Luxor MW1449 Manuale utente
THESE INSTRUCTIONS CONTAIN IMPORTANT INFORMATION
WHICH WILL HELP YOU GET THE BEST FROM YOUR APPLIANCE
IT WILL ENSURE SAFE AND CORRECT INSTALLATION,
USE AND MAINTENANCE.
IF YOU NEED HELP OR HAVE DAMAGED OR MISSING PARTS,
CALL LUXOR SUPPORT ON 0333 3052260
INSTALLATION AND OPERATING INSTRUCTIONS
MODEL: MW1449
FULLY ELECTRONIC AUTOMATIC
WASHING MACHINE
0333 3052260
CONTENTS
SAFETY INFORMATION 2 - 4
CORRECT USAGE 2
GENERAL WARNING 3
SAFETY WARNINGS 4
INSTALLATION 5-8
REMOVING TRANSIT BOLTS 5
ADJUSTING THE FEET 6
INSTALLATION (ELECTRICAL CONNECTION) 7
INSTALLATION (WATER INLET HOSE CONNECTION) 7
INSTALLATION (WATER DISCHARGE CONNECTION) 8
TECHNICAL SPECIFICATIONS 9
DESCRIPTION OF APPLIANCE 10
CONTROL PANEL 11 - 12
WASHING YOUR LAUNDRY 13 - 16
PRELIMINARY PREPARATION OF LAUNDRY 13
PUTTING LAUNDRY IN THE MACHINE 14
ADDING DETERGENT TO THE MACHINE 14
AUXILIARY FUNCTIONS 15
CHILD LOCK 16
CANCELLING A PROGRAM 16
FINISHING A PROGRAM 16
MAINTENANCE AND CLEANING 17 - 19
WATER INLET FILTERS 17
PUMP FILTERS 18
DETERGENT DRAWER 19
FLUSH STOPPER 19
BODY 19
DRUM 19
TROUBLESHOOTING 20 - 22
AUTOMATIC FAULT WARNINGS 23
WASHING PROGRAM 24 - 26
GUARANTEE 27
1
THIS QUALITY APPLIANCE HAS BEEN TESTED AND CERTIFIED TO MEET ALL APPLICABLE
UK ELECTRICAL AND SAFETY STANDARDS.
THIS APPLIANCE MUST BE INSTALLED AND CONNECTED IN ACCORDANCE WITH
CURRENT REGULATIONS BY A QUALIFIED ELECTRICIAN.
AFTER UNPACKING THE APPLIANCE ENSURE THAT THERE IS NO VISIBLE DAMAGE. IF THE
APPLIANCE HAS BEEN DAMAGED DURING TRANSIT, DO NOT USE IT,
CONTACT YOUR RETAILER IMMEDIATELY.
- Your machine is designed to be used domestically.
Commercial use will cause your warranty to be invalid.
- Keep pets away from your machine.
- Please check the packaging of your machine is in good order before installation, and the outer surface
of the machine after the package is opened. Do not operate damaged machines.
- Have your machine installed only by a qualied person. Any interference to your machine by anyone
other than a qualied person will invalidate your warranty.
- The appliance in not intended for use by people (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance.
- Use your machine only for laundry that has been specied as suitable for washing by the
manufacturer.
Before operating the washing machine, remove the 4 transit
bolts and rubber spacers from the back of the machine. If the bolts
are not removed, it will cause heavy vibration, noise and product
malfunction (invalidating the guarantee)
- Your machine is not covered under warranty for faults caused by any kind of external
factors (pesticides, re, etc.).
- Please do not throw away this user manual: keep it for future reference as it contains full operating
instructions as well as the serial number of your machine. You will need this should you wish to book a
service call.
Note: Specications may vary depending on the product purchased.
0333 3052260
CORRECT USAGE
2
0333 3052260
GENERAL WARNINGS
- The ambient temperature for your machine’s ideal operation is 15-25ºC.
- Frozen hoses can tear and explode. In regions where temperature is below zero, ambient
temperature might endanger the safe operation of the electronic circuit board.
