Lycoming IO-360-N1A Manuale utente
© 2016 Avco Corporation. All Rights Reserved.
Engine Installation and Operation Manual
IO-360-N1A Engine
February 2016
Part No. IOM-IO-360-N1A
IO-360-N1A Engine
Installation and Operation Manual
Lycoming Part Number: IOM-IO-360-N1A
Contact Us:
Mailing Address:
Lycoming Engines
652 Oliver Street
Williamsport, PA 17701 USA
Phone:
Factory
U.S. and Canada Toll Free:
Direct:
+1 (800) 258-3279
+1 (570) 323-6181
Lycoming’s regular business hours are Monday through Friday from 8:00AM through 5:00PM
Eastern Time (-5 GMT).
Visit us Online: www.Lycoming.com
IO-360-N1A Engine Installation and Operation Manual
© 2016 Avco Corporation. All Rights Reserved Record of Revisions
February 2016 Page i
RECORD OF REVISIONS
Revision
Revision
Date
Revised
By
Revision Description
Original
Original Release of Installation and Operation Manual - Part No.
IOM-IO-360-N1A
IO-360-N1A Engine Installation and Operation Manual
Record of Revisions © 2016 Avco Corporation. All Rights Reserved
Page ii February 2016
This page intentionally left blank.
IO-360-N1A Engine Installation and Operation Manual
© 2016 Avco Corporation. All Rights Reserved Service Document List
February 2016 Page iii
SERVICE DOCUMENT LIST
NOTICE: The following is a list of service documents referenced in or incorporated into the
information in this manual. Always refer to the latest revision of any service document
for changes or additional information.
Number
Incorporation
Date
Subject
S.B. 369
02/16
Engine Inspection after Overspeed
S.B. 480
02/16
I. Oil and Filter Change and Screen Cleaning
II. Oil Filter Screen Content Inspection
S.B. 533
02/16
Recommended Action for Sudden Engine Stoppage,
Propeller/Rotor Strike or Loss of Propeller/Rotor
Blade or Tip
S.I. 1009
02/16
Recommended Time Between Overhaul Periods
S.I. 1014
02/16
Lubricating Oil Recommendations
S.I. 1070
02/16
Specified Fuels
S.I. 1098
02/16
Propeller Flange Bushing Location
S.I. 1132
02/16
Magneto Drop-off
S.I. 1154
02/16
FAA Approved Starter and Alternators
S.I. 1241
02/16
Pre-oil the Engine Prior to Initial Start
S.I. 1409
02/16
Lycoming Engines P/N LW-16702, Oil Additive
S.I. 1427
02/16
Lycoming Reciprocating Engine Run-In and Oil
Consumption
S.I. 1443
02/16
Approved Slick Magnetos on Lycoming Engines
S.I. 1472
02/16
Removal of Preservative Oil from Engine
S.I. 1481
02/16
Factory Engine Preservation
S.I. 1505
02/16
Cold Weather Starting
S.I. 1528
02/16
Aircraft Engine Starter Recommendations
S.I. 1530
02/16
Engine Inspection in a Particulate Laden
Environment (Volcanic Ash, Sand, Dust, Airborne
Debris)
L 114
02/16
Reciprocating Engine and Accessory Maintenance
Publications
L180
02/16
Engine Preservation for Active and Stored Aircraft
IO-360-N1A Engine Installation and Operation Manual
Service Document List © 2016 Avco Corporation. All Rights Reserved
Page iv February 2016
This page intentionally left blank.
