The root milling cutter is used to remove tree stumps and their rootsystem up to 235 mm below
the earth's surface. By moving the cutting edges sideways with swivel movements over the top and
front of the stump, the tree stump is gradually milled away.
The machine may only be operated by one person.
The root milling machine is not suitable for milling modry and rotten stumps. The milling of tree
stumps with stones, metal or glass objects and the like. is prohibited.
Make sure that there is a minimum distance of 15 m between other
persons/animals/children and the machine. Objects can be thrown away and
injure people or animals.
Any use that does not meet the above specifications shall be deemed not to be in accordance with
its intended purpose. Use for other purposes can be dangerous or cause damage to the device.
L.V.G. Hartham GmbH will accordingly relieve itself against the consequences of any claims
resulting from non-compliance with these provisions.
Attention!
Persons unfamiliar with the operating instructions, children, adolescents and persons under
the influence of alcohol, drugs and medication are not allowed to operate the device.
The root milling machine BFS-15 is a hand-held machine and is powered by a powerful 4-stroke
OHV gasoline engine.
The motor drives the milling wheel via V-belts.
The milling wheel is covered by the protective hood. Slight pressure on the handlebar controls the
milling wheels depth and direction.
The handle bar is equipped with a height-adjustable handle.
The left bike is braked, the right bike is free-running, i.e. not braked.
A wide chassis and wheels with air tyres allow for convenient transport.
A hand-start device serves as the starting device for the gasoline engine. The engine speed is
controlled by the throttle lever on the handlebar.
The ignition circuit is closed by the motor switch (turned off) or opened by actuating the
EMERGENCY STOP handle, and thus the gasoline engine is stopped.
