1. HEAT
RIGHT, Press the “HEAT” key, the control lamp “HEAT” lights up.
The preset power stage “5” is selected and the device turns on.
(Power stages: 1, 2, 3, 4, 5, 6, 7, 8, 9, 10)
With the “+”/ “-” keys, you can change the sengs at any me in
a range from 1-10.
LEFT, Press the “HEAT” key, the control lamp “HEAT” lights up.
The preset power stage “4” is selected and the device turns on.
(Power stages: 1, 2, 3, 4, 5, 6, 7,)
With the “+”/ “-” keys, you can change the sengs at any me in
a range from 1-7.
2. TEMP
Press the “TEMP” key, the control lamp “TEMP” lights up. The preset
temperature stage “120°C” is selected and the device turns on.
(Temperature stages: 60, 80, 100, 120, 140, 160, 180, 200, 220 and
240°C)
With the “+” / “-” keys, you can change the sengs at any me in
a range from 60 to 240°C.
3. LOCK
In the working state or in the standby mode, press and hold the child
lock buon for three seconds, the buzzer sound, the two digital tube
simultaneously ash LOC (machine) into the child lock state, Repress
the child lock 3 seconds to unlock the unit, or cut o the power and
plug in again to unlock the child locking.
4. Timer-function:
Aer select of the operang mode (HEAT stage or TEMP stage), press
the “TIMER” key. The control lamp “TIMER” lights up and the cipher
“0” appears on the LED display. By pressing the “+” / “-” keys you will
be able to select the operang me in increasing 5 minutes (up to
180 minutes maximum), reducing 1 minute.
The me will be counted down in minute steps, where upon the
display returns to the prior status (HEAT, TEMP).
Utensils suitable for this appliance
Compable Pans:
Steel or cast iron, enamelled iron, stainless steel, at-boom pans/
pots with a base diameter of 15 to 24 cm.
Non-compable Pans:
Heat-resistant glass, ceramic container, copper, aluminium pans/pots.
Rounded-boom pans/pots with a base of less than 15 cm.
Maintenance
• Clean aer each use. Disconnect plug and wait
unl the unit has cooled down. If the pots/
pans are used without being cleaned, as this
may result in discoloraon or stains. Do not
use fuel, paint thinner, scrubbing brush or
polishing powder to clean the inducon stove.
• Wipe down the unit using a dish washing agent
and a damp cloth. Use vacuum cleaner to suck
up dirt from the air intake and exhaust vent.
• Never run water over the unit (if water
gets inside it may cause malfuncon).
Once the me is up, an acousc signal sounds and the unit
automacally goes into standby mode. If you want to cancel the
TIMER funcon, simply press the ON/STANDBY key to switch o and
repeat to restart.
GB-6 GB-7
