logitrans EHS 1000RF-SEMI Manuale utente
EHS 1000RF-SEMI
D66-4
EU DECLARATION OF CONFORMANCE
Manufacturer: Logitrans A/S
Hillerupvej 35
6760 Ribe
Denmark
It is hereby declared that:
Machine: Product group: Stackers
EHS 1000RF-SEMI
Type: EHSS 1000RF-SEMI
Year of
manufacture/
Serial No.:
a) Has been manufactured in conformance with the stipulations of the:
• Directive no. 2006/42/EC
• Directive no. 2004/108/EC
• Directive no. 2006/95/EC
b) Has been manufactured in conformance with the stipulations of the standard:
• EN 3691-5
Name: Gitte K. Berg
Position: CEO
Company: Logitrans A/S
Product type declaration of:
Signature: 10.10.2016
Distributor:
3
The Logitrans Stacker is manufactured in accordance with safety directives.
Among the subjects dealt with in this Instruction Manual are:
Therefore please read this Instruction Manual carefully!
1.0 Before the first lift...
• Proper application
• Physical limitations of the product
• Risks with improper use
4
EHS RF-SEMI
For proper operation,
stand behind the handle!
Push/pull - raise/lower
2.0 Functions and identifications
2.1 Handling of pallets
5
3.1 Avoid overloads
The maximum load must not be exceeded.
Remember, the stacker is designed for evenly distributed load, - goods on pallets
etc. If the forks are pointloaded on one side there is a risk of bending.
3.2 Avoid offset loads
The load must be evenly distributed. The maximum centre of gravity distance from
the front of the fork mast (given on the truck) must not be exceeded. A greater
distance will reduce the level of safety and increase the risk of toppling.
Goods on pallets, etc. must be properly secured so that they cannot fall off during
transport, when the truck is lifted, or when the truck must remain lifted for a time.
3.3 Marking
The mast lifting capacity and the corresponding centre of
gravity distance are given by the pictogram on the side of
the mast.
The lifting capacity of the mast is the same as the
max. lifting capacity of the product.
Max. lifting capacity is set on the safety valve in
the product.
3.0 Optimum safety
6
!
If it becomes necessary to use the load as a brake to prevent the stacker running
loose, activate the DOWN button quickly until the load reaches the ground.
3.4 Transport with load
The stacker is designed for use on even and level oor. During transport the
forks shall be raised as little as possible. Transport with raised forks should be
made over the shortest possible distances and at low speed.
3.5 Emergency braking
3.0 Optimum safety
7
3.0 Optimum safety
Safety regulations
• Never walk under a raised load!
• Before lowering the forks, make certain that no foreign
elements can hinder the free lowering of the forks.
• The stacker is designed for use on an even and level oor.
• During transport the forks shall be raised as little as possible.
• Transport with raised forks should be made over the shortest
possible distances and at low speed.
• Check that the chains lift equally. They shall be equally tight when the forks
are loaded.
• Chains and chain bolts must not be damaged.
Chains that have become permanently stretched (max. 2% of original length)
must be scrapped.
ATTENTION
Moving parts
8
1
2
4
BA2
3
C
A1
D
4.1 Fuses
A: Fuses: motor protector and protection against electrical overload.
B: Safety/pressure relief valve: protection against mechanical and hydraulic
overload. Set by the manufacturer at the maximum design load (see product
name plate).
C: Hose safety valve: protection against load “falling” in the event of hose
fracture.
D: Emergency stop: disconnects the main current.
4.0 There must be a current supply...
9
4.2 Fuses - replacement
There are two fuses in the electrical circuit.
- See illustration under point 4.1
80 amp fuse in main supply from battery
(location: see A1, point 4.1)
5 amp fuse in control current circuit
(location: see A2, point 4.1)
Replacement:
Before replacing fuse, disconnect battery + pole. The old fuse can then be removed
and replaced by a new one of the same size.
Do not insert a larger fuse; the fuse acts as a protector for the pump motor.
Find out why fuses blow!
4.3 Wiring connections
Much operational disturbance is caused by poor connections in the electrical
circuit. Make sure connections are in order.
Check connections regularly for damage at insulating caps or looseness at plugs, etc.
Verdigris must be removed from lead plugs. Keep all screw/nut connections tight.
4.0 There must be a current supply...
10
Regular inspection and the replacement of worn or defective parts in good time
will prolong the life of the stacker. “Prevention is better than repair”, therefore
ensure:
• Correct usage
• Regular cleaning
• Periodic safety and service inspection
5.1 Lubrication and hydraulic oil
All ball bearings are lubricated with a lubricating grease for the food
industry, and all moving parts are treated with a grease for the food
industry.
The hydraulic system is lled with hydraulic oil of viscosity class
ISO VG 15. An additive is added to the oil. The concentrate reduces
friction and wear and protects against corrosion.- Pre-mixed hydraulic oil with the
additive can be bought at the dealers. The oil is suited for use in the temperature
range -10ºC to +50ºC. A thinner oil is recommended for temperatures below -10ºC
(please contact a dealer).
The hydraulic oil must be changed every second year.
5.2 Oil change
Draining the oil:
1. Bring the forks down to the lowest position.
2. Most of the oil can be drained by loosening the hydraulic hose union and briey
activating the hydraulic pump with the switch.
3. Remaining oil can be drained from the oil tank by taking off the twelve clips on
the pump and removing the tank.
Oil lling:
4. Fill oil through the lling hole (point 4.1 pos. 4) on the tank.
5. Oil quantity:
EHS 1000/1200 approx. 3 litre
EHS 1000/1400 approx. 3 litre
EHS 1000/1600 approx. 3 litre
6. Ret the lling cap and bleed the system (point 5.6).
5.0 Long live the stacker
Indice
Altri manuali logitrans Carrello elevatore
logitrans
logitrans PANTHER MAXI AC Manuale utente
logitrans
logitrans HS 1000RF-SEMI Manuale utente
logitrans
logitrans LOGIFLEX ELFR Manuale utente
logitrans
logitrans Twin Stacker Manuale utente
logitrans
logitrans Logiflex Manuale del proprietario
logitrans
logitrans ELF 1001/1200 Manuale utente
logitrans
logitrans SGL/Panther Manuale utente
logitrans
logitrans LOGIFLEX SELF 1001 Manuale utente
logitrans
logitrans ROTATOR ELFR Manuale utente
logitrans
logitrans WSP 2200 Manuale utente
logitrans
logitrans LOGIFLEX SELF MAXI Manuale utente
logitrans
logitrans Logiflex ELF1201 Manuale utente
logitrans
logitrans LOGIFLEX SELFR Series Manuale utente
logitrans
logitrans LOGIFLEX ELF Manuale utente
logitrans
logitrans LOGIFLEX ELF Manuale del proprietario
logitrans
logitrans EHS Stainless 1000/1400 Manuale utente
logitrans
logitrans ROTATOR SELFR Manuale utente
logitrans
logitrans EHL 1004 Guida
logitrans
logitrans Level Control LC4 Manuale utente
logitrans
logitrans LOGIFLEX SELF1003 Manuale utente