IO-360-N1A Engine Installation and Operation Manual
© 2016 Avco Corporation. All Rights Reserved Table of Contents
February 2016 Page v
TABLE OF CONTENTS
Section Page
Frontal__________________________________________________________________________
Record of Revisions.............................................................................................................................. i
Service Document List.......................................................................................................................iii
Table of Contents................................................................................................................................ v
List of Figures..................................................................................................................................... ix
List of Tables ...................................................................................................................................... xi
Abbreviations and Acronyms .........................................................................................................xiii
Introduction....................................................................................................................................... xv
System Description________________________________________________________________
—System Description ................................................................................................................... 1
—Cylinders................................................................................................................................... 1
—Crankcase.................................................................................................................................. 2
—Ignition System ......................................................................................................................... 2
—Starter........................................................................................................................................ 3
—Fuel Injection System................................................................................................................ 4
—Lubrication System ................................................................................................................... 4
—Cylinder Number Designations................................................................................................. 5
Engine Reception and Lift__________________________________________________________
—Uncrate Procedure for a New, Rebuilt, or Overhauled Engine................................................. 7
—Acceptance Check..................................................................................................................... 7
—Engine Preservative Oil Removal............................................................................................. 8
—Lift the Engine .......................................................................................................................... 8
Requirements for Engine Installation ________________________________________________
—Overview................................................................................................................................... 9
—Step 1. Prepare the Engine........................................................................................................ 9
—Step 2. Supply Interface Items................................................................................................ 14
—Step 3. Remove Components.................................................................................................. 15
—Step 4. Install Aircraft-Supplied Engine Mounts.................................................................... 15
—Step 5. Prepare the Aircraft Engine Harness........................................................................... 15
—Step 6. Make Electrical Interface Connections....................................................................... 15
IO-360-N1A Engine Installation and Operation Manual
Table of Contents © 2016 Avco Corporation. All Rights Reserved
Page vi February 2016
Section Page
Engine Installation________________________________________________________________
—Engine Installation Overview.................................................................................................. 17
—Step 1. Install the Engine on Mounts...................................................................................... 18
—Step 2. Connect the Wiring Harness....................................................................................... 18
—Step 3. Connect the Linkages.................................................................................................. 18
—Step 4. Install External Accessories (as necessary) ................................................................ 18
—Step 5. Install Baffling............................................................................................................ 18
—Step 6. Install the Compressor Belt (as necessary)................................................................. 18
—Step 7. Install the Propeller..................................................................................................... 18
—Step 8. Connect Fuel Lines..................................................................................................... 19
—Step 9. Connect Oil Lines....................................................................................................... 19
—Step 10. Install Components That Had Been Removed Before Engine Installation............... 20
—Step 11. Add Oil...................................................................................................................... 20
—Step 12. Add Fuel.................................................................................................................... 21
—Step 13. Engine Pre-Oil Procedure......................................................................................... 21
Engine Start and Operation ________________________________________________________
—Warranty Requirement............................................................................................................ 23
—Before Engine Start................................................................................................................. 23
—Engine Run-In / Engine Break-In ........................................................................................... 23
—Step 1. Prepare an Engine for First Time Operation............................................................... 24
—Pre-Flight Inspection for First Time Operation Checklist .................................................. 25
—Step 2. Start the Engine........................................................................................................... 26
—Magnetic Drop-Off Check .................................................................................................. 28
—Step 3. Complete the Engine Run-Up..................................................................................... 28
—Step 4. Operate the Engine...................................................................................................... 29
—Operation in Flight.............................................................................................................. 29
—Fuel Mixture Leaning.......................................................................................................... 29
—Step 5. Stop the Engine........................................................................................................... 30
IO-360-N1A Engine Installation and Operation Manual
© 2016 Avco Corporation. All Rights Reserved Table of Contents
February 2016 Page vii
Section Page
Engine Conditions ________________________________________________________________
—Action for Engine Conditions................................................................................................. 31
—Apply Heat to a Cold Engine.............................................................................................. 32
—Cold Weather Start.............................................................................................................. 33
—Engine Operation in Hot Weather....................................................................................... 34
—Volcanic Ash....................................................................................................................... 34
—Overspeed............................................................................................................................ 35
—Low Oil Pressure During Flight.......................................................................................... 35
Flight Test_______________________________________________________________________
—Flight Test ............................................................................................................................... 37
Engine Preservation and Storage ____________________________________________________
—Engine Corrosion and Prevention........................................................................................... 39
—Engine Preservation - 30 to 60 Days....................................................................................... 40
—Fuel Injector Preservation....................................................................................................... 42
—Engine Preservation - 61 to 180 Days..................................................................................... 42
—Engine Preservation - 181 Days or More................................................................................ 43
—Cold Weather Storage............................................................................................................. 43
—Long-Term Storage of Engines that Use Automotive Fuel .................................................... 43
Appendix________________________________________________________________________
—Appendix A - Engine Specifications and Operating Limits ................................................... 45
—Appendix B - Installation and Wiring Diagrams.................................................................... 49
—Appendix C - Performance Data............................................................................................. 51
IO-360-N1A Engine Installation and Operation Manual
Table of Contents © 2016 Avco Corporation. All Rights Reserved
Page viii February 2016
This page intentionally left blank.
Indice
Altri manuali Lycoming Motore
Lycoming
Lycoming O-290 Manuale utente
Lycoming
Lycoming TEO-540-A1A Manuale utente
Lycoming
Lycoming IO-320-A1A Manuale utente
Lycoming
Lycoming TEO-540 Series Manuale utente
Lycoming
Lycoming TEO-540-C1A Manuale utente
Lycoming
Lycoming YO-233-B2A Manuale utente
Lycoming
Lycoming O-360 Series Manuale utente
Lycoming
Lycoming IO-390-D Series Manuale utente
Lycoming
Lycoming VO-540 Series Manuale utente
Lycoming
Lycoming O-320 76 Series Manuale utente