- Please ensure that the clothes put into your machine do not contain any foreign objects
(nails, needles, coins, lighters, matches, clips, etc.) in pockets. These objects can
damage your machine.
It is recommended that the rst washing operation is carried out on a
90º Cotton program but without laundry and using ½ the dose of
detergent in the 2nd compartment of the detergent drawer.
- If a detergent or softener is exposed to air for any time, residue may be caused, be sure
only to put your detergent or softener in the detergent drawer at the beginning of every wash.
- It is advised that you unplug your machine and close the water inlet tap if you do not intend
to use the machine for a prolonged period of time. Also, leaving the door of your appliance
open will prevent the formation of bad odours due to humidity.
- Some water might be left in your machine after factory trials and tests conducted due to
Quality Control procedures. This is normal and will not damage your machine.
- Remember the packaging materials of your machine may be dangerous for children. Keep
the packaging materials in a place where children cannot reach them and dispose of them
appropriately.
- Keep any small parts away from the reach of children and babies.
- Use Pre-wash programs only for very dirty laundry.
- Never open the detergent compartment when the appliance is running.
- In case of any breakdown, unplug the appliance rst and then turn the
water inlet off. Do not attempt repair by yourself, always contact the
authorised service agent help line.
- The amount of laundry you put in your washing machine should not
exceed the maximum amount indicated.
- Never force the door to open when the machine is running.
- Do not wash clothes covered in our or other powders in your machine as
it will cause damage.
- Please adhere to detergent/fabric conditioner manufacturer’s advice
regarding the use of fabric conditioner or similar products.
- Set up your machine in a place where its door can be completely opened.
- Set up your machine in a position where it can be fully ventilated and
has constant air circulation.
3
0333 3052260
SAFETY WARNINGS
You must take note of these warnings, as this can protect you and your family.
DANGER OF BURNS
- Do not touch the discharge hose or water during the discharge process
as the appliance can reach high temperatures during operation.
RISK DUE TO ELECTRICAL CURRENT
- Do not use multi-sockets on an extension lead.
- Do not plug in damaged plugs.
- Never pull the cable when unplugging - always grip the plug itself.
- Do not plug-in or remove the plug with wet hands.
- Never touch the machine with wet hands or feet.
If the mains cable becomes damaged it must be replaced
by an qualied electrician or service agent
DANGER OF FIRE
- Do not keep ammable liquids near your machine.
- The sulphur content of paint removers might cause corrosion. For this
reason, never use paint-removing materials in your machine.
- Never use products that contain solvent material in your machine.
- Remove all objects from the pockets of your laundry (needles,
paperclips, lighters, matches, etc.) before placing it in your machine.
FALL AND INJURY HAZARD
- Do not climb on your machine. The top lid of your machine may
break and you might get injured.
- Tidy the hose, cable and packaging of your machine during
installation, to avoid tripping or falling over.
- Do not turn your machine upside down or on its side.
- Do not lift your machine by holding it from extruding parts
(detergent drawer, door). These parts might break and cause you to get injured.
- There’s the risk of tripping and injury if the materials like hoses
and cables are not properly stored after your machine is installed.
Machine must be carried by 2 people
CHILD SAFETY
- Do not leave children unattended near the machine. Children
might lock themselves inside.
- Door glass and surface may get hot while your machine operates.
And as a result of this, touching the machine might damage the
skin, especially that of children.
- Keep packaging material away from children.
- Danger may occur if detergent or cleaning materials are
consumed, and eyes or the skin might be irritated if contact is
made. Keep the cleaning materials away from the reach of children.
4
0333 3052260
INSTALLATION
Removing transit bolts
Before operating the washing machine,
remove the 4 transit bolts and rubber
spacers from the back of the machine.
If the bolts are not removed, it will
cause heavy vibration, noise and
product malfunction, (invalidating the
guarantee).
For this reason, the transit bolts should be
loosened by being rotated counterclockwise
using an appropriate wrench.
The transit bolts are removed by
pulling out.
