3
IV.Aiming your remote towards the IR Receiver , press 5 buttons you want to use for controlling the lift.
Every properly received button will be confirmed by short pauses . Number of pauses correspond to the
button set :
-
( 1 pause)
-
(2 pauses)
( 3 pauses)
( 4 pauses)
5- RC SET (Memory button)
(
5 pauses)
After assigning all the 5 buttons , the beeper will go silent , but the red LED button wil stay on . You can always
leave the Setup mode by pressing&holding setup , until the RED led is off .
It is possible to reset all the favorite positions . t . To reset the lift press&hold setup button for
about 5 seconds. Control box will confirm re-setting by showing you this symbol on the digital display :
.
Please note , that it will not reset none of the remote setup ( RF or IR ) . To change the remote settings , you need
to go through the IR of RF remote assingment again.
After resetting the lift , it will move substantially slower ( both lift and autolid) , until it will reach the marginal
positions , to calibrate itself. If you reset the settings , please drive the lift to its lowest positon , move it up and
rotate at least 45° left and 45° right
: Please note that , due to many external reasons the accuracy of rotation might be within
the tolerance of 2°-3°for left/right movement and 1° -2° for central “0” setting. Thus it is recommended taking
this into consideration when designing the furniture
SETUP AND Motion MEMORY MODE
To enter SETUP mode , press&hold setup button for about 2 seconds – you will notice the RED Setup LED lit.
Note: Do not hold the SETUP button longer , as you might evoke another function , which will be described later
in this manual.
The setup mode allows you to move the lift freely – to its maximum capacities both left , right , up and down.
Setting favorite positions is possible only in
( top viewing position ) - follow these steps : Remember this has to be done in SETUP mode.
I.Move the lift to your preferred TOP position
II. Press RC SET ( this can be either the button on your IR Remote - 5-RC SET , or use the control box RC-SET
button ) . You will hear intermittent beeper signal , which means the control box is awaiting input
