particuliers qui fonctionnent dans des
conditions d'exposition à des appareils portables.
E
Eu
ur
ro
op
pe
e
–
–
E
EU
U
D
De
ec
cl
la
ar
ra
at
ti
io
on
n
o
of
f
C
Co
on
nf
fo
or
rm
mi
it
ty
y
This device complies with the essential requirements of the R&TTE
Directive 1999/5/EC and EMC directive 2004/108/EC. The following test
methods have been applied in order to prove presumption of conformity
with the essential requirements of the R&TTE Directive 1999/5/EC and
EMC directive 2004/108/EC:
EN 55022: 2006 +A1: 2007
EN 61000-3-2 : 2006
EN 61000-3-3 : 1995 + A1 : 2001 + A2 : 2005
EN 55024: 1998 +A1: 2001 +A2: 2003
(IEC 61000-4-2: 2008;
IEC 61000-4-3: 2006 +A1:2007;
FIELDBOOK E1 User Guide
8
IEC 61000-4-4: 2004;
IEC 61000-4-5: 2005;
IEC 61000-4-6: 2003 +A1: 2004 +A2: 2006;
IEC 61000-4-8: 1993 +A1: 2000;
IEC 61000-4-11: 2004)
IEC/EN 60950-1: 2001
Safety of information technology equipment
EN 300 328 V1.7.1: 2006
EN 301 489-17 V2.1.1: 2009 and EN 301 489-1 V1.8.1: 2008
EN 62311: 2008
This device is a 2.4GHz wideband transmission system (transceiver),
intended for use in all EU member states and EFTA countries under the
following conditions and/or with the following restrictions:
In Italy the end-user should apply for a license at the national
spectrum authorities in order to obtain authorization to use the
device for setting up outdoor radio links and/or for supplying public
access to telecommunications and/or network services.
This device may not be used for setting up outdoor radio links in
France and in some areas the RF output power may be limited to 10
mW EIRP in the frequency range of 2454 – 2483.5 MHz. For detailed
information the end-user should contact the national spectrum
authority in France.
FIELDBOOK E1 User Guide
9
C
Ch
ha
ap
pt
te
er
r
1
1
General
Information
1
1.
.1
1.
.
I
In
nt
tr
ro
od
du
uc
ct
ti
io
on
n
FIELDBOOK E1 rugged tablet PC is TI® OMAP Platform (OMAP4460)
processor core architecture based rugged Tablet with a bright 10.1 inch
LED backlight LCD display. FIELDBOOK E1 is a high-performance tablet
that runs on Google ® Android ® operating system.
All FIELDBOOK E1 tablets have been engineered and tested to meet
Military Standards for Environmental Extremes (MIL STD 810G). Your
tablet includes the following features that make it exceptionally rugged
and durable:
Android 4.0 ICS supported
Highest rugged standard on the market: IP65, MIL-STD-810G; 6 feet
drop resistance
Fully communication: Wi-Fi 802.11 a/b/g/n, Bluetooth V4.0, GPS,
NFC (RFID).
Dual camera: 1.2MP FF front camera for HD video conference; 5MP
AF rear camera w/ LED flash
Programmable physical buttons: users can define the hot key by
FIELDBOOK E1 User Guide
10
themselves FieldControl AP.
1
1.
.2
2.
.
S
Sp
pe
ec
ci
if
fi
ic
ca
at
ti
io
on
n
The FIELDBOOK E1 rugged tablet PC is a flexible, multi-functional flat
tablet. With following specifications that can be applied in diverse
operational environments and implemented in multi-faceted applications.
1.2.1. Main System
Platform:
Google ® Android 4.0.4 ICS
CPU:
TI® OMAP Platform (OMAP4460 dual-core 1.5GHz)
System Memory:
1GB LPDDRII Memory
Storage:
1 x 32G Flash eMMC
LCD Panel:
10.1 inch LED Backlight Screen
10.1” WXGA (1366x768) 400nits LCD + T/P(sunlight readable
technology)
Touch Panel
2-pointed Capacitive Touch Screen
Audio:
-1 x High Quality Speaker (1W)
Altri manuali per Fieldbook E1
1
Indice
Altri manuali Logic Instrument Tavoletta
Logic Instrument
Logic Instrument Fieldbook E1 Manuale utente
Logic Instrument
Logic Instrument Fieldbook K101 Manuale utente
Logic Instrument
Logic Instrument Fieldbook K122 Manuale utente
Logic Instrument
Logic Instrument Fieldbook I1 Manuale utente
Logic Instrument
Logic Instrument Fieldbook K80 Manuale utente
Logic Instrument
Logic Instrument Fieldbook I1 Manuale utente
