TOTA-LED USER MANUAL 7
INSTRUCTOONS
MOUNTING THE
LIGHT POWERING THE
TOTA-LED
The TOTA-LED can be powered directly from
an AC outlet or by a V-mount battery
(not included).
Using the TOTA-LED with AC power
Important! The TOTA-LED is a multivoltage
fixture capable of running on 100–240 V, 50/60
Hz. The included cable has a 120 V, 50 Hz
(North American) plug. To use this fixture with
other voltages, you must use a plug adapter
(sold separately).
1. Connect the AC power adapter to the
dimmer control box with the 3-pin XLR
power cable, and plug the power cable into
an outlet.
The two-way 5/8-inch receiver allows the yoke
to be mounted vertically or horizontally.
Mount the yoke horizontally to use the TOTA-
LED as a flood light. (Figure A)
Mount the yoke vertically to add an umbrella
to your setup. (Figure B)
1. Make sure the tilt locking knob is fully
tightened.
2. Loosen the locking knob, and place the
5/8-inch receiver on a light stand.
3. Tighten the locking knob until secure.
4. Loosen the tilt locking knob to adjust the
angle of the light, and tighten.
1
A B
