Maestro GSM100 Manuale utente
DS100-1 May ’07 www.rfsolutions.co.uk ©2007 REG No 277 4001, ENGLAND.
GSM & GPRS Modem
•GSM and GPRS
•Voice / Fax / SMS and Data
•Quad Band 850 / 900 / 1800 1900 MHz
•Accepts Standard SIM Card
•Miniature size 88 x 60 x 26mm
•Can Be Used On Standard GSM Network
•RS232 Interface
•One user programmable input/Output Port
•GSM100T: TCP/IP stack available for data and
internet
•AT command set:
GSM 07.05 and 07.07 and WAVECOM
•GPRS Class B Class 10:
36Kbps download / 24Kbps upload
Compact "PlugAnd Play" Quad band GSM modems can be directly connected to the serial port of a desktop or
notebook computer through the RS232 interface. A standard SIM card can be inserted in the integral card-holder
within the metal enclosure.
The modems’ metal casing makes it an appropriate solution for tough industrial applications such as Telemetry,
Wireless Local Loop (payphones) or as part of a fleet management system. The small size makes it simple to
integrate in a space constraint environment. The modem is supplied with power cable. Other accessories available
are an antenna (with 1m coax cable), RS232 connecting cable with Telephone interface, DIN Rail mounting adaptor
and power supply unit.
About GPRS: GPRS stands for General Packet Radio Services. The user can remain "ON" all the time and the
data communication speed rivals that of a cable modem.
Ordering Information
Part No Description
GSM100 GSM Quad Band Modem, GPRS Class 10
GSM100T As GSM100 with Additional TCP/IP Stack
GSM20-ANT Antenna with flying lead and connector
GSM20-CAB232 RS232 Cable Interface to PC
GSM20-DINRL DIN Rail Mount Bracket
GSM20-PSU Power Supply (12Vdc to 110-240Vac)
1
DS100-1 May ’07 www.rfsolutions.co.uk ©2007 REG No 277 4001, ENGLAND. Page 1
GSM & GPRS Modem
CONTENTS
SAFETYPRECUTIONS 2
CHAPTER 1 INTRODUCTION 3
CHAPTER 2 INSTALLATION 7
CHAPTER 3 WORKING WITH MAESTRO 100 9
CHAPTER 4 SPECIFICATION 12
CHAPTER5APPENDIX 13
CHAPTER 6 TROUBLESHOOTING 14
2
DS100-1 May ’07 www.rfsolutions.co.uk ©2007 REG No 277 4001, ENGLAND. Page 2
GSM & GPRS Modem
SAFETY PRECUTIONS
zThe modem generates radio frequency (RF) power. When using the modem care must be taken on
safety issues related to RF interference as well as regulations of RF equipment.
zDo not use your phone in aircraft, hospitals, petrol stations or in places where using GSM products is
prohibited.
zBe sure that the modem will not be interfering with nearby equipment. For example: pacemakers or
medical equipment. The antenna of the modem should be away from computers, office equipment,
home appliance, etc.
zAn external antenna must be connected to the modem for proper operation. Only uses approved
antenna with the modem. Please contact authorized dealer on finding an approved antenna.
zAlways keep the antenna with minimum safety distance of 26.6 cm or more from human body. Do not
put the antenna inside metallic box, containers, etc.
Using the modem in vehicle
zCheck for any regulation or law authorizing the use of GSM in vehicle in your country before installing
the modem
zInstall the modem by qualified personnel. Consult your vehicle dealer for any possible interference of
electronic parts by the modem.
zThe modem should be connected to the vehicle’s supply system by using a fuse-protected terminal in
the vehicle’s fuse box
zBe careful when the modem is powered by the vehicle’s main battery. The battery may be drained after
extended period.
Protecting your modem
zTo ensure error-free usage, please install and operate your modem with care. Do remember the
following:
zDo not expose the modem to extreme conditions such as high humidity/rain, high temperatures, direct
sunlight, caustic/harsh chemicals, dust, or water.
zDo not try to disassemble or modify the modem. There is no user serviceable part inside and the
warranty would be void.
zDo not drop, hit or shake the modem. Do not use the modem under extreme vibrating condition.
zDo not pull the antenna or power supply cable. Attach/ detach by holding the connector.
zConnect the modem only according to the instruction manual. Failure to do it will void the warranty.
zIn case of problem, please contact authorized dealer.