Fit the plastic transit bolt caps (in the
accessories bag) into the holes left by the
removal of the transit bolts.
The transit bolts should be stored to be
used in case of future transportation.
REMEMBER - You must remove the
transit bolts of your machine
before rst use. Faults occurring
to the machine if operated with
transit bolts tted will be out of
scope of warranty.
5
0333 3052260
INSTALLATION
Adjusting the feet
Do not install your machine on a carpet or
anything that will prevent ventilation under
the base.
To ensure silent and vibration-free operating
of your machine, it should be sited on a
non-slippy rm oor.
You can adjust the level of your machine
by the adjustable feet.
Loosen the plastic adjustment nut.
Adjust the feet upwards or downward by
rotating them.
After maintaining the level, compress the
plastic adjustment nut upwards again.
REMEMBER - The appliance must
be level
Never put cardboard, wood or
other materials under your machine
if you are trying to level any
distortion in the oor.
When cleaning the oor, on which
your machine stands, be careful not
to disturb the balance of the
machine.
6
0333 3052260
INSTALLATION
Installation (Electrical Connection)
Your washing machine is set to 220-240V and 50Hz.
The mains cord of your washing machine is equipped with a
specic earthed plug. This plug should always be inserted to an
earthed socket of 13 amps. The rating of the fuse should be 13 amps.
NOTE: Operating your machine below the recommended
voltage will cause the life cycle of your appliance to be
reduced and its performance to be restricted.
Installation (Water Inlet Hose Connection)
Your machine may have either a single inlet (cold) or
double water inlets (cold/hot) based on its specications.
A white-capped hose should be connected to the cold
water inlet and a red-capped hose to a hot water inlet
(applicable for machines with double water inlets).
To eliminate water leakages in the connection points, 1
or 2 nuts are provided in the hose package (applicable for
machines with double water inlets). Fit these nuts to the
ends of new water inlet hoses on the tap end of the hose.
Connect the new water inlet hoses to a 3/4 “, threaded
inlet pipe.
Connect the white-elbow end of the water inlet hoses
to the white ltered water inlet valve on the rear side of
the machine and the red-elbow end to the red-ltered
one (applicable for machines with double water inlets).
Tighten plastic parts of the junctions using your hand. If
you are unsure of this process get the work done by a
qualied plumber.
Flow of water with pressure of 0.1-1 Mpa will allow
your machine to operate more efciently. (0,1 Mpa
pressure means that more than 8 litres of water will ow
per minute).
Ensure that the new water inlet hoses are not bent, broken, crushed or the wrong
size.
If your machine has a hot water connection, the temperature of the water inlet
should be maximum 70 Degrees Centigrade.
NOTE: Use only the new water inlet hose supplied with your machine while
making water inlet hose connections. Never use old, used or damaged water
inlet hoses.
7
0333 3052260
INSTALLATION
Installation (Water Discharge Connection)
The end of the water discharge hose can be
tted to a specic outlet pipe.
Never attempt to extend the water discharge
hose by joining two pieces of hose.
Do not put the discharge hose of your machine
into a bucket or sink.
Make sure that the water discharge hose does
not bend, buckle, become squashed or stretched.
Please note:
The water drain hose should be mounted at a
height of minimum 60cm, and maximum of
100cm from the ground.
8
0333 3052260
TECHNICAL SPECIFICATION
Important Note:
This appliance is marked according to the European directive
2002/96/EC on Waste Electrical and Electronic Equipment (WEEE).
By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and
human health, which could otherwise be caused by inappropriate
waste handling of this product.
The symbol on the product, or on the documents accompanying the
product, the Crossed Out Wheelie Bin, indicates that this appliance
may not be treated as household waste. Instead it shall be handed
over to the applicable collection point for the recycling of electrical
and electronic equipment.
Disposal must be carried out in accordance with local environmental
regulations for waste disposal. For more detailed information
about treatment, recovery and recycling of this product, please
contact your local authority, your household waste disposal service
or the retailer where you purchased the product.
9
Indice
