Tuning in (Note: You may need to press the AV button on your TV remote
control until you can see your receiver’s menus on your TV screen.)
Because this is the first time that the receiver has been used there are
no channels stored in the receiver’s memory.
If the menu below automatically appears, go straight to step 5...)
If the menu above does not appear on your TV screen...
1. Press the MENU button and the ‘Main Menu’ will appear.
2.Press button to highlight ‘Installation’ and press SELECT.
3.
Press button to highlight ‘First Time Installation’ and press SELECT.
4.You will be asked if you want to delete all channels and settings. Press the
/ buttons to highlight ‘Yes’ and press SELECT. You may have to wait
5.Press the / buttons on the remote contol to select the type of TV you
have connected to your Digital Receiver Choose between either 4:3
(standard) or 16:9 (widescreen) and then press SELECT to confirm.
6. The next menu will ask if you want to start the automatic search. Press
the / buttons to highlight ‘Yes’ and press SELECT.
7.Your Digital Receiver will now automatically search for all available
channels. Please be patient, this process will take a few minutes. When
completed, the first channel of the channel list is displayed and you can
now watch digital terrestrial television using the P+/P- buttons on your
remote control.
Reception Issues
If less than 10 channels are found, picture freezes, blanking out or blocking
occurs, please re-check all connections and repeat the automatic tuning
procedure.
Persistant problems with setting up your receiver could be caused by
incorrect signal levels. Your aerial system may need re-alignment or to be
upgraded. Contact your retailer for details. Alternatively you can call the
Digital Helpline on: 0844 800 3090 (open Mon-Fri 8.30-8, Sat 9-6, Sun
9-5.30, all calls charged at National Rate).
•
•
•
•
up to 15 seconds before the above display is shown.