GENERAL
3
DS100-1 May ’07 www.rfsolutions.co.uk ©2007 REG No 277 4001, ENGLAND. Page 3
GSM & GPRS Modem
CHAPTER 1
INTRODUCTION
Maestro 100 is a ready-to-use GSM modem for voice, data, fax and SMS services. It also supports GPRS
Class 10 for hi-speed data transfer. Maestro 100 can be easily controlled by using AT command for all
kinds of operations. With standard 9-pin RS232 port and telephone-like audio plug (via optional cable) the
Maestro 100 can be set up with minimal effort.
1.1. Package
The Maestro 100 package should include the following:
1. Maestro 100 or 100T x 1
2. Power cord with fuse x 1
3. Safety note x 1
1.2. Interfaces
1.2.1. Status indicator
The LED will indicate different status of the modem:
- off Modem switched off
- on Modem is connecting to the network
- flashing slowly Modem is in idle mode
- flashing rapidly Modem is in transmission/communication (GSM only)
1.2.2. SMA female antenna connector
-Connect this to an external antenna with SMA male connector. Make sure the antenna is for the
correct GSM frequency with impedance of 50ohm, and also connector is secured tightly.
SIM holder eject button Status indicator
SIM holder 4-PIN connector (Power, Input / Output)
15 pin Sub-D Female Connector
(RS232/Audio)
SMA female antenna connector
4
DS100-1 May ’07 www.rfsolutions.co.uk ©2007 REG No 277 4001, ENGLAND. Page 4
GSM & GPRS Modem
1.2.3. 15-PIN D-SUB Female connector (RS232 / Audio)
- The connector provides serial link and audio link to the modem.
Pin number Name EIA designation Type Note
1 DCD Data Carrier Detect Output
2 TX Transmit Data Input
3 BOOT Input Not used
4 MICROPHONE (+) Input
5 MICROPHONE (-) Input
With 2V DC bias
output
6 RX Receive Data Output
7 DSR Data Set Ready Output
8 DTR Data Terminal Ready Input
9 GND Ground Ground
10 SPEAKER(+) Output
11 CTS Clear to Send Output
12 RTS Request to Send Input
13 RI Ring Indicator Output
14 RESET Input Pull low to reset
15 SPEAKER(-) Output
Specification of microphone and speaker to be connected :
Parameters Min Typical Max Remark
Microphone current @2V / 2K Ohm 0.5 mA
Microphone input level 100 mVpp
Speaker output current 150 Ohm/ 1nF 16mA
Speaker impedance 32ohm 50ohm
Please refer to the document “Application notes - Power supply & Audio” for more information of audio
connection.
1.2.4. 4-PIN connector (Power, Input / Output)
Pin assignment of 4-pin connector
Pin number Name Functions
1 I/O Input / Output port
2 ~INTR Interrupt function triggered by pulling this pin to
ground or LOW level; reserved for additional
functions with new firmware
3 POWER - DC power negative input
4 POWER+ DC power positive input
5
DS100-1 May ’07 www.rfsolutions.co.uk ©2007 REG No 277 4001, ENGLAND. Page 5
GSM & GPRS Modem
A cable, included in the package shall be used for power supply connection:
I/O Parameters Min Typical Max Remark
I/O In LOW voltage 0.5V
I/O In HIGH voltage 3V 5V
I/O out max. sink current 5mA Internal 1k resistor in series
INTR Parameters Min Typical Max Remark
Input LOW voltage 0 0.5V Triggered by pulling this pin to
LOW level ; otherwise leave it
open
•Please refers to Chapter 6 Appendix for using I/O and INTR signals. Contact your dealer if you need
wire for the I/O and INTR connection
1.2.5 Optional accessories
You may contact your sales agent for the following optional accessories:
External antenna
- Magnetic mount type
- Frequency GSM 900/1800 band
- Gain 3db
- VSWR < 1.5:1
- Height ~ 236 mm (including magnetic base)
- Cable : Type RG-174U length 2.5m
Fuse holder
Fuse rating :
Connector Micro-Fit 3.0 Stripped wire
5-32V DC
Su
pp
l
y
6
DS100-1 May ’07 www.rfsolutions.co.uk ©2007 REG No 277 4001, ENGLAND. Page 6
GSM & GPRS Modem
4p4c plug
Pin Assignment
Sub-D 15
(male) Sub-D 9
(female) Plug
4P4C
1 1
2 3
3
4 1
5 4
6 2
7 6
8 4
9 5
10 2
11 8
12 7
13 9
14
15 3
Sub-D 9 pin
‘Y’ cable
- Direct connection with standard
9-pin RS-232 port (DTE)
- Direct connection with common
handset of telephone for voice call
- Shielded cable
- Cable length 1.1m (w/ connector)
DIN rail mount
-Quick attachment / detachment to
standard DIN rail
7
DS100-1 May ’07 www.rfsolutions.co.uk ©2007 REG No 277 4001, ENGLAND. Page 7
GSM & GPRS Modem
CHAPTER 2
INSTALLATION
2.1 Mounting the modem
Use 2 pcs of M3 screw to mount the modem
When using optional DIN rail mount please refer to document “Installation of DIN rail mount”
Bottom view
2.2 Installing the SIM card
Use a ball pen or paper clip to press the SIM holder eject button. The SIM holder will come out a little.
Then take out the SIM holder.
Note : DO NOT pull out the SIM holder without pushing the eject button.
Put the SIM card to the tray, make sure it has completely sit on the tray. Put the tray back into the slot.
2.3 Connecting the external antenna (SMA type)
Connect this to an external antenna with SMA male connector. Make sure the antenna is for the GSM
frequency with impedance of 50ohm, and also connector is secured tightly.
Note : Please use antenna designed for GSM device operation. Incorrect antenna will affect
communication and even damage the modem.
Screw mounting slot
SMA male connector of
secure tightly
8
DS100-1 May ’07 www.rfsolutions.co.uk ©2007 REG No 277 4001, ENGLAND. Page 8
GSM & GPRS Modem
2.4 Connect the modem to external device
You can use the optional ‘Y’ cable to connect the modem’s Sub-D connector to external
controller/computer. Note : The modem CANNOT be connected to the ‘Line’ jack of a landline telephone
directly.
Connection example using optional ‘Y’ cable:
2.5Connecting the DC power supply
Connect the open ending of the included power cord to a DC supply. Refer to the following for power
supply requirement.
Input voltage range 5V – 32V
Rated current 650 mA
Connect the connector to the modem. The modem will turn on automatically.
The status indicator on the modem will be lit when power on. After a few seconds it will go flashing slowly
(registered to the network successfully, refer section 1.2.1).
Chapter 3 describes how to communicate with the modem in Microsoft WindowsTM environment.
RS
-
232 port of PC
Handset of phone
DB-9
4p4c
Sub-D 15 pin
Maestro
100
AC-DC Adaptor
or battery
Solder wire
9
DS100-1 May ’07 www.rfsolutions.co.uk ©2007 REG No 277 4001, ENGLAND. Page 9
GSM & GPRS Modem
CHAPTER 3
WORKING WITH MAESTRO 100
3.1. Checking the modem (using Microsoft Windows XP HyperTerminal as
example)
3.1.1. On the first time power-up you can use a terminal software to communicate with the modem
through an RS-232 serial port. Following example is using the HyperTerminal in Windows XP .
3.1.2. On Windows XP, start the HyperTerminal program.Assign a name for a new session.
Indice
Altri manuali Maestro Modem
Maestro
Maestro M1002G Manuale utente
Maestro
Maestro M100 2G Manuale utente
Maestro
Maestro M100 2G Manuale utente
Maestro
Maestro 100 3G Manuale utente
Maestro
Maestro M110 Series Manuale utente
Maestro
Maestro HERITAGE 3G SERIES Manuale utente
Maestro
Maestro Executive 96M Manuale del prodotto
Maestro
Maestro 100 Manuale utente
Maestro
Maestro 100 Manuale utente
Maestro
Maestro E206XT Manuale utente
